Modelling the influence of atmospheric conditions on the outdoor real performance of a CPV (Concentrated Photovoltaic) module

In order to make CPV (Concentrated Photovoltaic) technology a real alternative to conventional generation of electricity, it is necessary to gain knowledge about its real outdoor operation by using a wide experimental basis. This basis makes it possible to analyze the electrical performance of these systems, and to obtain models to predict it. In this work, a prediction model is proposed. It calculates the maximum power delivered by CPV modules under previously known specific atmospheric conditions. To create this model, an experimental campaign was carried out in Jaen, Spain, from May 2012 to April 2013. In this campaign there were periodical measurements of the electrical parameters delivered by a CPV module, as well as the environmental variables that influence its performance – direct normal irradiance and its spectral distribution through the SMR (Spectral Matching Ratio) index, ambient temperature and wind speed. The proposed model was validated with one of the most frequently used commercial CPV modules in the market, but it can be used to predict the electrical performance of any other CPV module with similar constructive characteristics. An error within the range [3.98–5.27], in percentual terms, was obtained in the validation process performed to test the accuracy of the model.

[1]  Xiaoting Wang,et al.  Analysis and Prediction of Energy Production in Concentrating Photovoltaic (CPV) Installations , 2012 .

[2]  Wilhelm Warta,et al.  Solar cell efficiency tables (version 42) , 2013 .

[3]  Alessandro Valli,et al.  From a 32 m2 system with 90 CPV modules to a 105 m2 system with 12 CPV modules - Soitec's new CPV system CX-S530 , 2012 .

[4]  Zhifeng Wang,et al.  An improved temperature estimation method for solar cells operating at high concentrations , 2013 .

[5]  K. Araki,et al.  A simple rating method for CPV modules and systems , 2008, 2008 33rd IEEE Photovoltaic Specialists Conference.

[6]  Eduardo F. Fernández,et al.  Outdoor measurement of high concentration photovoltaic receivers operating with partial shading on the primary optics , 2013 .

[7]  Eduardo F. Fernández,et al.  Quantifying the effect of air temperature in CPV modules under outdoor conditions , 2012 .

[8]  César Domínguez,et al.  Indoor Characterization of CPV Modules Using the Helios 3198 Solar Simulator , 2009 .

[9]  T. Fuyuki,et al.  Annual output estimation of concentrator photovoltaic systems using high-efficiency InGaP/InGaAs/Ge triple-junction solar cells based on experimental solar cell's characteristics and field-test meteorological data , 2006 .

[10]  Álvaro Gutiérrez,et al.  Instituto de Sistemas Fotovoltaicos de Concentración concentration photovoltaics hybrid system first year of operation and improvements , 2013 .

[11]  Jen Fin Lin,et al.  High-efficiency concentrated optical module , 2012 .

[12]  S. Kurtz,et al.  Performance of CPV system using three types of III-V multi-junction solar cells , 2012 .

[13]  F. Rubio,et al.  Comparison of the different CPV rating procedures: Real measurements in ISFOC , 2009, 2009 34th IEEE Photovoltaic Specialists Conference (PVSC).

[14]  S. Campbell,et al.  Sputtering of metal oxide tunnel junctions for tandem solar cells , 2013, 2013 IEEE 39th Photovoltaic Specialists Conference (PVSC).

[15]  S. Askins,et al.  Current‐matching estimation for multijunction cells within a CPV module by means of component cells , 2013 .

[16]  Antonio J. Rivera,et al.  Characterization of Concentrating Photovoltaic modules by cooperative competitive Radial Basis Function Networks , 2013, Expert Syst. Appl..

[17]  G. Peharz,et al.  A simple method for quantifying spectral impacts on multi-junction solar cells , 2009 .

[18]  K. Araki,et al.  Validation of energy prediction method for a concentrator photovoltaic module in Toyohashi Japan , 2013 .

[19]  Karsten Heuser,et al.  Performance results from micro‐cell based high concentration photovoltaic research development and demonstration systems , 2013 .

[20]  S. Standard.  GUIDE TO THE EXPRESSION OF UNCERTAINTY IN MEASUREMENT , 2006 .

[21]  Matthew Muller,et al.  Minimizing Variation In Outdoor CPV Power Ratings , 2011 .

[22]  Gabriel Sala,et al.  Spectral Solar Radiation Measurements and Models for CPV Module Production Estimation , 2010 .

[23]  Eduardo F. Fernández,et al.  A two subcell equivalent solar cell model for III–V triple junction solar cells under spectrum and temperature variations , 2013 .

[24]  John Beavis Lasich,et al.  Analysis and Simulation of Performance of CPV Systems with Multi‐Junction Solar Cells , 2010 .

[25]  G. Almonacid,et al.  High Concentrator PhotoVoltaics efficiencies: Present status and forecast , 2011 .

[26]  P. Hebert,et al.  Concentrator multijunction solar cell characteristics under variable intensity and temperature , 2008 .

[27]  J. Gordon,et al.  Basic aspects of the temperature coefficients of concentrator solar cell performance parameters , 2013 .

[28]  Marta Victoria,et al.  Probing the effects of non-uniform light beams and chromatic aberration on the performance of concentrators using multijunction cells , 2012 .

[29]  Eduardo F. Fernández,et al.  Temperature coefficients of monolithic III-V triple-junction solar cells under different spectra and irradiance levels , 2012 .

[30]  Eduardo F. Fernández,et al.  Estimating the maximum power of a High Concentrator Photovoltaic (HCPV) module using an Artificial Neural Network , 2013 .

[31]  K. Cen,et al.  An improved method of Lambertian CCD-camera radiation flux measurement based on SMARTS (simple model of the atmospheric radiative transfer of sunshine) to reduce spectral errors , 2014 .

[32]  Wilhelm Warta,et al.  Spectral mismatch correction and spectrometric characterization of monolithic III–V multi‐junction solar cells , 2002 .

[33]  G. Peharz,et al.  Investigations on the temperature dependence of CPV modules equipped with triple‐junction solar cells , 2011 .

[34]  Steve Askins,et al.  Power rating of CPV systems based on spectrally corrected DNI , 2012 .

[35]  K. Araki,et al.  Development of concentrator modules with dome‐shaped Fresnel lenses and triple‐junction concentrator cells , 2005 .

[36]  Gerald Siefer,et al.  A method for using CPV modules as temperature sensors and its application to rating procedures , 2011 .

[37]  Aggelos Zacharopoulos,et al.  Chapter 15. Building Integration of High Concentration Photovoltaic Systems , 2015 .

[38]  Kenneth W. Stone,et al.  Energy prediction of Amonix CPV solar power plants , 2011 .

[39]  K. Edmondson,et al.  Spectral response and energy output of concentrator multijunction solar cells , 2009 .

[40]  Marco Stefancich,et al.  Rondine® PV concentrators: Field results and developments , 2009, PVSC 2009.

[41]  Andreas Gombert,et al.  CPV plants data analysis. ISFOC and NACIR projects results , 2012 .