Experimental study of air entrainment mode with natural ventilation using shafts in road tunnel fires

A set of burning experiments with n-heptane pool fire were conducted to investigate the air entrainment mode with natural ventilation using shafts in road tunnel fires. One criterion was proposed to determine the critical shaft height of the plug-holing occurrence in our previous work whereas this study quantificationally analyzes the effect of plug-holing on the smoke exhaust efficiency. The disturbance of smoke exhausting on the smoke–air interface, which causes different amounts of fresh air exhausted directly and indirectly, is investigated. Results show that using vertical shafts to discharge smoke leads to a strong mixing process between the smoke layer and the fresh air. Consequently, about 2/3 of the smoke exhausting rate of the shaft is air. Moreover, some of the entrained air mixes into the smoke layer downstream the shaft, resulting, in a small reduction amount of the spilling smoke, which also proves an inefficient smoke exhausting process. Hence, for the sake of improving effectiveness of natural ventilation, some significant improvements are needed in practice.

[1]  Jin Kim,et al.  The evaluation of natural ventilation pressure in Korean long road tunnels with vertical shafts , 2006 .

[2]  C. C. Hwang,et al.  The critical ventilation velocity in tunnel fires—a computer simulation , 2005 .

[3]  Jie Ji,et al.  Experimental investigation on influence of different transverse fire locations on maximum smoke temperature under the tunnel ceiling , 2012 .

[4]  Kuang-Chung Tsai,et al.  Critical ventilation velocity for multi-source tunnel fires , 2010 .

[5]  Shouxiang Lu,et al.  Initial fuel temperature effects on burning rate of pool fire. , 2011, Journal of hazardous materials.

[6]  Li Kaiyuan,et al.  Experimental investigation on influence of smoke venting velocity and vent height on mechanical smoke exhaust efficiency. , 2010, Journal of hazardous materials.

[7]  Lizhong Yang,et al.  The inclination effect on CO generation and smoke movement in an inclined tunnel fire , 2012 .

[9]  Y. Alarie,et al.  Toxicity of Fire Smoke , 2002, Critical reviews in toxicology.

[10]  Huo Ran.  Modeling and Experimental Studies on Mechanical Exhaust Efficiency in Compartment Fire , 2003 .

[11]  Angui Li,et al.  Fire-induced smoke control via hybrid ventilation in a huge transit terminal subway station , 2012 .

[12]  Wan Ki Chow,et al.  Numerical studies on performance evaluation of tunnel ventilation safety systems , 2003 .

[13]  Wan Ki Chow.  Determination of the Smoke Layer Interface Height for Hot Smoke Tests in Big Halls , 2009 .

[14]  Dezhi Zhu,et al.  Full-scale experiment research and theoretical study for fires in tunnels with roof openings , 2009 .

[15]  Kuang-Chung Tsai,et al.  Critical ventilation velocity for tunnel fires occurring near tunnel exits , 2011 .

[16]  Olivier Vauquelin,et al.  Experimental simulations of fire-induced smoke control in tunnels using an “air–helium reduced scale model”: Principle, limitations, results and future , 2008 .

[17]  Hiroomi Satoh,et al.  Fire properties in near field of square fire source with longitudinal ventilation in tunnels , 2003 .

[18]  Dong Hyeon Kim,et al.  Critical velocity and burning rate in pool fire during longitudinal ventilation , 2007 .

[19]  Haukur Ingason,et al.  Heat release rates from heavy goods vehicle trailer fires in tunnels , 2005 .

[20]  L. Y. Cooper,et al.  An Experimental Study of Upper Hot Layer Stratification in Full-Scale Multiroom Fire Scenarios , 1982 .

[21]  Hong Sun Ryou,et al.  Tunnel Fires: Experiments on Critical Velocity and Burning Rate in Pool Fire During Longitudinal Ventilation , 2007 .

[22]  Takeyoshi Tanaka,et al.  Smoke Control in Large Scale Spaces , 1985 .

[23]  Chang Nyung Kim,et al.  Effects of the ventilation duct arrangement and duct geometry on ventilation performance in a subway tunnel , 2011 .

[24]  Jie Ji,et al.  A study of the effect of plug-holing and boundary layer separation on natural ventilation with vertical shaft in urban road tunnel fires , 2012 .

[25]  Haukur Ingason,et al.  The maximum temperature of buoyancy-driven smoke flow beneath the ceiling in tunnel fires , 2011 .

[26]  Jie Ji,et al.  Effects of vertical shaft geometry on natural ventilation in urban road tunnel fires , 2014 .

[27]  E. Migoya,et al.  Determination of the heat release rate inside operational road tunnels by comparison with CFD calculations , 2010 .

[28]  Karim Van Maele,et al.  Application of RANS and LES field simulations to predict the critical ventilation velocity in longitudinally ventilated horizontal tunnels , 2008 .

[29]  Jie Ji,et al.  A simplified calculation method on maximum smoke temperature under the ceiling in subway station fires , 2011 .

[30]  Ming-Chun Lu,et al.  Verification of competitive kinetics technique and oxidation kinetics of 2,6-dimethyl-aniline and o-toluidine by Fenton process. , 2011, Journal of hazardous materials.

[31]  Bart Merci,et al.  Verification of the accuracy of CFD simulations in small-scale tunnel and atrium fire configurations , 2011 .

[32]  Kuang-Chung Tsai,et al.  Effect of vehicular blockage on critical ventilation velocity and tunnel fire behavior in longitudinally ventilated tunnels , 2012 .