Response Behavior of Poly(vinyl chloride)‐ and Polyurethane‐Based Ca2+‐Selective Membrane Electrodes with Polypyrrole‐ and Poly(3‐octylthiophene)‐Mediated Internal Solid Contact

The potentiometric response behavior of Ca2+-selective poly(vinyl chloride) (PVC) and polyurethane (PU) membranes with different inner contacts has been compared. Evidence for the formation of a water film between membrane and internal contact and, hence, a less than optimal lower detection limit have been found for membranes directly in contact with bare Au or with polypyrrole generated by electropolymerization in the presence of KCl. A significantly better behavior is shown by membranes with polypyrrole prepared in the presence of potassium hexacyanoferrate. Best performances have been obtained with solvent-cast poly(3-octylthiophene) as the internal contacting layer. As compared with the PVC membranes, those with PU had a significantly worse performance throughout.

[1]  A. Michalska,et al.  The influence of spontaneous charging/discharging of conducting polymer ion-to-electron transducer on potentiometric responses of all-solid-state calcium-selective electrodes , 2005 .

[2]  A. Michalska.  Improvement of Analytical Characteristic of Calcium Selective Electrode with Conducting Polymer Contact. The Role of Conducting Polymer Spontaneous Charge Transfer Processes and Their Galvanostatic Compensation , 2005 .

[3]  Ernö Pretsch,et al.  Potentiometric sensors for trace-level analysis. , 2005, Trends in analytical chemistry : TRAC.

[4]  Andrzej Lewenstam,et al.  Factors affecting the potentiometric response of all-solid-state solvent polymeric membrane calcium-selective electrode for low-level measurements. , 2004, Analytical chemistry.

[5]  Ernö Pretsch,et al.  Solid-contact polymeric membrane electrodes with detection limits in the subnanomolar range , 2004 .

[6]  Ernö Pretsch,et al.  A polypyrrole-based solid-contact Pb2+-selective PVC-membrane electrode with a nanomolar detection limit , 2004, Analytical and bioanalytical chemistry.

[7]  Ari Ivaska,et al.  Stability of the inner polyaniline solid contact layer in all-solid-state K+-selective electrodes based on plasticized poly(vinyl chloride). , 2004, Analytical chemistry.

[8]  R. E. Gyurcsányi,et al.  Microfabricated ISEs: critical comparison of inherently conducting polymer and hydrogel based inner contacts. , 2004, Talanta.

[9]  Johan Bobacka,et al.  Solution-cast films of poly(3,4-ethylenedioxythiophene) as ion-to-electron transducers in all-solid-state ion-selective electrodes , 2004 .

[10]  A. Ivaska,et al.  Small-volume radial flow cell for all-solid-state ion-selective electrodes. , 2004, Talanta.

[11]  A. Michalska,et al.  Lowering the Detection Limit of Ion-Selective Plastic Membrane Electrodes with Conducting Polymer Solid Contact and Conducting Polymer Potentiometric Sensors , 2003 .

[12]  E. Pretsch,et al.  Influence of Incorporated Lipophilic Particles on Ion Fluxes Through Polymeric Ion-Selective Membranes , 2003 .

[13]  E. Hall,et al.  Potentiometric Responses of Poly(pyrrole) Films Surface Modified by Nafion , 2002 .

[14]  Ernö Pretsch,et al.  Rational design of potentiometric trace level ion sensors. A Ag+-selective electrode with a 100 ppt detection limit. , 2002, Analytical chemistry.

[15]  W. E. Morf,et al.  Effects of controlled current on the response behavior of polymeric membrane ion-selective electrodes , 2002 .

[16]  Hakhyun Nam,et al.  All-solid-state carbonate-selective electrode based on a molecular tweezer-type neutral carrier with solvent-soluble conducting polymer solid contact. , 2002, Talanta.

[17]  Ernö Pretsch,et al.  Redox-Active Self-Assembled Monolayers for Solid-Contact Polymeric Membrane Ion-Selective Electrodes , 2002 .

[18]  A. Ivaska,et al.  Influence of oxygen and carbon dioxide on the electrochemical stability of poly(3,4-ethylenedioxythiophene) used as ion-to-electron transducer in all-solid-state ion-selective electrodes , 2002 .

[19]  A. Michalska,et al.  All-solid-state planar miniature ion-selective chloride electrode , 2002 .

[20]  H. Hill,et al.  Evaluating the separation of amphetamines by electrospray ionization ion mobility spectrometry/MS and charge competition within the ESI process. , 2002, Analytical chemistry.

[21]  R. E. Gyurcsányi,et al.  Picomolar detection limits with current-polarized Pb2+ ion-selective membranes. , 2001, Analytical chemistry.

