Control System Based on PLC for Winding Machine

Aiming at the performance of winding machine which implements the winding operation on special motor, a control system is designed based on PLC and permanent-magnet AC servo motor. The hardware design of the control system includes the serve drive design, photo electronic coupler and A/D expanding circuit design, displayer selection. The software design of the control system includes the main interface, parameter setting interface, and operation display interface, impulse computation for arbitrary winding turns, and speed adjustment computation. Experiment proves that the control system is stable and satisfies the requirement of winding operation on special motor.

[1]  Zhang Xu,et al.  Research on Spindle Drive Control System of High Speed Winding Machine , 2007, 2007 8th International Conference on Electronic Measurement and Instruments.

[2]  G. Huth.  Permanent-magnet-excited AC servo motors in tooth-coil technology , 2005, IEEE Transactions on Energy Conversion.

[3]  S. Katsura,et al.  Robust High Speed Position Servo System Considering Current & Voltage Limitation and Load Inertia Variation , 2007, IECON 2007 - 33rd Annual Conference of the IEEE Industrial Electronics Society.

[4]  Ned Mohan,et al.  On the Causes of Circulating Currents in PWM Drives With Open-End Winding AC Machines , 2013, IEEE Transactions on Industrial Electronics.

[5]  Selin Aviyente,et al.  The Effect of Failure Prognosis and Mitigation on the Reliability of Permanent-Magnet AC Motor Drives , 2013, IEEE Transactions on Industrial Electronics.

[6]  Haihong Qin,et al.  Optimization design of current loop for permanent magnet synchronous servo system , 2012, 2012 Asia-Pacific Symposium on Electromagnetic Compatibility.

[7]  Seung-Ki Sul,et al.  Control of an Open-Winding Machine in a Grid-Connected Distributed Generation System , 2008, IEEE Transactions on Industry Applications.

[8]  Deli Jia,et al.  Research and Development on Control System of Winding Machine for FRP Sand-filling Pipes , 2006, 2006 6th World Congress on Intelligent Control and Automation.

[9]  F. Nuno,et al.  Development of a deceleration control system for a winding machine based on a microcontroller , 2000, Conference Record of the 2000 IEEE Industry Applications Conference. Thirty-Fifth IAS Annual Meeting and World Conference on Industrial Applications of Electrical Energy (Cat. No.00CH37129).

[10]  Mengxiong Zeng,et al.  Designing and tuning current loop on AC servo system base on PMSM , 2011, 2011 Second International Conference on Mechanic Automation and Control Engineering.

[11]  Ned Mohan,et al.  Direct-Matrix-Converter-Based Drive for a Three-Phase Open-End-Winding AC Machine With Advanced Features , 2010, IEEE Transactions on Industrial Electronics.