Cut-Off Circular Waveguide Method for Dielectric Substrate Measurements in Millimeter Wave Range(General Methods, Materials, and Passive Circuits)( Advances in Characterization and Measurement Technologies for Microwave and Millimeter-Wave Materials, Devices and Circuits)

A novel resonator structure for the cut-off circular waveguide method is proposed to suppress the unwanted TE modes in the axial direction and TM modes in the radial direction. In this method, a dielectric plate sample is placed between two copper circular cylinders and clamped by two clips. The cylinder regions constitute the TE0m mode cut-off waveguides. The measurement principle is based on a rigorous analysis by the Ritz-Galerkin method. Many resonance modes observed in the measurement can be identified effectively by mode charts. In order to verify the validity of the novel structure for this method, the temperature dependences for three low-loss organic material plates were measured in the frequency range 40 to 50 GHz. It is found that modified polyolefin plates have comparable electric characteristics and low price, compared with PTFE plates. Moreover, it is verified that the novel resonator structure is effective in improvement of accuracy and stability in measurement. The measurement precisions are estimated within 1 percent for er and within 15 percent for tan δ. key words: cut-off circular waveguide method, millimeter wave, dielectric substrate measurement

[1]  Yoshio Kobayashi,et al.  Millimeter wave measurements of some low-loss dielectric plates by a novel cut-off circular waveguide method , 2002, 2002 32nd European Microwave Conference.

[2]  Yoshio Kobayashi,et al.  Design of a Grooved Circular Cavity for Dielectric Substrate Measurements in Millimeter Wave Region , 2003 .

[3]  T. Shimizu,et al.  Millimeter wave measurements of temperature dependence of complex permittivity of GaAs plates by a circular waveguide method , 2001, 2001 IEEE MTT-S International Microwave Sympsoium Digest (Cat. No.01CH37157).

[4]  Yoshio Kobayashi,et al.  Some discussions of the resonator structure for the cut-off waveguide method and the round robin test , 2003, 2003 33rd European Microwave Conference, 2003.

[5]  G. Kent.  An evanescent-mode tester for ceramic dielectric substrates , 1988 .

[6]  T. Shimizu,et al.  Millimeter wave measurements of temperature dependence of complex permittivity of dielectric plates by a cavity resonance method , 1997, 1999 IEEE MTT-S International Microwave Symposium Digest (Cat. No.99CH36282).

[7]  Alexander Lamb Cullen,et al.  The accurate measurement of permittivity by means of an open resonator , 1971, Proceedings of the Royal Society of London. A. Mathematical and Physical Sciences.

[8]  Y. Kobayashi,et al.  Influence of Conductor Shields on the Q-Factors of a Te/sub 0/ Dielectric Resonator , 1985, 1985 IEEE MTT-S International Microwave Symposium Digest.

[9]  Yoshio Kobayashi,et al.  Complex Permittivity Measurement of Dielectric Plates by a Cavity Resonance Method , 1988 .

[10]  Y. Kogami.  Measurements of complex permittivities in 100 GHz band by the Whispering-gallery mode resonator method , 2001 .