Path loss characteristics for vehicle-to-infrastructure channel in urban and suburban scenarios at 5.9 GHz

This paper investigates path loss characteristics for Vehicle-to-Infrastructure (V2I) communications in urban and suburban scenarios. We carried out measurements at 5.9 GHz. The transmitter antenna heights are 3.5 m and 1.5 m and the position of the receiver antenna is on the roof of the car. Then we analyzed the path loss characteristics by using the measured data. The results are helpful for the V2I communications system design.

[1]  Andreas F. Molisch,et al.  High-Speed Railway Communications: From GSM-R to LTE-R , 2016, IEEE Vehicular Technology Magazine.

[2]  Johan Karedal,et al.  Overview of Vehicle-to-Vehicle Radio Channel Measurements for Collision Avoidance Applications , 2010, 2010 IEEE 71st Vehicular Technology Conference.

[3]  Bo Ai,et al.  An Empirical Path Loss Model and Fading Analysis for High-Speed Railway Viaduct Scenarios , 2011, IEEE Antennas and Wireless Propagation Letters.

[4]  Fredrik Tufvesson,et al.  Vehicle-to-Vehicle Propagation Models With Large Vehicle Obstructions , 2014, IEEE Transactions on Intelligent Transportation Systems.

[5]  Jian Yu,et al.  On the Clustering of Radio Channel Impulse Responses Using Sparsity-Based Methods , 2016, IEEE Transactions on Antennas and Propagation.

[6]  Fredrik Tufvesson,et al.  This article has been accepted for inclusion in a future issue of this journal. Content is final as presented, with the exception of pagination. INVITED PAPER Vehicular Channel Characterization and Its Implications for Wireless System Design and Performan , 2022 .

[7]  Fan Bai,et al.  Mobile Vehicle-to-Vehicle Narrow-Band Channel Measurement and Characterization of the 5.9 GHz Dedicated Short Range Communication (DSRC) Frequency Band , 2007, IEEE Journal on Selected Areas in Communications.

[8]  Falko Dressler,et al.  On the applicability of Two-Ray path loss models for vehicular network simulation , 2012, 2012 IEEE Vehicular Networking Conference (VNC).

[9]  J. Miller,et al.  Vehicle-to-vehicle-to-infrastructure (V2V2I) intelligent transportation system architecture , 2008, 2008 IEEE Intelligent Vehicles Symposium.

[10]  Theodore S. Rappaport,et al.  Propagation measurements and models for wireless communications channels , 1995, IEEE Commun. Mag..

[11]  Xiaobo Liu,et al.  An Overview of Intelligent Transportation System Communication Technology , 2009 .

[12]  Claude Oestges,et al.  A Dynamic Wideband Directional Channel Model for Vehicle-to-Vehicle Communications , 2015, IEEE Transactions on Industrial Electronics.

[13]  Fei-Yue Wang,et al.  Parallel Control and Management for Intelligent Transportation Systems: Concepts, Architectures, and Applications , 2010, IEEE Transactions on Intelligent Transportation Systems.

[14]  Fredrik Tufvesson,et al.  Path Loss Modeling for Vehicle-to-Vehicle Communications , 2011, IEEE Transactions on Vehicular Technology.

[15]  G. Dimitrakopoulos,et al.  Intelligent Transportation Systems , 2010, IEEE Vehicular Technology Magazine.

[16]  B. Ai,et al.  Characterization of Quasi-Stationarity Regions for Vehicle-to-Vehicle Radio Channels , 2015, IEEE Transactions on Antennas and Propagation.

[17]  Andreas F. Molisch.  UWB propagation channels , 2009 .

[18]  Bo Ai,et al.  Propagation measurements and analysis for high-speed railway cutting scenario , 2011 .

[19]  Fredrik Tufvesson,et al.  Directional Analysis of Vehicle-to-Vehicle Propagation Channels , 2011, 2011 IEEE 73rd Vehicular Technology Conference (VTC Spring).

[20]  Houbing Song,et al.  On a simulation study of cyber attacks on vehicle-to-infrastructure communication (V2I) in Intelligent Transportation System (ITS) , 2015, Commercial + Scientific Sensing and Imaging.

[21]  Henry L. Bertoni,et al.  Radio Propagation for Modern Wireless Systems , 1999 .