Multi-frequency identification method in signal processing

Virtually vibration signals are always composed of many frequency components. Using the least squares method, a new multi-frequency identification algorithm has been proposed to identify the amplitude and phase of each component of a multi-frequency signal, and it will work well as long as the main frequency values are known. Based on this algorithm, two similar optimization procedures have been presented to obtain accurate frequency values for a sine-wave signal and a bi-tone signal, respectively. Assisted with band-pass filters and these optimization procedures, the multi-frequency identification algorithm can successfully identify the multi-frequency components of a signal. The multi-frequency identification method can be used to identify oil-film coefficients of journal bearing. And some reliable oil-film coefficients have been reached.

[1]  Ignacio Santamaria,et al.  A COMPARATIVE STUDY OF HIGH-ACCURACY FREQUENCY ESTIMATION METHODS , 2000 .

[2]  Sun Yi,et al.  On the non-linear dynamic behavior of a rotor–bearing system , 2004 .

[3]  Sophocles J. Orfanidis,et al.  Introduction to signal processing , 1995 .

[4]  Anh Kiet Tieu,et al.  The Effect of Perturbation Amplitudes on Eight Force Coefficients of Journal Bearings , 1996 .

[5]  H. Ding,et al.  Phase regression approach for estimating the parameters of a noisy multifrequency signal , 2004 .

[6]  A. Cruz Serra,et al.  New methods to improve convergence of sine fitting algorithms , 2003, Comput. Stand. Interfaces.

[7]  Dario Petri,et al.  Interpolation techniques for real-time multifrequency waveform analysis , 1989 .

[8]  She-Xu Zhao,et al.  Experimental identification of linear oil-film coefficients using least-mean-square method in time domain , 2005 .

[9]  Han-Xiong Li,et al.  High accuracy estimation of multi-frequency signal parameters by improved phase linear regression , 2007, Signal Process..

[10]  R. D. Flack,et al.  Accuracy evaluation of experimentally derived dynamic coefficients of fluid film bearings. I: Development of method , 1990 .

[11]  Sanxing Zhao,et al.  Stability and response analysis of symmetrical single-disk flexible rotor-bearing system , 2005 .

[12]  Sabine Van Huffel,et al.  Overview of total least-squares methods , 2007, Signal Process..

[13]  Guang Meng,et al.  On the oil-whipping of a rotor-bearing system by a continuum model , 2005 .

[14]  Yuh-Tay Sheen,et al.  An analysis method for the vibration signal with amplitude modulation in a bearing system , 2007 .