Large strain actuation in polypyrrole actuators

A typical limitation of polypyrrole based conducting polymer actuators is the low achievable active linear strains (2 % recoverable at 10 MPa, 7 % max) that these active materials exhibit when activated in a common propylene carbonate / tetraethylammonium hexafluorophosphate electrolyte. Mammalian skeletal muscle, on the other hand, exhibits large recoverable linear strains on the order of 20%. Such large linear strains are desirable for applications in life-like robotics, artificial prostheses or medical devices. We report herein the measurement of recoverable linear strains in excess of 14 % at 2.5 MPa (20 % max) for polypyrrole activated in the 1-butyl-3-methyl imidazolium tetrafluoroborate liquid salt electrolyte. This advancement in conducting polymer actuator technology will impact many engineering fields, where a lightweight, large displacement actuator is needed. Benefits and trade offs of utilizing ionic liquid electrolytes for higher performance polypyrrole actuation are discussed.

[1]  Peter Sommer-Larsen,et al.  A Conducting Polymer Artificial Muscle with 12 % Linear Strain , 2003 .

[2]  M. Jiménez,et al.  Towards Synthetic Molecular Muscles: Contraction and Stretching of a Linear Rotaxane Dimer , 2000 .

[3]  Tsuneo Hagiwara,et al.  Memory effect of electrical conductivity upon the counteranion exchange of polypyrrole films , 1992 .

[4]  I. Hunter,et al.  Fast contracting polypyrrole actuators , 2000 .

[5]  John D. W. Madden,et al.  Conducting polymer actuators as engineering materials , 2002, SPIE Smart Structures and Materials + Nondestructive Evaluation and Health Monitoring.

[6]  Jie Ding,et al.  High performance conducting polymer actuators utilising a tubular geometry and helical wire interconnects , 2003 .

[7]  R. Baughman.  Conducting polymer artificial muscles , 1996 .

[8]  Ian W. Hunter,et al.  Polypyrrole actuators: modeling and performance , 2001, SPIE Smart Structures and Materials + Nondestructive Evaluation and Health Monitoring.

[9]  D. Rossi,et al.  Investigation of the applied potential limits for polypyrrole when employed as the active components of a two-electrode device , 2001 .

[10]  G. Wallace,et al.  Strain Response from Polypyrrole Actuators under Load , 2002 .

[11]  R. J. Reid,et al.  Toward Molecular Muscles: Design and Synthesis of an Electrically Conducting Poly[cyclooctatetrathiophene] , 1999 .

[12]  Q. Pei,et al.  Electrochemical applications of the bending beam method. 1. Mass transport and volume changes in polypyrrole during redox , 1992 .

[13]  E. Smela.  Conjugated Polymer Actuators for Biomedical Applications , 2003 .

[14]  I. Hunter,et al.  A comparison of muscle with artificial actuators , 1992, Technical Digest IEEE Solid-State Sensor and Actuator Workshop.

[15]  John David Wyndham Madden,et al.  Conducting polymer actuators , 2000 .

[16]  G. Wallace,et al.  Use of Ionic Liquids for π-Conjugated Polymer Electrochemical Devices , 2002, Science.

[17]  John D. W. Madden,et al.  Thiophene-based conducting polymer molecular actuators , 2002, SPIE Smart Structures and Materials + Nondestructive Evaluation and Health Monitoring.