An in-line Mach-Zehnder Interferometer Using Thin-core Fiber for Ammonia Gas Sensing With High Sensitivity

Ammonia is an important indicator among environmental monitoring parameters. In this work, thin-core fiber Mach-Zehnder interferometer deposited with poly (acrylic acid) (PAA), poly (allyamine hydrochloride) (PAH) and single-walled carbon nanotubes (SWCNTs-COOH) sensing film for the detection of ammonia gas has been presented. The thin-core fiber modal interferometer was made by fusion splicing a small section of thin-core fiber (TCF) between two standard single mode fibers (SMF). A beam propagation method (BPM) is employed for the design of proposed interferometer and numerical simulation. Based on the simulation results, interferometer with a length of 2 cm of thin-core fiber is fabricated and experimentally studied. (PAH/PAA)2 + [PAH/(PAA + SWCNTs-COOH)]8 film is deposited on the outer surface of thin-core fiber via layer-by-layer (LbL) self-assembly technique. The gas sensor coated with (PAH/PAA)2 + [PAH/(PAA + SWCNTs-COOH)]8 film towards NH3 gas exposure at concentrations range from 1 to 960 ppm are analyzed and the sensing capability is demonstrated by optical spectrum analyzer (OSA). Experimental results show that the characteristic wavelength shift has an approximately linear relationship in the range 1–20 ppm, which is in accordance with the numerical simulation. Thus, this paper reveals the potential application of this sensor in monitoring low concentration NH3 gas.

[1]  A. Zhang,et al.  Fiber-optic refractive-index sensors based on transmissive and reflective thin-core fiber modal interferometers , 2010 .

[2]  F. Arregui,et al.  Sensitivity optimization of tapered optical fiber humidity sensors by means of tuning the thickness of nanostructured sensitive coatings , 2007 .

[3]  Sailing He,et al.  Optical fiber relative humidity sensor based on FBG incorporated thin-core fiber modal interferometer. , 2011, Optics express.

[4]  Ruohui Wang,et al.  Temperature-independent refractometer based on fiber-optic Fabry–Perot interferometer , 2016 .

[5]  Hydrostatic pressure sensor based on a gold-coated thin-core fiber modal interferometer and ripple shift measurement , 2012 .

[6]  Y. Wu,et al.  Partially reduced graphene oxide based FRET on fiber-optic interferometer for biochemical detection , 2017, 2017 25th Optical Fiber Sensors Conference (OFS).

[7]  Chuanyi Tao,et al.  Photonic crystal fiber in-line Mach-Zehnder interferometer for explosive detection. , 2016, Optics express.

[8]  Sailing He,et al.  Low-cost high-performance fiber-optic pH sensor based on thin-core fiber modal interferometer. , 2009, Optics express.

[9]  Ultrasensitive Temperature Sensor Based on Refractive Index Liquid-Sealed Thin-Core Fiber Modal Interferometers , 2014, IEEE Sensors Journal.

[10]  Bobo Gu,et al.  A novel fast response fiber-optic pH sensor based on nanoporous self-assembled multilayer films , 2010 .

[11]  Yinian Zhu,et al.  Nanofilm-coated long-period fiber grating humidity sensors for corrosion detection in structural health monitoring , 2011, Smart Structures and Materials + Nondestructive Evaluation and Health Monitoring.

[12]  Deming Liu,et al.  Distributed fiber-optic vibration sensor using a ring Mach-Zehnder interferometer , 2008 .

[13]  Hiroyuki Sasaki,et al.  A humidity sensor based on a hetero-core optical fiber , 2010 .

[14]  Long Jin,et al.  High-birefringence microfiber Sagnac interferometer based humidity sensor , 2016 .

[15]  G. Hocker.  Fiber-optic sensing of pressure and temperature. , 1979, Applied optics.

[16]  Atsushi Seki,et al.  A hetero-core structured fiber optic pH sensor. , 2007, Analytica chimica acta.

[17]  Q. Sui,et al.  Optical fiber Fabry–Perot interferometer for microorganism growth detection , 2016 .

[18]  S. Ferrari,et al.  Author contributions , 2021 .

[19]  Youngjoo Chung,et al.  High temperature fiber sensor with high sensitivity based on core diameter mismatch. , 2008, Optics express.

[20]  Jianchun Yang,et al.  Photonic crystal fiber methane sensor based on modal interference with an ultraviolet curable fluoro-siloxane nano-film incorporating cryptophane A , 2016 .

[21]  F. H. Hashim,et al.  Analysing surface plasmon resonance phase sensor based on Mach-Zehnder interferometer technique using glycerin , 2016 .

[22]  Kazuhiro Watanabe,et al.  Macrobending Characteristics of a Hetero-Core Splice Fiber Optic Sensor for Displacement and Liquid Detection , 2000 .

[23]  Kai Ni,et al.  Refractometer based on a tapered Mach–Zehnder interferometer with Peanut-Shape structure , 2016 .

[24]  Yi-Fang Lin,et al.  Fiber-optic chemical and biochemical probes based on localized surface plasmon resonance , 2006 .

[25]  Yuliya Semenova,et al.  A comprehensive analysis verified by experiment of a refractometer based on an SMF28–small-core singlemode fiber (SCSMF)–SMF28 fiber structure , 2011 .

[26]  Ruohui Wang,et al.  High-Temperature Properties of a Thin-Core Fiber MZI With an Induced Refractive Index Modification , 2016, IEEE Photonics Technology Letters.

[27]  Hwa-Yaw Tam,et al.  The pore water pressure sensor based on Sagnac interferometer with polarization-maintaining photonic crystal fiber for the geotechnical engineering , 2016 .

[28]  Xueguang Qiao,et al.  High temperature probe sensor with high sensitivity based on Michelson interferometer , 2015 .

[29]  Yu-Lung Lo,et al.  Compensation of non-ideal beam splitter polarization distortion effect in Michelson interferometer , 2016 .

[30]  Christopher J. Barrett,et al.  pH-Dependent Loading and Release Behavior of Small Hydrophilic Molecules in Weak Polyelectrolyte Multilayer Films , 2004 .

[31]  Byeong Ha Lee,et al.  Ultracompact in-line broadband Mach-Zehnder interferometer using a composite leaky hollow-optical-fiber waveguide. , 2008, Optics letters.