Thermal simulation of composite high conductivity laminated microencapsulated phase change material (MEPCM) board

In this paper, 3-dimensional geometric models have been developed to evaluate the particle distribution effect on the thermal performance of a composite high conductivity laminated MEPCM board. For the purpose of comparison three geometric configurations (rectangular, triangular and pyramidal) were considered for the distribution network. Copper foam was used as the base material for fixing the positions of the MEPCM particles and to enhance the thermal conductivity of the composite laminated board. The simulation results show that the thermal response times for the rectangular and triangular geometries were about half that of the pyramidal geometry during cooling and heating processes of the board. Even though there were no significant differences in their effective thermal conductivities, the values were more than ten (10) times that of pure MEPCM but suffered from a reduction in energy storage capacities by about 48%. Other methods of enhancing both thermal conductivity and energy storage are therefore encouraged.

[1]  K Darkwa,et al.  Quasi-isotropic laminated phase-change material system , 2007 .

[2]  André Bontemps,et al.  Realization, test and modelling of honeycomb wallboards containing a Phase Change Material , 2011 .

[3]  D. A. G. Bruggeman.  Berechnung verschiedener physikalischer Konstanten von heterogenen Substanzen. I. Dielektrizitätskonstanten und Leitfähigkeiten der Mischkörper aus isotropen Substanzen , 1935 .

[4]  W. Woodside,et al.  Thermal Conductivity of Porous Media. I. Unconsolidated Sands , 1961 .

[5]  D. Gray,et al.  The validity of the boussinesq approximation for liquids and gases , 1976 .

[6]  Liwu Fan,et al.  Thermal conductivity enhancement of phase change materials for thermal energy storage: A review , 2011 .

[7]  Martin R. Wolf,et al.  K3 User Guide , 2000 .

[8]  A. Elgafy,et al.  Numerical Study for Enhancing the Thermal Conductivity of Phase Change Material (PCM) Storage using High Thermal Conductivity Porous Matrix , 2005 .

[9]  Na Zhu,et al.  Dynamic characteristics and energy performance of buildings using phase change materials: A review , 2009 .

[10]  James G. Berryman,et al.  Thermal conductivity of porous media , 2004 .

[11]  Lawrence E. Nielsen,et al.  Dynamic mechanical properties of particulate‐filled composites , 1970 .

[12]  M. Santamouris,et al.  Development and testing of PCM doped cool colored coatings to mitigate urban heat island and cool buildings , 2011 .

[13]  Yi Li,et al.  Thermal stability of composite phase change material microcapsules incorporated with silver nano-particles , 2007 .

[14]  J. Fukai,et al.  Thermal conductivity enhancement of energy storage media using carbon fibers , 2000 .

[15]  Joseph Virgone,et al.  Experimental investigation of wallboard containing phase change material: Data for validation of numerical modeling , 2009 .

[16]  Dong Zhang,et al.  Experimental study on the phase change behavior of phase change material confined in pores , 2007 .

[17]  Pramod B. Salunkhe,et al.  A review on effect of phase change material encapsulation on the thermal performance of a system , 2012 .