A study on multi-nozzle arrangement for spray cooling system in natural draft dry cooling tower

Natural draft dry cooling tower (NDDCT) technology is especially attractive to power plants built in arid regions with limited water resource. However, high ambient temperature in summer deteriorates the performance of built NDDCT. To address this problem, evaporative pre-cooling technology has been developed by using nozzles to disintegrate water into fine droplets to achieve quick evaporation. The pre-cooled air flowing through radiator, has an enhanced heat exchange with the hot working fluid in the tube side. This paper reports a spray cooling system for the experimental tower built in UQ by combining several nozzle LNN1.5 to cool the inlet air and consequently improve the cooling efficiency of the NDDCT. To minimize water usage, a careful arrangement of spray nozzles should be investigated to achieve the maximum cooling outcome. With five nozzles installment, the inlet air is cooled by 6.3 °C, corresponding to 51.2% cooling efficiency. A dimensionless analysis is presented to correlate cooling efficiency with influencing factors. The advantage of this pre-cooling system lies in the efficient water usage: more than 96% of the injected water extracts substantial heat from hot air and evaporates into vapor, leading to a pre-cooled airflow.

[1]  W. Sirignano,et al.  Fluid Dynamics and Transport of Droplets and Sprays , 1999 .

[2]  C. Crowe,et al.  The Particle-Source-In Cell (PSI-CELL) Model for Gas-Droplet Flows , 1977 .

[3]  Boyin Zhang,et al.  A study of the unfavorable effects of wind on the cooling efficiency of dry cooling towers , 1995 .

[4]  Mustapha Chaker.  Key Parameters for the Performance of Impaction-Pin Nozzles Used in Inlet Fogging of Gas Turbine Engines , 2007 .

[5]  Junjie Yan,et al.  Droplet dispersion characteristics of the hollow cone sprays in crossflow , 2013 .

[6]  Yan Li,et al.  Numerical study on the cooling performance of natural draft dry cooling tower with vertical delta radiators under constant heat load , 2015 .

[7]  Ingo Jahn,et al.  Nozzle arrangement effect on cooling performance of saline water spray cooling , 2016 .

[8]  Xi Jiang,et al.  Physical modelling and advanced simulations of gas―liquid two-phase jet flows in atomization and sprays , 2010 .

[9]  H. Montazeri,et al.  Evaporative cooling by water spray systems: CFD simulation, experimental validation and sensitivity analysis , 2015 .

[10]  S. W. Park,et al.  Rainfall characteristics and their relation to splash erosion , 1983 .

[11]  Said Elgobashi,et al.  An Updated Classification Map of Particle-Laden Turbulent Flows , 2006 .

[12]  Antonio Sánchez Kaiser,et al.  NUMERICAL MODEL OF EVAPORATIVE COOLING PROCESSES IN A NEW TYPE OF COOLING TOWER , 2005 .

[13]  J. D. Sartor,et al.  Prediction and Measurement of the Accelerated Motion of Water Drops in Air , 1975 .

[14]  Bjarne Husted,et al.  Comparison of PIV and PDA droplet velocity measurement techniques on two high-pressure water mist nozzles , 2009 .

[15]  W. M. Robertson,et al.  The effects of spray-chilling carcasses on the shrinkage and quality of beef. , 1988, Meat science.

[16]  Hal Gurgenci,et al.  CFD analysis of pre-cooling water spray system in natural draft dry cooling towers , 2016 .

[17]  Suoying He,et al.  Numerical simulation of water spray for pre-cooling of inlet air in natural draft dry cooling towers , 2013 .

[18]  W. E. Ranz,et al.  Evaporation from drops , 1952 .

[19]  Mehmet Kanoglu,et al.  Improving the performance of an existing air-cooled binary geothermal power plant : A case study , 1999 .

[20]  S. A. Morsi,et al.  An investigation of particle trajectories in two-phase flow systems , 1972, Journal of Fluid Mechanics.

[21]  Cyrus B. Meher-Homji,et al.  Inlet Fogging of Gas Turbine Engines—Part I: Fog Droplet Thermodynamics, Heat Transfer, and Practical Considerations , 2004 .

[22]  M. D. Su,et al.  Numerical simulation of fluid flow and thermal performance of a dry-cooling tower under cross wind condition , 1999 .

[23]  Ingo Jahn,et al.  An investigation on spray cooling using saline water with experimental verification , 2016 .

[24]  A. Stilgoe,et al.  A theoretical model with experimental verification for heat and mass transfer of saline water droplets , 2015 .

[25]  Z. Guan,et al.  Investigation on the influence of injection direction on the spray cooling performance in natural draft dry cooling tower , 2017 .

[26]  W. Sirignano,et al.  Fluid Dynamics and Transport of Droplets and Sprays: Index , 2010 .

[27]  Detlev G. Kröger,et al.  Performance evaluation of dry-cooling systems for power plant applications , 1996 .

[28]  Antonio Peretto,et al.  CFD Simulation of Water Injection in GT Inlet Duct Using Spray Experimentally Tuned Data: Nozzle Spray Simulation Model and Results for an Application to a Heavy-Duty Gas Turbine , 2007 .

[29]  A. Lefebvre.  Atomization and Sprays , 1988 .

[30]  Antonio Sánchez Kaiser,et al.  On the influence of psychrometric ambient conditions on cooling tower drift deposition , 2010 .

[31]  B. Launder,et al.  Lectures in mathematical models of turbulence , 1972 .

[32]  Xiaoze Du,et al.  Dimensional characteristics of wind effects on the performance of indirect dry cooling system with vertically arranged heat exchanger bundles , 2013 .

[33]  Suoying He,et al.  Water spray for pre-cooling of inlet air for Natural Draft Dry Cooling Towers – Experimental study , 2015 .

[34]  Suoying He,et al.  Pre-cooling with Munters media to improve the performance of Natural Draft Dry Cooling Towers , 2013 .

[35]  D. Costenaro,et al.  Assessment of Evaporative Cooling Enhancement Methods for Air-Cooled Geothermal Power Plants , 2002 .

[36]  Cyrus B. Meher-Homji,et al.  Inlet Fogging of Gas Turbine Engines—Part III: Fog Behavior in Inlet Ducts, Computational Fluid Dynamics Analysis, and Wind Tunnel Experiments , 2004 .

[37]  Cyrus B. Meher-Homji,et al.  Inlet fogging of gas turbine engines. Part II: Fog droplet sizing analysis, nozzle types, measurement, and testing , 2004 .

[38]  Yan Li,et al.  Numerical study on the cooling performance of dry cooling tower with vertical two-pass column radiators under crosswind , 2015 .

[39]  Detlev G. Kröger,et al.  Performance optimization of dry-cooling systems for power plants through SQP methods , 1998 .

[40]  Ting Wang,et al.  Simulation of Mist Transport for Gas Turbine Inlet Air Cooling , 2004 .

[41]  P. Boulet,et al.  Air cooling by evaporating droplets in the upward flow of a condenser , 2011 .

[42]  T. S. Dhanasekaran,et al.  Calibration of a Computational Model to Predict Mist/Steam Impinging Jets Cooling With an Application to Gas Turbine Blades , 2010 .

[43]  Ebrahim Rezaei,et al.  Reducing water consumption of an industrial plant cooling unit using hybrid cooling tower , 2010 .