Surface Modification of Poly(propylene) Microporous Membrane to Improve Its Antifouling Characteristics in an SMBR: O2 Plasma Treatment

Fouling is the major obstacle in membrane processes applied in water and wastewater treatment. To improve the antifouling characteristics of PPHFMMs in an SMBR for wastewater treatment, the PPHFMMs were surface-modified by O 2 low temperature plasma treatment. Structural and morphological changes on the membrane surface were characterized by XPS and FE-SEM. The change of surface wettability was monitored by contact angle measurements. Results of XPS clearly indicated that the plasma treatment introduced oxygen containing polar groups on the membrane surface. The static water contact angle of the modified membrane reduced obviously with the increase of plasma treatment time. The relative pure water flux for the modified membranes increased with plasma treatment time up to 1 min, then it decreased with further increase of plasma treatment time. Decreases in the tensile strength and the tensile elongation at break of the modified membranes were also observed. To assess the relation between the plasma treatment and the membrane fouling in an SMBR, filtration for activated sludge was carried out by using synthetic wastewater. After continuous operation in the SMBR for about 75 h, flux recovery were 8.7 and 12.3%, reduction of flux were 91.6 and 87.4% for the nascent and O 2 plasma treated PPHFMM for 1 min, relative flux ratio for O 2 plasma treated PPHFMM for 1 min was 49.9% higher than that of the nascent PPHFMM.

[1]  M. Ulbricht,et al.  Ultrafiltration membrane surfaces with grafted polymer 'tentacles': preparation, characterization and application for covalent protein binding. , 1998, Biomaterials.

[2]  V. M. Elinson,et al.  SURFACE MODIFICATION OF POLY(ETHYLENE TEREPHTHALATE) TRACK MEMBRANES IN ANALLYL ALCOHOL PLASMA , 1998 .

[3]  G. Belfort,et al.  Surface modification of poly(ether sulfone) ultrafiltration membranes by low-temperature plasma-induced graft polymerization , 1999 .

[4]  I. Gancarz,et al.  Modification of polysulfone membranes 1. CO2 plasma treatment , 1999 .

[5]  Chettiyappan Visvanathan,et al.  Membrane Separation Bioreactors for Wastewater Treatment , 2000 .

[6]  J. Kaloustian,et al.  Polypropylene natural aging studied by X-ray photoelectron spectroscopy , 2000 .

[7]  Vinod T. Kuberkar,et al.  Modeling of fouling reduction by secondary membranes , 2000 .

[8]  I. Gancarz,et al.  Modification of polysulfone membranes: 3. effect of nitrogen plasma , 2000 .

[9]  Sung Soo Kim,et al.  Surface modification of polypropylene membrane by low-temperature plasma treatment , 2001 .

[10]  Y. Lee,et al.  Surface modification of polypropylene membranes by γ-ray induced graft copolymerization and their solute permeation characteristics , 2001 .

[11]  David G. Castner,et al.  Low temperature plasma treatment of asymmetric polysulfone membranes for permanent hydrophilic surface modification , 2001 .

[12]  G Amy,et al.  Cleaning strategies for flux recovery of an ultrafiltration membrane fouled by natural organic matter. , 2001, Water research.

[13]  J. Feijen,et al.  Tailoring the properties of asymmetric cellulose acetate membranes by gas plasma etching. , 2002, Journal of colloid and interface science.

[14]  Kun-Hong Lee,et al.  Surface modification of polysulfone ultrafiltration membrane by oxygen plasma treatment , 2002 .

[15]  K. L. Tan,et al.  Plasma-induced immobilization of poly(ethylene glycol) onto poly(vinylidene fluoride) microporous membrane , 2002 .

[16]  I. Gancarz,et al.  Modification of polysulfone membranes. 4. Ammonia plasma treatment , 2002 .

[17]  G. Belfort,et al.  Increasing membrane permeability of UV-modified poly(ether sulfone) ultrafiltration membranes , 2002 .

[18]  Michelle L. Steen,et al.  Hydrophilic modification of polymeric membranes by low temperature H2O plasma treatment , 2002 .

[19]  E. R. Fisher,et al.  Hydrophilic modification of polyethersulfone membranes by low temperature plasma-induced graft polymerization , 2002 .

[20]  R M Ben Aim,et al.  Membrane bioreactors for wastewater treatment and reuse: a success story. , 2003, Water science and technology : a journal of the International Association on Water Pollution Research.

[21]  Jiding Li,et al.  Nanofiltration membrane prepared from polyacrylonitrile ultrafiltration membrane by low-temperature plasma: I. Graft of acrylic acid in gas , 2004 .

