Rock Slope Stability Evaluation in a Steep-Walled Canyon: Application to Elevator Construction in the Yunlong River Valley, Enshi, China

AbstractA passenger elevator is to be built on a nearly vertical slope in the National Geological Park in Enshi, Hubei province, China. Three steps comprise the construction: excavating the slope toe for the elevator platform, building the elevator on the platform, and affixing the elevator to the slope using anchors. To evaluate the rock slope stability in the elevator area and the safety of the elevator construction, we applied three techniques: qualitative analysis, formula calculation, and numerical simulation methods, based on field investigation and parameter selection, and considering both wet and dry conditions, pre- and post-construction. Qualitative stability factors for sliding and falling were calculated using the limit equilibrium method; the results show that the slope as a whole is stable, with a few unstable blocks, notably block BT1. Formula-based stability factors were calculated for four sections on block BT1, revealing the following: anchors will decrease the stability of certain rock pieces; the lowest average stability factor after anchoring will be Kf = 1.36 in wet conditions; block BT1 should be reinforced during elevator construction, up to a first-class slope stability factor of Kf = 1.40; and the slope as a whole is stable. Numerical simulation using FLAC3D indicated that the stress distribution will reach equilibrium for all steps before and after construction, and that the factor of safety (FOS) is within the general slope safety range (FOS > 1.05). We suggest that unstable pieces in block BT1 be reinforced during construction to a first-class slope safety range (FOS > 1.3), and that deformation monitoring on the slope surface be implemented.