Numerical simulation of power production from abandoned oil wells in Ahwaz oil field in southern Iran

Abstract Abandoned oil and gas wells can be used as low temperature geothermal resources for heat extraction from geological formations. They can provide valuable potential sources of heat without the extra cost of deep drilling required in traditional geothermal projects. In this study, two oil wells (AZ and DQ) in southern Iran were numerically simulated using a 3D technique for heat extraction. The bottom-hole temperature of wells AZ and DQ were 138.7 °C and 159.8 °C, respectively. Heat transfer between the fluid injected into the well and the surrounding hot rock was simulated. Well casing geometry and an exact thermal gradient for two abandoned oil wells were considered. The simulation results were optimized for parameters such as input and output fluid flow rates and temperatures. The results revealed that, in addition to thermal gradient and input mass flow rate, well casing geometry and the size of injection and extraction pipes were essential to the output heat extraction rate. The small internal diameter of the wells and design of the injection and extraction pipes were limited, resulting in lower mass flow rate and higher power consumption by the injection pump. Total extractable rate of heat from wells AZ-II and DQ-II was 967 kW and 1842 kW, respectively, and net electricity generation using a geothermal binary cycle was 138 kW and 364 kW, respectively.

[1]  Alessandro Franco,et al.  Optimal design of binary cycle power plants for water-dominated, medium-temperature geothermal fields , 2009 .

[2]  Tao Guo,et al.  Fluids and parameters optimization for a novel cogeneration system driven by low-temperature geother , 2011 .

[3]  S. N. Emirov,et al.  Thermal conductivity of sandstone at high pressures and temperatures , 2007 .

[4]  Ryuichi Itoi,et al.  Flash Cycle and Binary Geothermal Power Plant Optimization , 2012 .

[5]  Farhad Samadzadegan,et al.  Spatial analysis and multi-criteria decision making for regional-scale geothermal favorability map , 2014 .

[6]  W. Worek,et al.  Optimum design criteria for an Organic Rankine cycle using low-temperature geothermal heat sources , 2007 .

[7]  K. Sasaki,et al.  Developing the geothermal resources map of Iran , 2010 .

[8]  Tzu-Chen Hung,et al.  A study of organic working fluids on system efficiency of an ORC using low-grade energy sources , 2010 .

[9]  T. Kujawa,et al.  Utilization of existing deep geological wells for acquisitions of geothermal energy , 2006 .

[10]  Göran Hellström,et al.  Borehole heat exchangers : state of the art 2001 , 2002 .

[11]  José Acuña,et al.  Transient heat transfer in a coaxial borehole heat exchanger , 2014 .

[12]  Seyed Ali Ghoreishi Madiseh.  Geothermal energy extraction from petroleum wells in Qatar , 2013 .

[13]  Aie.  World Energy Outlook 2011 , 2001 .

[14]  Yong‐Le Nian,et al.  Studies on geothermal power generation using abandoned oil wells , 2013 .

[15]  Alexander Mitsos,et al.  Optimization of binary geothermal power systems , 2013 .

[16]  R. Itoi,et al.  Production capacity estimation by reservoir numerical simulation of northwest (NW) Sabalan geotherma , 2011 .

[17]  Seyed Ali,et al.  Numerical and experimental study of geothermal energy extraction from underground mines , 2014 .

[18]  Christopher J. Koroneos,et al.  Low-enthalpy geothermal resources for electricity production: A demand-side management study for intelligent communities , 2013 .

[19]  Efstathios E. Michaelides,et al.  Geothermal power production from abandoned oil wells , 2009 .

[20]  William D'haeseleer,et al.  Comparison of Thermodynamic Cycles for Power Production from Low-Temperature Geothermal Heat Sources , 2013 .

[21]  Ulvi Arslan,et al.  Geothermal application in low-enthalpy regions , 2013 .

[22]  Tao Guo,et al.  Selection of working fluids for a novel low-temperature geothermally-powered ORC based cogeneration system , 2011 .

[23]  José Acuña,et al.  Borehole resistance and vertical temperature profiles in coaxial borehole heat exchangers , 2013 .

[24]  Alexander Mitsos,et al.  Modeling and optimization of a binary geothermal power plant , 2013 .

[25]  A. Bejan.  Advanced Engineering Thermodynamics , 1988 .

[26]  Thomas Kohl,et al.  System performance of a deep borehole heat exchanger , 2002 .

[27]  Frank P. Incropera,et al.  Fundamentals of Heat and Mass Transfer , 1981 .

[28]  Xianbiao Bu,et al.  Geothermal energy production utilizing abandoned oil and gas wells , 2012 .

[29]  Ali Salim Shirazi,et al.  Thermal capacity effects in borehole ground heat exchangers , 2013 .