0.5 V and 0.43 pJ/bit Capacitive Sensor Interface for Passive Wireless Sensor Systems

This paper presents an ultra low-power and low-voltage pulse-width modulation based ratiometric capacitive sensor interface. The interface was designed and fabricated in a standard 90 nm CMOS 1P9M technology. The measurements show an effective resolution of 10 bits using 0.5 V of supply voltage. The active occupied area is only 0.0045 mm2 and the Figure of Merit (FOM), which takes into account the energy required per conversion bit, is 0.43 pJ/bit. Furthermore, the results show low sensitivity to PVT variations due to the proposed ratiometric architecture. In addition, the sensor interface was connected to a commercial pressure transducer and the measurements of the resulting complete pressure sensor show a FOM of 0.226 pJ/bit with an effective linear resolution of 7.64 bits. The results validate the use of the proposed interface as part of a pressure sensor, and its low-power and low-voltage characteristics make it suitable for wireless sensor networks and low power consumer electronics.

[1]  Gerard C. M. Meijer,et al.  An Energy-Efficient 15-Bit Capacitive-Sensor Interface Based on Period Modulation , 2012, IEEE Journal of Solid-State Circuits.

[2]  Georges G. E. Gielen,et al.  A fully-digital, 0.3V, 270 nW capacitive sensor interface without external references , 2011, 2011 Proceedings of the ESSCIRC (ESSCIRC).

[3]  Suhwan Kim,et al.  A Delta–Sigma Interface Circuit for Capacitive Sensors With an Automatically Calibrated Zero Point , 2011, IEEE Transactions on Circuits and Systems II: Express Briefs.

[4]  David Blaauw,et al.  12.6 A 160nW 63.9fJ/conversion-step capacitance-to-digital converter for ultra-low-power wireless sensor nodes , 2014, 2014 IEEE International Solid-State Circuits Conference Digest of Technical Papers (ISSCC).

[5]  Roc Berenguer,et al.  A 0.6V and 0.53µW nonius TDC for a passive UHF RFID pressure sensor tag , 2012, 2012 IEEE International Conference on RFID-Technologies and Applications (RFID-TA).

[6]  P. Bruschi,et al.  A low-power capacitance to pulse width converter for MEMS interfacing , 2008, ESSCIRC 2008 - 34th European Solid-State Circuits Conference.

[7]  Mohamad Sawan,et al.  A very-high output impedance current mirror for very-low voltage biomedical analog circuits , 2008, APCCAS 2008 - 2008 IEEE Asia Pacific Conference on Circuits and Systems.

[8]  Jean Gaubert,et al.  Modeling and Design of CMOS UHF Voltage Multiplier for RFID in an EEPROM Compatible Process , 2007, IEEE Transactions on Circuits and Systems II: Express Briefs.

[9]  Wei-Hung Hsu,et al.  A Capacitance-Ratio-Modulated Current Front-End Circuit With Pulsewidth Modulation Output for a Capacitive Sensor Interface , 2012, IEEE Transactions on Instrumentation and Measurement.

[10]  Youngcheol Chae,et al.  A 1.8V 11μW CMOS smart humidity sensor for RFID sensing applications , 2011, IEEE Asian Solid-State Circuits Conference 2011.