DCM, FSM, dead time and width controllers for a high frequency high efficiency buck DC-DC converter over a wide load range

This paper presents a width controller, a dead time controller, a discontinuous current mode (DCM) controller and a frequency skipping modulation (FSM) controller for a high frequency high efficiency buck DC-DC converter. To improve the efficiency over a wide load range, especially at high switching frequency, the dead time controller and width controller are applied to enhance the high load efficiency, while the DCM controller and FSM controller are proposed to increase the light load efficiency. The proposed DC-DC converter controllers have been designed and fabricated in the Chartered 0.35 μm CMOS process, and the measured results show that the efficiency of the buck DC-DC converter is above 80% over a wide load current range from 8 to 570 mA, and the peak efficiency is 86% at 10 MHz switching frequency.

[1]  K.G. McCarthy,et al.  Design and optimisation of a high current, high frequency monolithic buck converter , 2008, 2008 Twenty-Third Annual IEEE Applied Power Electronics Conference and Exposition.

[2]  Raymond Foley,et al.  A 20 MHz 200-500 mA Monolithic Buck Converter for RF Applications , 2009, 2009 Twenty-Fourth Annual IEEE Applied Power Electronics Conference and Exposition.

[3]  Thomas H. Lee,et al.  A 3MHz Low-Voltage Buck Converter with Improved Light Load Efficiency , 2007, 2007 IEEE International Solid-State Circuits Conference. Digest of Technical Papers.

[4]  S. Reynolds.  A DC-DC converter for short-channel CMOS technologies , 1997 .

[5]  Bilal Manai,et al.  A 0.65-0.9-1.2V Supplies 10MHz High Efficiency PWM CMOS Buck DC-DC Converter , 2007, 2007 14th IEEE International Conference on Electronics, Circuits and Systems.

[6]  Wai Tung Ng,et al.  A 1V buck converter IC with hybrid current-mode control and a charge-pump DAC , 2008, 2008 IEEE Power Electronics Specialists Conference.

[7]  Ke-Horng Chen,et al.  A new PWM/PFM control technique for improving efficiency over wide load range , 2008, 2008 15th IEEE International Conference on Electronics, Circuits and Systems.

[8]  Ke-Horng Chen,et al.  Dithering Skip Modulation, Width and Dead Time Controllers in Highly Efficient DC-DC Converters for System-On-Chip Applications , 2007, IEEE Journal of Solid-State Circuits.

[9]  Ke-Horng Chen,et al.  A high-speed and precise current sensing circuit with bulk control (CCB) technique , 2008, 2008 15th IEEE International Conference on Electronics, Circuits and Systems.

[10]  Tsz Yin Man,et al.  An Auto-Selectable-Frequency Pulse-Width Modulator for Buck Converters with Improved Light-Load Efficiency , 2008, 2008 IEEE International Solid-State Circuits Conference - Digest of Technical Papers.

[11]  Chern-Lin Chen,et al.  Zero-Voltage-Switching Control for a PWM Buck Converter Under DCM/CCM Boundary , 2009, IEEE Transactions on Power Electronics.

[12]  L. Huang,et al.  On Load Adaptive Control of Voltage Regulators for Power Managed Loads: Control Schemes to Improve Converter Efficiency and Performance , 2007, IEEE Transactions on Power Electronics.

[13]  Eduard Alarcón,et al.  Energy optimization of tapered buffers for CMOS on-chip switching power converters , 2005, 2005 IEEE International Symposium on Circuits and Systems.

[14]  Dragan Maksimovic,et al.  A power stage optimization method for monolithic DC-DC converters , 2006 .