Mach–Zehnder Interferometer Based on Interference of Selective High-Order Core Modes

We report a novel Mach-Zehnder interferometer based on interference of selective high-order core modes in few mode fibers (FMFs). The proposed interferometer is composed of a section of FMF sandwiched between single-mode fibers with small lateral core-offsets. The theoretical and experimental results indicate that the interference patterns are coupled between core modes LP21 and LP02. Because LP21 and LP02 both reside in the fiber core, few of the guided light can propagate outside the fiber through the evanescent wave, which makes the sensor insensitive to surrounding refractive index (RI). The experimental results show that the proposed structure has a high strain sensing sensitivity of 3.35 pm/μu within the range of 0-1000 μu at the wavelength of 1513 nm. RI insensitivity makes the device convenient for strain measurement in humid environment.

[1]  B. Kim,et al.  Use of highly elliptical core fibers for two-mode fiber devices. , 1987, Optics letters.

[2]  Weihong Bi,et al.  Refractive index insensitive temperature sensor based on specialty triple-clad fiber. , 2015, Optics express.

[3]  Youngjoo Chung,et al.  High temperature fiber sensor with high sensitivity based on core diameter mismatch. , 2008, Optics express.

[4]  Li Wang,et al.  CO2-Laser-Induced Long Period Fiber Gratings in Few Mode Fibers , 2015, IEEE Photonics Technology Letters.

[5]  Shecheng Gao,et al.  Long-Period Fiber Grating Cascaded to an S Fiber Taper for Simultaneous Measurement of Temperature and Refractive Index , 2013, IEEE Photonics Technology Letters.

[6]  Qiang Wu,et al.  High sensitivity SMS fiber structure based refractometer--analysis and experiment. , 2011, Optics express.

[7]  In-Fiber Modal Interferometer Based on Coaxial Dual-Waveguide Fiber for Temperature Sensing , 2014, IEEE Photonics Technology Letters.

[8]  Chi Chiu Chan,et al.  Strain Sensor Realized by Using Low-Birefringence Photonic-Crystal-Fiber-Based Sagnac Loop , 2010, IEEE Photonics Technology Letters.

[9]  Robert S. Windeler,et al.  External refractive index insensitive air-clad long period fibre grating , 1999 .

[10]  Zhi Wang,et al.  Bending sensor based on intermodal interference properties of two-dimensional waveguide array fiber. , 2012, Optics letters.

[11]  Roland Ryf,et al.  6×56-Gb/s mode-division multiplexed transmission over 33-km few-mode fiber enabled by 6×6 MIMO equalization. , 2011, Optics express.

[12]  Peiguang Yan,et al.  Ambient refractive index-independent bending vector sensor based on seven-core photonic crystal fiber using lateral offset splicing. , 2013, Optics express.

[13]  Hwa-Yaw Tam,et al.  Temperature-insensitive strain sensor with polarization-maintaining photonic crystal fiber based Sagnac interferometer , 2007 .

[14]  Y Wang,et al.  Fiber In-Line Mach–Zehnder Interferometer Embedded in FBG for Simultaneous Refractive Index and Temperature Measurement , 2010, IEEE Photonics Technology Letters.

[15]  Hong-Bo Sun,et al.  Single S-tapered fiber Mach-Zehnder interferometers. , 2011, Optics letters.

[16]  C. Liao,et al.  Microfiber in-line Mach-Zehnder interferometer for strain sensing. , 2013, Optics letters.