Influence of thermal annealing on electrical and optical properties of indium tin oxide thin films

Abstract Transparent conducting indium tin oxide (ITO) thin films with the thickness of 300 nm were deposited on quartz substrates via electron beam evaporation, and five of them post-annealed in air atmosphere for 10 min at five selected temperature points from 200 °C to 600 °C, respectively. An UV–vis spectrophotometer and Hall measurement system were adopted to characterize the ITO thin films. Influence of thermal annealing in air atmosphere on electrical and optical properties was investigated in detail. The sheet resistance reached the minimum of 6.67 Ω/sq after annealed at 300 °C. It increased dramatically at even higher annealing temperature. The mean transmittance over the range from 400 nm to 800 nm reached the maximum of 89.03% after annealed at 400 °C, and the figure of merit reached the maximum of 17.79 (Unit: 10 −3  Ω −1 ) under the same annealing condition. With the annealing temperature increased from 400 °C to 600 °C, the variations of transmittance were negligible, but the figure of merit decreased significantly due to the deterioration of electrical conductivity. With increasing the annealing temperature, the absorption edge shifted towards longer wavelength. It could be explained on the basis of Burstein–Moss shift. The values of optical band gap varied in the range of 3.866–4.392 eV.

[1]  I. Hamberg,et al.  Evaporated Sn‐doped In2O3 films: Basic optical properties and applications to energy‐efficient windows , 1986 .

[2]  B. Chiou,et al.  Deposition of indium tin oxide films on polycarbonate substrates by radio-frequency magnetron sputtering , 1997 .

[3]  T. Hammad.  Effect of annealing on electrical, structural, and optical properties of sol–gel ITO thin films , 2009 .

[4]  W. Möller,et al.  Real-time evolution of the indium tin oxide film properties and structure during annealing in vacuum , 2004 .

[5]  T. Moss.  The Interpretation of the Properties of Indium Antimonide , 1954 .

[6]  D. Cameron,et al.  Investigation of annealing effects on sol-gel deposited indium tin oxide thin films in different atmospheres , 2002 .

[7]  Joseph George,et al.  Electrical and optical properties of electron beam evaporated ITO thin films , 2000 .

[8]  S. Chang,et al.  Optical, structural and electrical properties of tin doped indium oxide thin films prepared by spray-pyrolysis technique , 2000 .

[9]  Youngchul Park,et al.  Effect of substrate temperature on the bonded states of indium tin oxide thin films deposited by plasma enhanced chemical vapor deposition , 2003 .

[10]  G. Haacke.  New figure of merit for transparent conductors , 1976 .

[11]  Seunghyup Yoo,et al.  Optical Outcoupling Enhancement in Organic Light‐Emitting Diodes: Highly Conductive Polymer as a Low‐Index Layer on Microstructured ITO Electrodes , 2010, Advanced materials.

[12]  Sang Yeol Lee,et al.  Properties of ITO films on glass fabricated by pulsed laser deposition , 2003 .

[13]  Ziqiang Zhu,et al.  Sol–gel preparation of poly(ethylene glycol) doped indium tin oxide thin films for sensing applications , 2004 .

[14]  M. Ghasemi,et al.  Influence of heat treatment on structural, electrical, impedance and optical properties of nanocrystalline ITO films grown on glass at room temperature prepared by electron beam evaporation , 2007 .

[15]  A. Ennaoui,et al.  Structural, optical and electrical properties of indium tin oxide thin films prepared by spray pyrolysis , 1999 .

[16]  Young-Chul Park,et al.  ITO thin films deposited at different oxygen flow rates on Si(100) using the PEMOCVD method , 2002 .

[17]  K. Jain,et al.  Patterning of indium tin oxide by projection photoablation and lift-off process for fabrication of flat-panel displays , 2007 .

[18]  Alberto Piqué,et al.  Electrical, optical, and structural properties of indium–tin–oxide thin films for organic light-emitting devices , 1999 .

[19]  J. Yu,et al.  Glancing angle deposited ITO films for efficiency enhancement of a-Si:H/μc-Si:H tandem thin film solar cells. , 2011, Optics express.

[20]  Jinn-Kong Sheu,et al.  Effects of thermal annealing on the indium tin oxide Schottky contacts of n-GaN , 1998 .

[21]  S. Kotru,et al.  Evaluation of indium tin oxide films grown at room temperature by pulsed electron deposition , 2010 .

[22]  D. Blank,et al.  Role of Sn doping in In2O3 thin films on polymer substrates by pulsed-laser deposition at room temperature , 2006 .

[23]  Huasong Peng,et al.  Indium tin oxide thin films by bias magnetron rf sputtering for heterojunction solar cells application , 2005 .

[24]  A. Ennaoui,et al.  Spectroscopic ellipsometry studies of index profile of indium tin oxide films prepared by spray pyrolysis , 2002 .

[25]  A. Ulyashin,et al.  Deposition by magnetron sputtering and characterization of indium tin oxide thin films , 2007 .

[26]  E. Burstein.  Anomalous Optical Absorption Limit in InSb , 1954 .

[27]  X. Yi,et al.  Improved performance of lateral GaN-based light emitting diodes with novel buried CBL structure in ITO film and reflective electrodes , 2014 .

[28]  F. Placido,et al.  Annealing effect on ITO thin films prepared by microwave-enhanced dc reactive magnetron sputtering for telecommunication applications , 2003 .

[29]  Hamid Reza Fallah,et al.  The effect of deposition rate on electrical, optical and structural properties of tin-doped indium oxide (ITO) films on glass at low substrate temperature , 2006 .