[22]  Ari Ivaska,et al.  Calcium-selective electrode based on polyaniline functionalized with bis(4-(1,1,3,3-tetramethylbutyl)phenyl)phosphate , 2001 .

[23]  K. Maksymiuk,et al.  Studies on Spontaneous Charging/Discharging Processes of Polypyrrole in Aqueous Electrolyte Solutions , 2001 .

[24]  Richard P. Buck,et al.  Peer Reviewed: Tracing the History of Selective Ion Sensors , 2001 .

[25]  N. D. de Rooij,et al.  Potential Drifts of Solid‐Contacted Ion‐Selective Electrodes Due to Zero‐Current Ion Fluxes Through the Sensor Membrane , 2000 .

[26]  Qin,et al.  Improved detection limits and unbiased selectivity coefficients obtained by using ion-exchange resins in the inner reference solution of ion-selective polymeric membrane electrodes , 2000, Analytical chemistry.

[27]  J. Bobacka,et al.  Potential Stability of All-Solid-State Ion-Selective Electrodes Using Conducting Polymers as Ion-to-Electron Transducers. , 1999, Analytical chemistry.

[28]  Ernö Pretsch,et al.  Polymer Membrane Ion-Selective Electrodes–What are the Limits? , 1999 .

[29]  R. E. Gyurcsányi,et al.  Tailored transport through ion-selective membranes for improved detection limits and selectivity coefficients , 1999 .

[30]  A. Ivaska,et al.  Plasticizer-free all-solid-state potassium-selective electrode based on poly(3-octylthiophene) and valinomycin , 1999 .

[31]  Ernö Pretsch,et al.  Lowering the Detection Limit of Solvent Polymeric Ion-Selective Membrane Electrodes. 2. Influence of Composition of Sample and Internal Electrolyte Solution , 1999 .

[32]  P. Bühlmann,et al.  Carrier-Based Ion-Selective Electrodes and Bulk Optodes. 2. Ionophores for Potentiometric and Optical Sensors. , 1998, Chemical reviews.

[33]  E. Bakker,et al.  Effect of Transmembrane Electrolyte Diffusion on the Detection Limit of Carrier-Based Potentiometric Ion Sensors , 1998 .

[34]  Ernö Pretsch,et al.  Carrier-Based Ion-Selective Electrodes and Bulk Optodes. 1. General Characteristics. , 1997, Chemical reviews.

[35]  E. Pretsch,et al.  Large Improvement of the Lower Detection Limit of Ion-Selective Polymer Membrane Electrodes , 1997 .

[36]  A. Michalska,et al.  All-Solid-State Potentiometric Sensors for Potassium and Sodium Based on Poly(pyrrole) Solid Contact , 1997 .

[37]  Richard B. Brown,et al.  Enhancing EMF stability of solid-state ion-selective sensors by incorporating lipophilic silver-ligand complexes within polymeric films , 1996 .

[38]  Johan Bobacka,et al.  Single-piece all-solid-state ion-selective electrode , 1995 .

[39]  P. Hauser,et al.  A potassium-ion selective electrode with valinomycin based poly(vinyl chloride) membrane and a poly(vinyl ferrocene) solid contact , 1995 .

[40]  Dermot Diamond,et al.  All-solid-state sodium-selective electrode based on a calixarene ionophore in a poly(vinyl chloride) membrane with a polypyrrole solid contact , 1992 .

[41]  A R Midgley,et al.  Electrochemical performance, biocompatibility, and adhesion of new polymer matrices for solid-state ion sensors. , 1991, Analytical chemistry.

[42]  A. Hulanicki,et al.  Calcium-selective electrodes with pvc membranes and solid internal contacts , 1976 .

[43]  R. Cattrall,et al.  Some alkylphosphoric acid esters for use in coated-wire calcium-selective electrodes: Part I. Response characteristics , 1975 .

[44]  H. J. James,et al.  Coated-wire ion-selective electrodes , 1986 .

[45]  A. Michalska,et al.  All-solid-state calcium solvent polymeric membrane electrode for low-level concentration measurements. , 2003, Analytical chemistry.

[46]  F. Diederich,et al.  Redox-active self-assembled monolayers as novel solid contacts for ion-selective electrodes , 2000 .

[47]  A. Michalska,et al.  The specific influence of hydrogen ions on poly(pyrrole) potentiometry , 1999 .

[48]  Róbert E. Gyurcsányi,et al.  Novel polypyrrole based all-solid-state potassium-selective microelectrodes , 1998 .

[49]  A. Ivaska,et al.  All solid-state poly(vinyl chloride) membrane ion-selective electrodes with poly(3-octylthiophene) solid internal contact , 1994 .