Real-Time Implementation of a Constrained MPC for Efficient Airflow Control in a PEM Fuel Cell

Fuel cells represent an area of great industrial interest due to the possibility to generate clean energy for stationary and automotive applications. It is clear that the proper performance of these devices is closely related to the kind of control that is used; therefore, a study of improved control alternatives is fully justified. The air-supply control is widely used to guarantee safety and to achieve a high performance. This paper deals with this control loop, proposing and comparing two control objectives aimed at satisfying the oxygen starvation avoidance criterion and the maximum efficiency criterion, respectively. The control architecture is based on a constrained explicit model predictive control (MPC) law suitable for real-time implementation due to its low computational demands. The proposed controller is implemented and evaluated on a 1.2-kW polymer electrolyte membrane or proton exchange membrane fuel-cell test bench, thus obtaining real data which show that the maximum efficiency criterion does not conflict with the starvation avoidance criterion and allows system performance improvements of up to 3.46%. Moreover, experimental results utilizing the explicit MPC approach also show improved transient responses compared to those of the manufacturer's control law.

[1]  Phatiphat Thounthong,et al.  Control Strategy of Fuel Cell and Supercapacitors Association for a Distributed Generation System , 2007, IEEE Transactions on Industrial Electronics.

[2]  Michael A. Danzer,et al.  Model-based control of cathode pressure and oxygen excess ratio of a PEM fuel cell system , 2008 .

[3]  Amir Abtahi,et al.  Neural network model for a commercial PEM fuel cell system , 2007 .

[4]  Luciane Neves Canha,et al.  An electrochemical-based fuel-cell model suitable for electrical engineering automation approach , 2004, IEEE Transactions on Industrial Electronics.

[5]  Tor Arne Johansen,et al.  Approximate explicit constrained linear model predictive control via orthogonal search tree , 2003, IEEE Trans. Autom. Control..

[6]  P. Thounthong,et al.  Analysis of a Fuel Starvation Phenomenon of a PEM Fuel Cell , 2007, 2007 Power Conversion Conference - Nagoya.

[7]  Srdjan M. Lukic,et al.  Energy Storage Systems for Automotive Applications , 2008, IEEE Transactions on Industrial Electronics.

[8]  Guidong Liu,et al.  High frequency decoupling strategy for the PEM fuel cell hybrid system , 2008 .

[9]  Alberto Bemporad,et al.  Evaluation of piecewise affine control via binary search tree , 2003, Autom..

[10]  Sirivatch Shimpalee,et al.  Prediction of transient response for a 25-cm2 PEM fuel cell , 2007 .

[11]  Jong-Woo Ahn,et al.  Coolant controls of a PEM fuel cell system , 2008 .

[12]  Claire H. Woo,et al.  PEM fuel cell current regulation by fuel feed control , 2007 .

[13]  A.G. Stefanopoulou,et al.  Control of fuel cell breathing , 2004, IEEE Control Systems.

[14]  Anna G. Stefanopoulou,et al.  Control of Fuel Cell Power Systems , 2004 .

[15]  Fu-Cheng Wang,et al.  Low power proton exchange membrane fuel cell system identification and adaptive control , 2007 .

[16]  Maher A.R. Sadiq Al-Baghdadi,et al.  Modelling of proton exchange membrane fuel cell performance based on semi-empirical equations , 2005 .

[17]  Jorge Moreno,et al.  Ultracapacitor-Based Auxiliary Energy System for an Electric Vehicle: Implementation and Evaluation , 2007, IEEE Transactions on Industrial Electronics.

[18]  T. Springer,et al.  Polymer Electrolyte Fuel Cell Model , 1991 .

[19]  T. Nguyen,et al.  A liquid water management strategy for PEM fuel cell stacks , 2003 .

[20]  M. Ouyang,et al.  Modeling and control of air stream and hydrogen flow with recirculation in a PEM fuel cell system - I. Control-oriented modeling , 2006 .

[21]  Minggao Ouyang,et al.  Modeling and control of air stream and hydrogen flow with recirculation in a PEM fuel cell system - II. Linear and adaptive nonlinear control , 2006 .

