Effect of heating rate on mechanical property, microstructure and texture evolution of Al–Mg–Si–Cu alloy during solution treatment

[1]  L. Kestens,et al.  Warm deep-drawing and post drawing analysis of two Al-Mg-Si alloys , 2014 .

[2]  J. Hirsch,et al.  Superior light metals by texture engineering: Optimized aluminum and magnesium alloys for automotive applications , 2013 .

[3]  L. Kestens,et al.  Deformation, recrystallization and plastic anisotropy of asymmetrically rolled aluminum sheets , 2010 .

[4]  L. Kestens,et al.  Effect of particles on texture banding in an aluminium alloy , 2010 .

[5]  J. Remacle,et al.  Influence of grain shape on the planar anisotropy of rolled steel sheets ― evaluation of three models , 2009 .

[6]  W. C. Liu,et al.  Effect of heating rate on the microstructure and texture of continuous cast AA 3105 aluminum alloy , 2008 .

[7]  W. C. Liu,et al.  Evolution of recrystallization and recrystallization texture in continuous-cast AA 3015 aluminum alloy , 2005 .

[8]  P. van Houtte,et al.  Recrystallization Texture and r-Value of Rolled and T4-Treated Al-Mg-Si Alloy Sheets , 2005 .

[9]  F. J. Humphreys,et al.  Recrystallisation behaviour of supersaturated Al–Mn alloys Part 1 – Al–1.3 wt-%Mn , 2003 .

[10]  Olaf Engler,et al.  Texture control by thermomechanical processing of AA6xxx Al–Mg–Si sheet alloys for automotive applications—a review , 2002 .

[11]  Young-Hoon Chung,et al.  EFFECT OF GRAIN SHAPE AND TEXTURE ON THE EARINGS IN AN Al-Li ALLOY , 2000 .

[12]  W. S. Miller,et al.  Recent development in aluminium alloys for the automotive industry , 2000 .

[13]  S. Kwun,et al.  Effects of grain shape and texture on the yield strength anisotropy of Al-Li alloy sheet , 1999 .

[14]  G. J. Marshall,et al.  Continuous recrystallization—related phenomena in a commercial Al–Fe–Si alloy , 1998 .

[15]  M. Ferry,et al.  High-rate annealing of single-phase and particle-containing aluminium alloys , 1997 .

[16]  H. Ko,et al.  Texture and plastic anisotropy of Al-Mg-0.3Cu-1.0Zn alloys , 1997 .

[17]  M. Aindow,et al.  The effect of finely dispersed particles on primary recrystallisation textures in AlMnSi alloys , 1997 .

[18]  Daw-Kwei Leu,et al.  Prediction of the limiting drawing ratio and the maximum drawing load in cup-drawing , 1997 .

[19]  O. Engler.  On the Influence of Dispersoids on the Particle Stimulated Nucleation of Recrystallization in an Al-Fe-Si Model Alloy , 1996 .

[20]  J. Hirsch,et al.  Recrystallization Textures and Plastic Anisotropy in Al-Mg-Si Sheet Alloys , 1996 .

[21]  O. Daaland,et al.  Recrystallization texture development in commercial AlMnMg alloys , 1996 .

[22]  D. Lloyd,et al.  Microstructural control of aluminum sheet used in automotive applications , 1995 .