Analysis of Long-Term Anisotropic Convergence in Drifts Excavated in Callovo-Oxfordian Claystone

The main purpose of this paper is to analyze the convergence measurements in drifts of the Underground Research Laboratory (URL) of the French National Radioactive Waste Management Agency (Andra), excavated in Callovo-Oxfordian claystone. These measurements show an anisotropic closure, which depends on the drift orientations with respect to the horizontal in situ stresses. This anisotropic character of the deformation is taken into account by assuming that the drifts section evolves following an elliptical shape. The characteristics of the deformed elliptical section are evaluated following the methodology proposed by Vu et al. (Rock Mech Rock Eng 46:231–246, 2013). Then, using the semi-empirical law proposed by Sulem et al. (Int J Rock Mech Min Sci Geomech Abstr 24:145–154, 1987), the convergence evolution is fitted independently for each axis of the ellipse. This method allows to distinguish two effects: the face advance and the time-dependent behavior of the ground. The results for the two drift orientations (along the major horizontal stress and perpendicular to it) show very close values for the parameters describing the time-dependent properties of the ground, the distance of influence of the face, and the extent of the decompressed zone around the drift. Finally, the model is validated by keeping these parameters as constants and by simulating the convergence data on a new drift. It is shown that with a period of about 40 days of convergence monitoring, the model can provide valuable insights for predictions of the convergence evolution in the long term.

[1]  G. Armand,et al.  Geometry and Properties of the Excavation-Induced Fractures at the Meuse/Haute-Marne URL Drifts , 2013, Rock Mechanics and Rock Engineering.

[2]  Jean Desroches,et al.  Complete in situ stress determination in an argillite sedimentary formation , 2007 .

[3]  Michel Tijani,et al.  New numerical modelling of the mechanical long-term behaviour of the GMR gallery in ANDRA’s Underground Research Laboratory , 2011 .

[4]  Gilles Armand,et al.  Making of the underground scientific experimental programme at the Meuse/Haute-Marne underground research laboratory, North Eastern France , 2007 .

[5]  Albert Giraud,et al.  Hydromechanical modelling of an excavation in an underground research laboratory with an elastoviscoplastic behaviour law and regularization by second gradient of dilation , 2013 .

[6]  M. Panet.  Two case histories of tunnels through squeezing rocks , 1996 .

[7]  J. Zghondi,et al.  Short- and long-term behaviors of drifts in the Callovo-Oxfordian claystone at the Meuse/Haute-Marne Underground Research Laboratory , 2013 .

[8]  The Manh Vu,et al.  Anisotropic Closure in Squeezing Rocks: The Example of Saint-Martin-la-Porte Access Gallery , 2013, Rock Mechanics and Rock Engineering.

[9]  G. Armand,et al.  Modeling the viscoplastic and damage behavior in deep argillaceous rocks , 2011 .

[10]  Patrick R. Steiner.  Displacement measurements ahead of a tunnel face using the RH Extensometer , 2007 .

[11]  F. Collin,et al.  Using Local Second Gradient Model and Shear Strain Localisation to Model the Excavation Damaged Zone in Unsaturated Claystone , 2015, Rock Mechanics and Rock Engineering.

[12]  F. Martin,et al.  Geotechnical Feedback of the New Galleries Excavation At the ANDRA Underground Research Laboratory - Bure (France) , 2010 .

[13]  Patrick Lebon,et al.  The excavation damaged zone in clay formations time-dependent behaviour and influence on performance assessment , 2007 .

[14]  Yingxin Zhou,et al.  Harmonising Rock Engineering and the Environment , 2011 .

[15]  M. Panet,et al.  Closure analysis in deep tunnels , 1987 .

[16]  Wulf Schubert.  The Development of the Observational Method , 2008 .

[17]  Mark S. Diederichs,et al.  Sensitivity Testing of the Newly Developed Elliptical Fitting Method for the Measurement of Convergence in Tunnels and Shafts , 2014, Rock Mechanics and Rock Engineering.