[22]  Anna G. Stefanopoulou,et al.  Current Management in a Hybrid Fuel Cell Power System: A Model-Predictive Control Approach , 2006, IEEE Transactions on Control Systems Technology.

[23]  James Larminie,et al.  Fuel Cell Systems Explained , 2000 .

[24]  D. Chu,et al.  Performance of polymer electrolyte membrane fuel cell (PEMFC) stacks. Part I. Evaluation and simulation of an air-breathing PEMFC stack , 1999 .

[25]  C. Bordons,et al.  Development and experimental validation of a PEM fuel cell dynamic model , 2007 .

[26]  James Larminie,et al.  Fuel Cell Systems Explained: Larminie/Fuel Cell Systems Explained , 2003 .

[27]  Alberto Bemporad,et al.  The explicit linear quadratic regulator for constrained systems , 2003, Autom..

[28]  J. C. Amphlett,et al.  Performance modeling of the Ballard Mark IV solid polymer electrolyte fuel cell. II: Empirical model development , 1995 .

[29]  T. Fuller,et al.  Water and Thermal Management in Solid‐Polymer‐Electrolyte Fuel Cells , 1993 .

[30]  David Q. Mayne,et al.  Constrained model predictive control: Stability and optimality , 2000, Autom..

[31]  Mohammad S. Alam,et al.  Neural networks-based control of active and reactive power of a stand-alone PEM fuel cell power plant , 2004 .

[32]  Shuhai Quan,et al.  Model predictive control of water management in PEMFC , 2008 .

[33]  David Q. Mayne,et al.  Control of Constrained Dynamic Systems , 2001, Eur. J. Control.

[34]  Alberto Bemporad,et al.  Corrigendum to: "The explicit linear quadratic regulator for constrained systems" [Automatica 38(1) (2002) 3-20] , 2003, Autom..

[35]  Lino Guzzella,et al.  Optimizing air supply control of a PEM fuel cell system , 2003, Proceedings of the 2003 American Control Conference, 2003..

[36]  Tatsuhiro Okada,et al.  Theory for water management in membranes for polymer electrolyte fuel cells: Part 1. The effect of impurity ions at the anode side on the membrane performances , 1999 .

[37]  Carlos Andrés Ramos-Paja,et al.  Minimum Fuel Consumption Strategy for PEM Fuel Cells , 2009, IEEE Transactions on Industrial Electronics.

[38]  C. Bordons,et al.  Constrained predictive control strategies for PEM fuel cells , 2006, 2006 American Control Conference.

[39]  Anna G. Stefanopoulou,et al.  Parameterization and prediction of temporal fuel cell voltage behavior during flooding and drying conditions , 2008 .

[40]  Jing Sun,et al.  Load governor for fuel cell oxygen starvation protection: a robust nonlinear reference governor approach , 2004 .

[41]  Huei Peng,et al.  Model predictive control for starvation prevention in a hybrid fuel cell system , 2004, Proceedings of the 2004 American Control Conference.

[42]  Daniel Hissel,et al.  Energy-Management Strategy for Embedded Fuel-Cell Systems Using Fuzzy Logic , 2007, IEEE Transactions on Industrial Electronics.

[43]  Daniel Hissel,et al.  Energy consumption reduction of a PEM fuel cell motor-compressor group thanks to efficient control laws , 2006 .

[44]  Anna G. Stefanopoulou,et al.  Mechatronics in fuel cell systems , 2004 .

[45]  Carlos Bordons,et al.  Design and experimental validation of a constrained MPC for the air feed of a fuel cell , 2009 .

[46]  Daniel Hissel,et al.  A New Modeling Approach of Embedded Fuel-Cell Power Generators Based on Artificial Neural Network , 2008, IEEE Transactions on Industrial Electronics.

[47]  Carlos Bordons,et al.  Application of constrained predictive control strategies to a PEM fuel cell benchmark , 2007, 2007 European Control Conference (ECC).

[48]  Lino Guzzella,et al.  Optimal power management of an experimental fuel cell/supercapacitor-powered hybrid vehicle , 2005 .