Timescale Correlation between Marine Atmospheric Exposure and Accelerated Corrosion Testing

Jerome C. Curran ESC Team QNA Mailstop ESC 24 Kennedy Space Center, FL 32899 Mark R. Kolody ESC Team QNA Mailstop ESC 24 Kennedy Space Center, FL 32899 Evaluation of metal-based structures has long relied on atmospheric exposure test sites to determine corrosion resistance in marine environments. Traditional accelerated corrosion testing relies on mimicking the exposure conditions, often incorporating salt spray and ultraviolet (UV) radiation, and exposing the metal to continuous or cyclic conditions of the corrosive environment. Their success for correlation to atmospheric exposure is often a concern when determining the timescale to which the accelerated tests can be related. Accelerated laboratory testing, which often focuses on the electrochemical reactions that occur during corrosion conditions, has yet to be universally accepted as a useful tool in predicting the long term service life of a metal despite its ability to rapidly induce corrosion. Although visual and mass loss methods of evaluating corrosion are the standard and their use is imperative, a method that correlates timescales from atmospheric exposure to accelerated testing would be very valuable. This work uses surface chemistry to interpret the chemical changes occurring on low carbon steel during atmospheric and accelerated corrosion conditions with the objective of finding a correlation between its accelerated and long-term corrosion performance. The current results of correlating data from marine atmospheric exposure conditions at the Kennedy Space Center beachside corrosion test site, alternating seawater spray, and immersion in typical electrochemical laboratory conditions, will be presented.

[1]  D. Joly,et al.  Hydrocarbons from sea water , 1973 .

[2]  S. Lyon,et al.  An electrochemical study of the atmospheric corrosion of iron. II: Cathodic and anodic processes on uncorroded and pre-corroded iron , 1994 .

[3]  Chris W. Brown,et al.  Characterization of the passive film formed on weathering steels , 1983 .

[4]  N. Azzerri,et al.  Assessment of corrosion rate of steel in sea water by polarization resistance technique , 1981 .

[5]  M. Gustafsson,et al.  Inland transport of marine aerosols in southern Sweden , 2000 .

[6]  Martin Stratmann,et al.  In situ Möβbauer spectroscopic study of reactions within rust layers , 1989 .

[7]  M. Morcillo,et al.  Effect of Distance from Sea on Atmospheric Corrosion Rate , 1999 .

[8]  Ashutosh Kumar Singh,et al.  Mössbauer and x-ray diffraction phase analysis of rusts from atmospheric test sites with different environments in Sweden , 1985 .

[9]  Sebastián Feliu,et al.  The prediction of atmospheric corrosion from meteorological and pollution parameters—I. Annual corrosion , 1993 .

[10]  J. Laseter,et al.  Alkanes at the Air-Sea Interface from Offshore Louisiana and Florida , 1974, Science.

[11]  Zhenyao Wang,et al.  Characterisation of initial atmospheric corrosion carbon steels by field exposure and laboratory simulation , 2007 .

[12]  Gad Frankel.  Electrochemical Techniques in Corrosion: Status, Limitations, and Needs , 2008 .

[13]  J. W. Fitzgerald,et al.  Marine aerosols: A review , 1991 .

[14]  Y. Waseda,et al.  Atomic-scale Structure and Morphology of γ-FeOOH Particles Formed during Corrosion of Fe-based Alloys in Aqueous Solution , 2008 .

[15]  F. Corvo,et al.  Changes in atmospheric corrosion rate caused by chloride ions depending on rain regime , 2005 .

[16]  Florian Mansfeld,et al.  Electrochemical monitoring of atmospheric corrosion phenomena , 1976 .

[17]  D. Draẑić,et al.  The correlation between accelerated laboratory corrosion tests and atmospheric corrosion station tests on steels , 1989 .

[18]  Martin Stratmann,et al.  On the atmospheric corrosion of metals which are covered with thin electrolyte layers. III, The measurement of polarisation curves on metal surfaces which are covered by thin electrolyte layers , 1990 .

[19]  Florian Mansfeld,et al.  Laboratory studies of atmospheric corrosion—I. Weight loss and electrochemical measurements , 1980 .

[20]  M. Morcillo,et al.  Salinity in marine atmospheric corrosion: Its dependence on the wind regime existing in the site , 2000 .

[21]  C. Leygraf,et al.  The Initial Stages of Atmospheric Corrosion of Iron in a Saline Environment Studied with Time-Resolved In Situ X-Ray Transmission Microscopy , 2010 .

[22]  Y. Li,et al.  The atmospheric corrosion kinetics of low carbon steel in a tropical marine environment , 2010 .

[23]  Francisco Corvo,et al.  Time of wetness in tropical climate: Considerations on the estimation of TOW according to ISO 9223 standard , 2008 .

[24]  J. J. Rodríguez,et al.  XRD and SEM studies of the layer of corrosion products for carbon steel in various different environments in the province of Las Palmas (The Canary Islands, Spain) , 2002 .

[25]  Hidesato Mabuchi,et al.  An electrochemical impedance study on atmospheric corrosion of steels in a cyclic wet-dry condition , 1995 .

[26]  V. F. C. Cunha Lins,et al.  Evaluation of the atmospheric corrosion resistance of AISI A-36 steel painted with coatings based on epoxy and poly(urethane) resins using semi-accelerated testing , 2009 .

[27]  J. Defourny,et al.  A literature survey on the development of an accelerated laboratory test method for atmospheric corrosion of precoated steel products , 1993 .

[28]  E. McCafferty,et al.  Validation of corrosion rates measured by the Tafel extrapolation method , 2005 .

[29]  S. Howell,et al.  Sea-Salt Size Distributions from Breaking Waves: Implications for Marine Aerosol Production and Optical Extinction Measurements during SEAS* , 2003 .

[30]  M. Manning,et al.  The episodic nature of the atmospheric rusting of steel , 1990 .

[31]  Ying Li,et al.  Corrosion of low carbon steel in atmospheric environments of different chloride content , 2009 .

[32]  M. Itagaki,et al.  Corrosion simulation of carbon steels in atmospheric environment , 2005 .

[33]  K. Asami,et al.  In-depth distribution of rusts on a plain carbon steel and weathering steels exposed to coastal-industrial atmosphere for 17 years , 2003 .

[34]  Stuart Lyon,et al.  A mechanistic study of initial atmospheric corrosion kinetics using electrical resistance sensors , 2005 .

[35]  Martin Stratmann,et al.  An electrochemical study of phase-transitions in rust layers , 1983 .

[36]  Thomas E. Graedel,et al.  Corrosion Mechanisms for Iron and Low Alloy Steels Exposed to the Atmosphere , 1990 .

[37]  H. Saricimen,et al.  Initial stages of atmospheric corrosion of steel in the Arabian Gulf , 1991 .

[38]  G. Gribble.  Naturally occurring organohalogen compounds--a comprehensive survey. , 2010, Fortschritte der Chemie organischer Naturstoffe = Progress in the chemistry of organic natural products. Progres dans la chimie des substances organiques naturelles.

[39]  N. Singh,et al.  Conversion electron Mössbauer spectroscopy study of growth and nature of corrosion products on mild steel exposed to different environments , 2009 .

[40]  Carmen Andrade,et al.  Modelling sea-salt transport and deposition in marine atmosphere zone : A tool for corrosion studies , 2008 .