Suitability of coated conductors for fusion magnets in view of their radiation response

HTS coated conductors could replace Nb3Sn wires in future fusion power plants, where the superconductors are exposed to neutron radiation. The maximum neutron fluence a superconductor can sustain is an important criterion for its suitability for fusion magnets. We report on the change of the superconducting properties in HTS RABiTS based coated conductors following high fluence irradiation (up to 3.3 1022 m−2) in a research reactor, which is significantly higher than previously reported. The transition temperature decreases as a function of fluence by up to 8 K and the critical current, Ic, heavily degrades when the magnetic field is applied parallel to the tape surface. The critical currents exhibit a maximum in their fluence dependence for the perpendicular field orientation, which shifts to lower fluences at higher temperatures. The same behavior is found for the fluence where Ic falls below that of the pristine tape. This limits the operation conditions to low temperatures under the expected lifetime fluences in future fusion magnets.

[1]  David M. Buczek,et al.  Advances in second generation high temperature superconducting wire manufacturing and R&D at American Superconductor Corporation , 2009 .

[2]  R. Fuger,et al.  Influence of neutron irradiation on high temperature superconducting coated conductors , 2008 .

[3]  M. Chudy,et al.  Neutron irradiation of coated conductors , 2009, 0908.4175.

[4]  Wilfried Goldacker,et al.  Prospects of High Temperature Superconductors for fusion magnets and power applications , 2013 .

[5]  D. Parkin,et al.  Effect of Neutron Irradiation on the Critical Current of Nb3Sn at High Magnetic Fields , 1976 .

[6]  C. Scheuerlein,et al.  Effects of neutron irradiation on pinning force scaling in state-of-the-art Nb3Sn wires , 2013, 1311.6901.

[7]  F. Weiss,et al.  Changes in superconducting properties by room temperature neutron irradiation for binary and alloyed Nb 3 Sn multifilamentary wires , 1987 .

[8]  Wilfried Goldacker,et al.  Investigation of a Rutherford cable using coated conductor Roebel cables as strands , 2013 .

[9]  L. Greenwood,et al.  Neutron dosimetry and damage calculations for the TRIGA MARK-II reactor in Vienna , 1986 .

[10]  F. Sauerzopf Anisotropic flux pinning in YBa 2 Cu 3 O 7 − δ single crystals: The influence of defect size and density as determined from neutron irradiation , 1998 .

[11]  H. W. Weber,et al.  Stress dependence of the critical currents in neutron irradiated (RE)BCO coated conductors , 2013, 1301.4436.

[12]  Joseph V. Minervini,et al.  HTS twisted stacked-tape cable conductor , 2011 .

[13]  S. Sathyamurthy,et al.  Second Generation Wire Development at AMSC , 2013, IEEE Transactions on Applied Superconductivity.

[14]  K. Tanabe,et al.  Exploration of new superconductors and functional materials, and fabrication of superconducting tapes and wires of iron pnictides , 2015, Science and technology of advanced materials.

[15]  R. Wesche,et al.  Design and Strand Tests of a Fusion Cable Composed of Coated Conductor Tapes , 2014, IEEE Transactions on Applied Superconductivity.

[16]  Loren F. Goodrich,et al.  High-current dc power transmission in flexible RE–Ba2Cu3O7 − δ coated conductor cables , 2011 .

[17]  N. Mitchell,et al.  Reversible and irreversible mechanical effects in real cable-in-conduit conductors , 2013 .

[18]  H. Weber RADIATION EFFECTS ON SUPERCONDUCTING FUSION MAGNET COMPONENTS , 2011 .

[19]  Wilfried Goldacker,et al.  Status of high transport current ROEBEL assembled coated conductor cables , 2009 .

[20]  Pierluigi Bruzzone,et al.  High current superconductors for DEMO , 2013 .