Chemical sensors based on temperature-responsive hydrogels

Temperature responsive hydrogels show a strong ability to change their swelling degree in dependence on organic solvent or salt concentration in aqueous solutions. This behavior can be used for appropriate sensors if a suitable transducer transforms the volume change into an electrical output signal. In the present work, piezoresistive sensors were used where the hydrogel led to a deflection of a silicon membrane within the sensor chip. This principle allows for a strict separation of the fluid from the piezoresistors as well as from other electronic components at the front side of the sensor chip. Poly(N-isopropylacrylamide) (PNIPAAm) as well as photo cross-linkable poly(N-isopropylacrylamide-co-dimethyl-acrylamide-co-2-(dimethyl maleimido)-N-ethyl-acrylamide) (PNIPAAm-DMAAm-DMIAAm) terpolymer have been applied and investigated for organic solvent concentration sensors and salt concentration sensors. The sensor's output voltage was measured during the swelling of the hydrogel under influence of water solutions with different organic and inorganic solute concentrations at different temperatures. A complex "reentrant" swelling behavior of the hydrogel in mixed co-solvents as well as "salting in" and "salting out" effects of different salts were studied. It was found that the change in the gel volume phase transition temperature depends on the solution viscosity and the concentration of the additive affecting the stiffness of the polymer chain in the surrounding solution. The influence of an initial gel conditioning procedure on the signal value and the sensitivity of the proposed chemical sensors was investigated and the measurement conditions necessary for high signal reproducibility and long-term stability were determined.

[1]  C. Frank,et al.  Photo-Cross-Linkable PNIPAAm Copolymers. 1. Synthesis and Characterization of Constrained Temperature-Responsive Hydrogel Layers , 2002 .

[2]  C. Frank,et al.  Photo-Cross-Linkable PNIPAAm Copolymers. 5. Mechanical Properties of Hydrogel Layers , 2003 .

[3]  P Bergveld,et al.  Study of chemically induced pressure generation of hydrogels under isochoric conditions using a microfabricated device. , 2004, The Journal of chemical physics.

[4]  W. Seitz,et al.  Chemical modulation of thermosensitive poly(N-isopropylacrylamide) microsphere swelling: a new strategy for chemical sensing , 2005 .

[5]  D. Kuckling,et al.  Multisensitive polymers based on 2‐vinylpyridine and N‐isopropylacrylamide * , 2001 .

[6]  H. Adler,et al.  Temperature sensitive polymers based on 2-(dimethyl maleinimido)-N-ethyl-acrylamide: Copolymers with N-isopropylacrylamide , 2000 .

[7]  Kangsheng Chen,et al.  Demonstration of etched cladding fiber Bragg grating-based sensors with hydrogel coating , 2003 .

[8]  N. Kruse,et al.  The Influence of Crosslinking Density to the Elastic Properties of ‘Smart’ Polymers: A Scanning Force and Scanning Electron Microscopy Study , 2003, Microscopy and Microanalysis.

[9]  Kangsheng Chen,et al.  Fiber optic Bragg grating sensor based on hydrogels for measuring salinity , 2002 .

[10]  O. Okay,et al.  Reentrant conformation transition in poly(N,N-dimethylacrylamide) hydrogels in water–organic solvent mixtures , 2006 .

[11]  C. V. Chaudhari,et al.  Radiation induced synthesis and swelling characterization of thermo-responsive N-isopropylacrylamide-co-ionic hydrogels , 2006 .

[12]  Andreas Richter,et al.  Application of sensitive hydrogels in flow control , 2000 .

[13]  G. Pharr,et al.  An improved technique for determining hardness and elastic modulus using load and displacement sensing indentation experiments , 1992 .

[14]  Andreas Richter,et al.  Influence of volume phase transition phenomena on the behavior of hydrogel-based valves , 2004 .

[16]  G. Gerlach,et al.  Chemical and pH sensors based on the swelling behavior of hydrogels , 2005 .

[17]  J. Miller,et al.  Water structure in aqueous solutions of alkali halide salts: FTIR spectroscopy of the OD stretching band. , 2005, Journal of colloid and interface science.

[18]  Oguz H. Elibol,et al.  Micromechanical cantilever as an ultrasensitive pH microsensor , 2002 .

[19]  Andreas Richter,et al.  Temperature and ph-dependent swelling behavior of poly(N-isopropylacrylamide) copolymer hydrogels and their use in flow control , 2003 .

[20]  Margarita Guenther,et al.  pH sensors based on polyelectrolytic hydrogels , 2005, SPIE Smart Structures and Materials + Nondestructive Evaluation and Health Monitoring.

[21]  Thomas Wallmersperger,et al.  Coupled chemo-electro-mechanical formulation for ionic polymer gels––numerical and experimental investigations , 2004 .

[22]  Margarita Guenther,et al.  Application of sensitive hydrogels in chemical and pH sensors , 2004 .

[23]  S. Saito,et al.  Volume phase transition of N-alkylacrylamide gels , 1993 .

[24]  Andreas Richter,et al.  Electronically controllable microvalves based on smart hydrogels: magnitudes and potential applications , 2003 .

[25]  A. Richter,et al.  Approaches of quantifying the entire load–depth curve in terms of hardness , 2003 .

[26]  M. Plötner,et al.  Photopatterning of thermally sensitive hydrogels useful for microactuators , 1999 .

[27]  Ruth Freitag,et al.  Influence of the synthesis conditions and ionic additives on the swelling behaviour of thermo-responsive polyalkylacrylamide hydrogels , 2005 .

[28]  Andreas Richter,et al.  Characterization of a microgravimetric sensor based on pH sensitive hydrogels , 2004 .

[29]  G. Demirel,et al.  Thermosensitive poly(N-isopropylacrylamide-co-acrylamide) hydrogels: Synthesis, swelling and interaction with ionic surfactants , 2006 .

[30]  Karl-Friedrich Arndt,et al.  Photo cross-linkable poly(N-isopropylacrylamide) copolymers III: micro-fabricated temperature responsive hydrogels , 2003 .

[31]  D. Kuckling,et al.  Synthesis of transition‐metal‐ion‐selective poly(N‐isopropylacrylamide) hydrogels by the incorporation of an Aza crown ether , 2003 .