Noise canceling LNA with gain enhancement by using double feedback

In this paper we present a balun low noise amplifier (LNA) in which the gain is boosted by using a double feedback structure. The circuit is based on a conventional balun LNA with noise and distortion cancelation. The LNA is based on the combination of a common-gate (CG) stage and common-source (CS) stage. We propose to replace the load resistors by active loads, which can be used to implement local feedback loops (in the CG and CS stages). This will boost the gain and reduce the noise figure (NF). Simulation results, with a 130nm CMOS technology, show that the gain is 24dB and the NF is less than 2.7dB. The total power dissipation is only 5.4mW (since no extra blocks are required), leading to a figure-of-merit (FOM) of 3.8mW-1 using a nominal 1.2V supply. Measurement results are presented for the proposed DFB LNA included in a receiver front-end for biomedical applications (ISM and WMTS). HighlightsWe present a balun LNA with high gain and low noise figure by using active loads.A double feedback technique for gain enhancement and noise figure reduction is used.Two RF front-end receivers using a 130 nm CMOS technology were implemented: (1) using an LNA with active loads; (2) using an LNA with active loads and local double feedback.

[1]  Hao Min,et al.  A wideband CMOS variable gain low noise amplifier based on single-to-differential stage for TV tuner applications , 2008, 2008 IEEE Asian Solid-State Circuits Conference.

[2]  P. Wambacq,et al.  Low-power 5 GHz LNA and VCO in 90 nm RF CMOS , 2004, 2004 Symposium on VLSI Circuits. Digest of Technical Papers (IEEE Cat. No.04CH37525).

[3]  Ahmed Amer,et al.  A Low-Power Wideband CMOS LNA for WiMAX , 2007, IEEE Transactions on Circuits and Systems II: Express Briefs.

[4]  Krzysztof Iniewski,et al.  VLSI Circuits for Biomedical Applications , 2008 .

[5]  K. Yeo,et al.  Effect of technology scaling on the 1/f noise of deep submicron PMOS transistors , 2004 .

[6]  L. Ratti,et al.  Noise Characterization of 130 nm and 90 nm CMOS Technologies for Analog Front-end Electronics , 2006, 2006 IEEE Nuclear Science Symposium Conference Record.

[7]  Eric A. M. Klumperink,et al.  Discrete-Time Mixing Receiver Architecture for RF-Sampling Software-Defined Radio , 2010, IEEE Journal of Solid-State Circuits.

[8]  Thomas H. Lee,et al.  The Design of CMOS Radio-Frequency Integrated Circuits: RF CIRCUITS THROUGH THE AGES , 2003 .

[9]  B. Nauta,et al.  Wide-band CMOS low-noise amplifier exploiting thermal noise canceling , 2004, IEEE Journal of Solid-State Circuits.

[10]  Pui-In Mak,et al.  Design of an ESD-Protected Ultra-Wideband LNA in Nanoscale CMOS for Full-Band Mobile TV Tuners , 2009, IEEE Transactions on Circuits and Systems I: Regular Papers.

[11]  José Silva-Martínez,et al.  A High Dynamic Range CMOS Variable Gain Amplifier for Mobile DTV Tuner , 2007, IEEE Journal of Solid-State Circuits.

[12]  Luís Bica Oliveira,et al.  Balun LNA with continuously controllable gain and with noise and distortion cancellation , 2012, 2012 IEEE International Symposium on Circuits and Systems.

[13]  Minjae Lee,et al.  An 800-MHz–6-GHz Software-Defined Wireless Receiver in 90-nm CMOS , 2006, IEEE Journal of Solid-State Circuits.

[14]  Behzad Razavi,et al.  RF Microelectronics , 1997 .

[15]  Luís Bica Oliveira,et al.  Double feedforward 0.6 V LNA with high gain and low noise figure , 2013, Proceedings of the 20th International Conference Mixed Design of Integrated Circuits and Systems - MIXDES 2013.

[16]  B. Nauta,et al.  Wideband Balun-LNA With Simultaneous Output Balancing, Noise-Canceling and Distortion-Canceling , 2008, IEEE Journal of Solid-State Circuits.

[17]  S.S. Taylor,et al.  A 5GHz resistive-feedback CMOS LNA for low-cost multi-standard applications , 2006, 2006 IEEE International Solid State Circuits Conference - Digest of Technical Papers.

[18]  I. Bastos,et al.  A 6.2 mW 0.024 mm2 fully-passive RF downconverter with 12 dB gain enhancement using MOS parametric amplification , 2013 .

[19]  I. Bastos,et al.  A low power balun LNA with active loads for gain and noise figure optimization , 2014 .

[20]  Piet Wambacq,et al.  A Mixed-Signal Design Roadmap , 2001, IEEE Des. Test Comput..

[21]  Michiel Steyaert,et al.  Cmos Wireless Transceiver Design , 2015 .

[22]  Ahmad Mirzaei,et al.  A Blocker-Tolerant, Noise-Cancelling Receiver Suitable for Wideband Wireless Applications , 2012, IEEE Journal of Solid-State Circuits.