[22]  F. Ding,et al.  Modification of a Membrane Surface Charge by a Low Temperature Plasma Induced Grafting Reaction and Its Application to Reduce Membrane Fouling , 2004 .

[23]  S. H. Kim,et al.  Effects of surface modification of the membrane in the ultrafiltration of waste water , 2004 .

[24]  S. Teoh,et al.  Surface modification of ultra thin poly (ε-caprolactone) films using acrylic acid and collagen , 2004 .

[25]  D. J. Upadhyay,et al.  Pervaporation studies of gaseous plasma treated PVA membrane , 2004 .

[26]  I. Gancarz,et al.  Microwave plasma in preparation of new membranes , 2004 .

[27]  M. Mänttäri,et al.  Modification of NF membrane properties by in situ redox initiated graft polymerization with hydrophilic monomers , 2004 .

[28]  G. Poletti,et al.  Wettability and Dyeability Modulation of Poly(ethylene terephthalate) Fibers through Cold SF6 Plasma Treatment , 2005 .

[29]  J. Lai,et al.  Surface grafting polymerization and modification on poly(tetrafluoroethylene) films by means of ozone treatment , 2005 .

[30]  E. R. Fisher,et al.  Modification of polysulfone ultrafiltration membranes by CO2 plasma treatment , 2005 .

[31]  Zhi-Kang Xu,et al.  Surface modification of polypropylene microporous membrane to improve its antifouling property in MBR: CO2 plasma treatment , 2005 .

[32]  Zhi-Kang Xu,et al.  Improvement of Surface Properties of Poly(propylene) Hollow Fiber Microporous Membranes by Plasma‐Induced Tethering of Sugar Moieties , 2005 .

[33]  Oluwaseun O. Ogunbiyi,et al.  Methods Employed for Control of Fouling in MF and UF Membranes: A Comprehensive Review , 2005 .

[34]  Shuko Suzuki,et al.  In vitro bioactivity of MOEP grafted ePTFE membranes for craniofacial applications. , 2005, Biomaterials.

[35]  Zhi‐Kang Xu,et al.  Surface modification of polypropylene microporous membranes with a novel glycopolymer , 2005 .

[36]  Bo Zhang,et al.  High-concentration food wastewater treatment by an anaerobic membrane bioreactor. , 2005, Water research.

[37]  Kristen R. Kull,et al.  Surface modification with nitrogen-containing plasmas to produce hydrophilic, low-fouling membranes , 2005 .

[38]  David F. Fletcher,et al.  Fouling Control in a Submerged Flat Sheet Membrane System: Part II—Two‐Phase Flow Characterization and CFD Simulations , 2006 .

[39]  Seoktae Kang,et al.  Mitigated membrane fouling in a vertical submerged membrane bioreactor (VSMBR) , 2006 .

[40]  Zhi-Kang Xu,et al.  Flux enhancement for polypropylene microporous membrane in a SMBR by the immobilization of poly(N-vinyl-2-pyrrolidone) on the membrane surface , 2006 .

[41]  N. V. Ndinisa,et al.  Fouling Control in a Submerged Flat Sheet Membrane System: Part I – Bubbling and Hydrodynamic Effects , 2006 .

[42]  K. Yasuda,et al.  Polymerization of Acrylic Acid on Expanded Poly(tetrafluoroethylene) Tube by APGD Plasma Treatment , 2006 .

[43]  Sung-Woon Myung,et al.  Comparison of the surface characteristics of polypropylene films treated by Ar and mixed gas (Ar/O2) atmospheric pressure plasma. , 2006, Journal of colloid and interface science.

[44]  Yoshimasa Watanabe,et al.  Difference in membrane fouling in membrane bioreactors (MBRs) caused by membrane polymer materials , 2006 .

[45]  S. Chae,et al.  Development of an innovative vertical submerged membrane bioreactor (VSMBR) for simultaneous removal of organic matter and nutrients. , 2006, Water research.

[46]  Rong Wang,et al.  Development of a novel electrophoresis-UV grafting technique to modify PES UF membranes used for NOM removal , 2006 .

[47]  P. Favia,et al.  Tuning the Acid/Base Surface Character of Carbonaceous Materials by Means of Cold Plasma Treatments , 2006 .

[48]  J. Lai,et al.  Hydrophilic surface-grafted poly(tetrafluoroethylene) membranes using in pervaporation dehydration processes , 2006 .

[49]  Anthony G. Fane,et al.  Operation of Membrane Bioreactor with Powdered Activated Carbon Addition , 2006 .