Pitting and uniform corrosion source recognition using acoustic emission parameters
暂无分享,去创建一个
[1] H. Uhlig,et al. Corrosion and corrosion control , 1971 .
[2] M. Fregonese,et al. Ability of acoustic emission technique for detection and monitoring of crevice corrosion on 304L austenitic stainless steel , 2003 .
[3] C. Tronel,et al. An acoustic emission technique for monitoring pitting corrosion of austenitic stainless steels , 1995 .
[4] H. Idrissi,et al. Use of acoustic emission technique for the early detection of aluminum alloys exfoliation corrosion , 2002 .
[5] Dong-Jin Yoon,et al. Detecting the Extent of Corrosion with Acoustic Emission , 2000 .
[6] Effect of Sulfuric Acid Concentration on Acoustic Emission Signals in Uniform-Corrosion , 2006 .
[7] Asa Prateepasen,et al. Study on source location using an acoustic emission system for various corrosion types , 2007 .
[8] A. Prateepasen,et al. Identification of AE Source in Corrosion Process , 2006 .
[9] Liang-Shih Fan,et al. Bubble formation and dynamics in gas–liquid–solid fluidization—A review , 2007 .
[10] C. Scruby,et al. An introduction to acoustic emission , 1986 .
[11] H. Idrissi,et al. A study of abrasion–corrosion of AISI 304L austenitic stainless steel in saline solution using acoustic emission technique , 2000 .
[12] M. Fregonese,et al. Study of oxygen reduction on stainless steel surfaces and its contribution to acoustic emission recorded during corrosion processes , 2006 .
[13] M. Fregonese,et al. Initiation and propagation steps in pitting corrosion of austenitic stainless steels: monitoring by acoustic emission , 2001 .
[14] Ahmet Cakir,et al. Ae response of 316L SS during SSR test under potentiostatic control fn1 fn1 This paper was presented , 1999 .
[15] Denny A. Jones. Principles and prevention of corrosion , 1991 .
[16] Kazimierz Darowicki,et al. Investigation of pitting corrosion of stainless steel by means of acoustic emission and potentiodynamic methods , 2003 .
[17] G. T. Burstein,et al. Effect of impact angle on the slurry erosion–corrosion of 304L stainless steel , 2000 .
[18] Julie Varley,et al. The uses of passive measurement of acoustic emissions from chemical engineering processes , 2001 .
[19] Peter Tscheliesnig,et al. FIELD TESTING OF FLAT BOTTOMED STORAGE TANKS WITH ACOUSTIC EMISSION - A REVIEW ON THE GAINED EXPERIENCE , 2003 .
[20] Asa Prateepasen,et al. Semi-Parametric Learning for Classification of Pitting Corrosion Detected by Acoustic Emission , 2006 .
[21] T. Leighton. The Acoustic Bubble , 1994 .
[23] R. López,et al. Simultaneous measurement of acoustic emission and electrical resistance variation in stress-corrosion cracking , 1995 .
[24] T. Faure,et al. Acoustic emission study of active–passive transitions during carbon steel erosion–corrosion in concentrated sulfuric acid , 2002 .
[25] H. Idrissi,et al. Characterization and control of selective corrosion of α,β′-brass by acoustic emission , 2003 .
[26] Jeong-Rock Kwon,et al. Acoustic emission testing of repaired storage tank , 2001 .
[27] C. B. Scruby,et al. A new technique for the measurement of acoustic emission transients and their relationship to crack propagation , 1978 .
[28] R. Oltra,et al. Abrasion-corrosion studies of passive stainless steels in acidic media: combination of acoustic emission and electrochemical techniques , 1995 .