论文信息 - Prediction of Chip Flow Direction and Cutting Forces in Oblique Machining with Nose Radius Tools

Prediction of Chip Flow Direction and Cutting Forces in Oblique Machining with Nose Radius Tools

A method is described for calculating the chip flow direction in terms of the tool cutting edge geometry and the cutting conditions, namely feed and depth of cut. By defining an equivalent cutting edge based on the chip flow direction it is then shown how cutting forces can be predicted given the work material's flow stress and thermal properties. A comparison between experimental results obtained from bar turning tests and predicted values for a wide range of tool geometries and cutting conditions shows good agreement.

[1] E. Usui,et al. Analytical Prediction of Three Dimensional Cutting Process—Part 2: Chip Formation and Cutting Force with Conventional Single-Point Tool , 1978 .

[2] P.L.B. Oxley,et al. Allowing for Nose Radius Effects in Predicting the Chip Flow Direction and Cutting Forces in Bar Turning , 1987 .

[3] Keiji Okushima,et al. On the Behavior of Chip in Steel Cutting , 1959 .

[4] P. Mathew,et al. Allowing for End Cutting Edge Effects in Predicting Forces in Bar Turning with Oblique Machining Conditions , 1986 .

[5] Keiji Okushima,et al. On the Behaviour of Chip at Steel Cutting , 1958 .

[6] R. M. Stewart,et al. Detection of Rolling Element Bearing Damage by Statistical Vibration Analysis , 1978 .

[7] P. Mathew,et al. Predicting the chip flow for nose radius tools under oblique machining conditions , 1993 .

[8] P Mathew,et al. Predicting Cutting Forces for Oblique Machining Conditions , 1982 .

[9] E. Usui,et al. Analytical Prediction of Three Dimensional Cutting Process , 1978 .

[10] M. C. Shaw,et al. Mechanics of Machining: An Analytical Approach to Assessing Machinability , 1989 .

[11] R. L. Bielawa,et al. An Analytic Study of the Energy Dissipation of Turbomachinery Bladed-Disk Assemblies Due to Inter-Shroud Segment Rubbing , 1978 .