Recovery of 1-butanol from aqueous solutions using zeolite ZSM-5 with a high Si/Al ratio; suitability of a column process for industrial applications

Abstract Commercially available zeolites (CBV28014, CBV901) with a high Si/Al ratio were tested as adsorbents to recover 1-butanol from aqueous solutions such as acetone–butanol–ethanol (ABE) fermentation broth. It was found that these zeolites can quickly and almost completely adsorb 1-butanol from aqueous solutions containing ∼1 wt% of 1-butanol. The binding capacity of the zeolites appeared to be around 0.12 g 1-butanol/g zeolite, and remained constant till equilibrium concentration as low as 0.04 wt% 1-butanol in water. Extrudates were prepared and tested in a column set-up to get an impression of the suitability of these zeolites for industrial applications. Extrudates of 80% zeolite and 20% alumina binder with 16–24 mesh (0.7–1.0 mm) size showed the best adsorption results in a packed bed column with up-flow of ABE broth. The adsorbent loading at 10% breakthrough was calculated to be 0.085 g 1-butanol/g zeolite (9.3 min residence time). A subsequent temperature swing leads to desorption. By choosing the temperature program carefully, it was possible to separate the water/ethanol/acetone and 1-butanol fractions. The resulting 1-butanol concentration in the 1-butanol fraction was 84.3 wt% and thus a concentration factor of 65 was achieved in one step, which is a higher value compared to other isolation techniques. Only 80% of adsorbed 1-butanol could be recovered, the remainder could only be desorbed at higher temperatures as butene. However, this should not be a problem in an industrial process as all stronger binding, catalytic sites will be blocked after the first adsorption/desorption round. A mathematical model was developed to simulate the breakthrough data and a mass transfer coefficient (kpa) of 0.052 min−1 was obtained. Comparison of simulated kpa for different sizes of extrudates clearly indicated that the adsorption rate is determined by solid phase diffusion.

[1]  Ashwani Kumar,et al.  Separation of 1-butanol/2,3-butanediol using ZSM-5 zeolite-filled polydimethylsiloxane membranes , 2009 .

[2]  K. Schügerl.  Integrated processing of biotechnology products. , 2000, Biotechnology advances.

[3]  N. Qureshi,et al.  United States Patent: SILICALITE MEMBRANE AND METHOD FOR THE SELECTIVE RECOVERY AND CONCENTRATION OF ACETONE AND BUTANOL FROM MODEL ABE SOLUTIONS AND FERMENTATION BROTH , 1998 .

[4]  Samuel D. Conte,et al.  Elementary Numerical Analysis , 1980 .

[5]  I. Maddox,et al.  The acetone-butanol-ethanol fermentation: recent progress in technology. , 1989, Biotechnology & genetic engineering reviews.

[6]  D. Nielsen,et al.  In situ product recovery of n‐butanol using polymeric resins , 2009, Biotechnology and bioengineering.

[7]  K. Ch. A. M. Luyben,et al.  Technologies for butanol recovery integrated with fermentations , 1992 .

[8]  Neil B. Milestone,et al.  Concentration of alcohols by adsorption on silicalite , 2007 .

[9]  Neil B. Milestone,et al.  Concentration of alcohols by adsorption on silicalite: Alcohol concentration by adsorption , 1981 .

[10]  T. Ezeji,et al.  Production of acetone butanol (AB) from liquefied corn starch, a commercial substrate, using Clostridium beijerinckii coupled with product recovery by gas stripping , 2007, Journal of Industrial Microbiology & Biotechnology.

[11]  T. Todd,et al.  Determination of a Solid Phase Mass Transfer Coefficient for Modeling an Adsorption Bed System Using Ammonium Molybdophosphate-Polyacrylonitrile (AMP-PAN) as a Sorbent for the Removal of 137Cs from Acidic Nuclear Waste Solutions , 2002 .

[12]  C. Wen,et al.  Longitudinal dispersion of liquid flowing through fixed and fluidized beds , 1968 .

[13]  Anton Friedl,et al.  Application of Continuous Substrate Feeding to the ABE Fermentation: Relief of Product Inhibition Using Extraction, Perstraction, Stripping, and Pervaporation , 1992 .

[14]  F. Helfferich,et al.  Mass transfer and kinetics of ion exchange , 1983 .

[15]  Leland M. Vane,et al.  Separation technologies for the recovery and dehydration of alcohols from fermentation broths , 2008 .

[16]  M. Holtzapple,et al.  Conceptual design for a process to recover volatile solutes from aqueous solutions using silicalite , 1994 .

[17]  Adrie J. J. Straathof,et al.  Assessment of Options for Selective 1-Butanol Recovery from Aqueous Solution , 2009 .

[18]  Leland M. Vane,et al.  A review of pervaporation for product recovery from biomass fermentation processes , 2005 .

[19]  A. G. Fadeev,et al.  Opportunities for ionic liquids in recovery of biofuels , 2001 .

[20]  Leo Petrus,et al.  Biomass to biofuels, a chemical perspective , 2006 .

[21]  N. Qureshi,et al.  Energy-efficient recovery of butanol from model solutions and fermentation broth by adsorption , 2005, Bioprocess and biosystems engineering.