论文信息 - Study on Dry Electrical Discharge Machining

Study on Dry Electrical Discharge Machining

In the paper are presented results of simulation and mathematical modelling of the material removal rate of electrodischarge milling process with compressed air as dielectric. There are also presented basic characteristic of the DEDM milling process and comparison of this green machining method with kerosene based EDM milling. Presented results refer to the experiments of micro machining with thick walled electrodes. There are described advantages and drawbacks of this machining method, especially in the field of micro-machining.

Grzegorz Skrabalak | Jerzy Kozak | G. Skrabalak | J. Kozak

[1] Jean-Pierre Kruth,et al. Sensing and compensation of tool wear in milling EDM , 2004 .

[2] T. Masuzawa,et al. Micro-EDM for Three-Dimensional Cavities - Development of Uniform Wear Method - , 1998 .

[3] Kamlakar P Rajurkar,et al. 3D Micro-EDM Using CAD/CAM , 2000 .

[4] I. Pashby,et al. A review on the use of environmentally-friendly dielectric fluids in electrical discharge machining , 2004 .

[5] Masanori Kunieda,et al. Advancing EDM through fundamental insight into the process , 2005 .

[6] Anju Vyas. Print , 2003 .

[7] Nobuhiro Nakajima,et al. High Speed 3D Milling by Dry EDM , 2003 .

[8] Kamlakar P Rajurkar,et al. Modelling and Simulation of Micro EDM Process , 2003 .

[9] Jean-Pierre Kruth,et al. Machining curvilinear surfaces by NC electro discharge machining , 2000 .

[10] John W. Sutherland,et al. Dry Machining and Minimum Quantity Lubrication , 2004 .

[11] Masanori Kunieda,et al. Electrical Discharge Machining in Gas , 1997 .

[12] M. Fujino,et al. Micro-EDM for Three-Dimensional Cavities , 2007 .

[13] Norliana Mohd Abbas,et al. A review on current research trends in electrical discharge machining (EDM) , 2007 .