论文信息 - Analysis of the Cutting Force Components and Friction in High Speed Machining

Analysis of the Cutting Force Components and Friction in High Speed Machining

An original experimental device is used to reproduce conditions of orthogonal cutting for a wide range of cutting speeds (from 15 to about 100 m/s) (Sutter et al.). Improvement of the initial device (Sutter et al.) makes it possible to record both values of normal and tangential forces in orthogonal cutting. An analysis of the tool-chip friction is then possible for a large range of cutting speeds. The evolution of cutting force components as well as the evolution of the friction coefficient are presented and analyzed. In addition, the process of chip formation during high speed machining is illustrated by photographic recording with a high speed camera.

Gustavo Sutter | Alain Molinari | A. Molinari | G. Sutter

[1] W. N. Findley,et al. The Influence of Extreme Speeds and Rake Angles in Metal Cutting , 1963 .

[2] Fritz Klocke,et al. 2D-FEM SIMULATION OF THE ORTHOGONAL HIGH SPEED CUTTING PROCESS , 2001 .

[3] D. Lee. The Effect of Cutting Speed on Chip Formation Under Orthogonal Machining , 1985 .

[4] A. Molinari,et al. Experimental Analysis of the Cutting Process and Chip Formation at High Speed Machining , 1997 .

[5] P. W. Wallace,et al. Tool Forces and Tool-Chip Friction in Orthogonal Machining: , 1964 .

[6] Robert S. Montgomery. Friction and wear at high sliding speeds , 1976 .

[7] W. F. Hastings,et al. A machining theory for predicting chip geometry, cutting forces etc. from work material properties and cutting conditions , 1980, Proceedings of the Royal Society of London. A. Mathematical and Physical Sciences.

[8] Gustavo Sutter,et al. An Experimental Study of High Speed Orthogonal Cutting , 1998 .

[9] P. Mathew,et al. Predicting the Effects of Very High Cutting Speeds on Cutting Forces, etc. , 1982 .

[10] M. E. Merchant. Mechanics of the Metal Cutting Process. I. Orthogonal Cutting and a Type 2 Chip , 1945 .