PD apparent charge estimation and calibration: A critical review

This paper focuses on the limits of partial discharge apparent charge estimation and calibration using an unified approach. The fundamental problems that prevent accurate apparent charge estimates (resonances, attenuation and partial discharge pulse splitting) are tackled through this approach, highlighting the physical limitations that prevent partial discharge charge to be measured properly. The feasibility of calibration of ultra-wide bandwidth measurement systems, something that is not treated in the IEC 60270 standard, is also discussed.

[1]  S. Tenbohlen,et al.  Wide and narrow band PD detection in plug-in cable connectors in the UHF range , 2008, 2008 International Conference on Condition Monitoring and Diagnosis.

[2]  B. F. Hampton,et al.  The excitation of UHF signals by partial discharges in GIS , 1996 .

[3]  E. Gulski,et al.  Sensitivity check for on-line VHF/UHF PD detection on Transmission cables , 2006, 2006 IEEE 8th International Conference on Properties & applications of Dielectric Materials.

[4]  S. A. Boggs,et al.  Propagation of partial discharge pulses in shielded power cable , 1982, Conference on Electrical Insulation & Dielectric Phenomena - Annual Report 1982.

[5]  J. Densley,et al.  Ageing mechanisms and diagnostics for power cables - an overview , 2001 .

[6]  A. Cavallini,et al.  A novel method to locate PD in polymeric cable systems based on amplitude-frequency (AF) map , 2007, IEEE Transactions on Dielectrics and Electrical Insulation.

[7]  G. Montanari,et al.  Digital detection and fuzzy classification of partial discharge signals , 2002 .

[8]  H. Zhu,et al.  Identification of stator insulation deterioration using on-line partial discharge testing , 2001 .

[9]  T. Endoh,et al.  Development of a method of partial discharge detection in extra-high voltage cross-linked polyethylene insulated cable lines , 1992 .

[10]  M. M. Twiel,et al.  An investigation into the effects of parasitic circuit inductance on partial discharge detection , 2001, Proceedings: Electrical Insulation Conference and Electrical Manufacturing and Coil Winding Conference (Cat. No.01CH37264).

[11]  G. Montanari,et al.  Theory of inception mechanism and growth of defect-induced damage in polyethylene cable insulation , 2005 .

[12]  Alfredo Contin,et al.  Advanced PD inference in on-field measurements. I. Noise rejection , 2003 .

[13]  R. Bartnikas,et al.  Corona measurement and interpretation , 1979 .

[14]  A. Cavallini,et al.  PD detection in extruded power cables: an approximate propagation model , 2008, IEEE Transactions on Dielectrics and Electrical Insulation.

[15]  W. S. Zaengl,et al.  A critique of present calibration procedures for partial discharge measurements , 1993 .

[16]  Alfredo Contin,et al.  Advanced PD inference in on-field measurements. II. Identification of defects in solid insulation systems , 2003 .

[17]  S. Tenbohlen,et al.  Partial discharge measurement in the ultra high frequency (UHF) range , 2008, IEEE Transactions on Dielectrics and Electrical Insulation.

[18]  F. Kreuger,et al.  Discharge detection in high voltage equipment , 1964 .

[19]  A. Gandelli,et al.  A contribution on the traceability of partial discharge measurements , 1992 .

[20]  A. Cavallini,et al.  PD inference for the early detection of electrical treeing in insulation systems , 2004, IEEE Transactions on Dielectrics and Electrical Insulation.

[21]  Robert B. Northrop,et al.  Location and characterization of partial discharge sites in shielded power cables , 1990 .

[22]  Hossein Borsi,et al.  Transfer function-based partial discharge localization in power transformers: a feasibility study , 2002 .

[23]  R. Bartnikas,et al.  Engineering Dielectrics Volume I Corona Measurement and Interpretation , 1979 .

[24]  I. J. Kemp,et al.  Towards a new partial discharge calibration strategy based on the transfer function of machine stator windings , 1996 .

[25]  A. Bergman,et al.  A method for calibration of partial discharge calibrators , 1998, 1998 Conference on Precision Electromagnetic Measurements Digest (Cat. No.98CH36254).

[26]  John C. Fothergill,et al.  Electrical degradation and breakdown in polymers , 1992 .

[27]  G. C. Stone,et al.  Partial discharge. XXV. Calibration of PD measurements for motor and generator windings-why it can't be done , 1998 .