Development of a small vehicular PEM fuel cell system

Abstract This paper reports the development of components in a stack assembly and measurements of electrochemical characteristics of a proton exchange membrane (PEM) fuel cell stack. A novel test fixture together with a superposition approach is utilized to assess the Ohmic resistance across the stack. Then, a Tafel-kinetic equation for describing the voltage and current curve for all processes including electrode activation, Ohmic resistance and mass transfer was reported. It was found that the Ohmic resistance inside the fuel cell stack was markedly impacted by clamping torque of the stack. An optimum clamping torque of 90 kgf cm was determined based on measured Ohmic resistance. Uniformity and stability in the stack was verified by measuring cell voltage and temperature distribution. Finally, stack durability was tested by impelling a buggy over a relatively long duration.

[1]  Lin Wang,et al.  A parametric study of PEM fuel cell performances , 2003 .

[2]  Ching-Han Huang,et al.  Analyses of the fuel cell stack assembly pressure , 2005 .

[3]  Jenn-Jiang Hwang,et al.  Parametric studies of a double-cell stack of PEMFC using Grafoil™ flow-field plates , 2002 .

[4]  Jenn-Jiang Hwang,et al.  Effect of clamping pressure on the performance of a PEM fuel cell , 2007 .

[5]  Jenn-Jiang Hwang,et al.  Modeling of two-phase temperatures in a two-layer porous cathode of polymer electrolyte fuel cells , 2007 .

[6]  Hongtan Liu,et al.  A parametric study of the cathode catalyst layer of PEM fuel cells using a pseudo-homogeneous model , 2001 .

[7]  Vladimir Fateev,et al.  Transfer processes in PEM fuel cell: Influence of electrode structure , 2006 .

[8]  Jenn-Jiang Hwang,et al.  A three-dimensional numerical simulation of the transport phenomena in the cathodic side of a PEMFC , 2004 .

[9]  Ay Su,et al.  Optimization of gas diffusion media for elevated temperature polymer electrolyte fuel cells , 2007 .

[10]  Ranga Pitchumani,et al.  Analysis and design of PEM fuel cells , 2005 .

[11]  Jenn-Jiang Hwang,et al.  Development of a lightweight fuel cell vehicle , 2005 .

[12]  Ching-Han Huang,et al.  Stainless steel bipolar plates , 2005 .

[13]  Nigel P. Brandon,et al.  Measurement and modelling of carbon monoxide poisoning distribution within a polymer electrolyte fuel cell , 2007 .

[14]  Jenn-Jiang Hwang,et al.  Heat/mass transfer in porous electrodes of fuel cells , 2006 .

[15]  R. Pitchumani,et al.  MEASUREMENT AND PREDICTION OF ELECTRICAL CONTACT RESISTANCE BETWEEN GAS DIFFUSION LAYERS AND BIPOLAR PLATE FOR APPLICATIONS TO PEM FUEL CELLS , 2004 .

[16]  J. C. Amphlett,et al.  A model predicting transient responses of proton exchange membrane fuel cells , 1996 .

[17]  Chengwei Wu,et al.  Contact resistance prediction and structure optimization of bipolar plates , 2006 .

[18]  Jenn-Jiang Hwang.  Heat Transfer in a Porous Electrode of Fuel Cells , 2006 .

[19]  Jenn-Jiang Hwang,et al.  Measurement of interstitial convective heat transfer and frictional drag for flow across metal foams , 2002 .