Influence of coupled pinch point temperature difference and evaporation temperature on performance of organic Rankine cycle

This paper presented the analysis on the influence of the pinch point temperature difference (PPTD) and the evaporation temperature on the performance of organic Rankine cycle (ORC) in recovering the low temperature waste heat of the flue gas. Both the net power output and the heat transfer area of the evaporator and condenser were evaluated for dry and isentropic working fluids. When the heat and cold source conditions were given, the maximum net power output and the heat transfer area were obtained. The results show that some organic working fluids cannot reach the maximum net power output to avoid the low temperature corrosion. With the increase of the PPTD of the evaporator at a given total temperature difference, the total heat transfer area decreases first and then increases, while the corresponding cost-effective performance (ratio of the net power output to total heat transfer area) displays almost the opposite variation tendency. The PPTD of the evaporator for the optimization cost-effective performance is approximately the same for different organic working fluids. Meanwhile, the isentropic working fluids show better cost-effective performance than dry working fluids.

[1]  Isam H. Aljundi,et al.  Effect of dry hydrocarbons and critical point temperature on the efficiencies of organic Rankine cycle , 2011 .

[2]  B. Zheng,et al.  A combined power and ejector refrigeration cycle for low temperature heat sources , 2010 .

[3]  Pedro J. Mago,et al.  An examination of exergy destruction in organic Rankine cycles , 2008 .

[4]  S. K. Wang,et al.  A Review of Organic Rankine Cycles (ORCs) for the Recovery of Low-grade Waste Heat , 1997 .

[5]  Olav Bolland,et al.  Working fluids for low-temperature heat source , 2010 .

[6]  Jiangfeng Wang,et al.  Parametric optimization and comparative study of organic Rankine cycle (ORC) for low grade waste heat recovery , 2009 .

[7]  Kangyao Deng,et al.  Energy and exergy analyses of a bottoming Rankine cycle for engine exhaust heat recovery , 2013 .

[8]  Zhen Lu,et al.  Performance analysis and optimization of organic Rankine cycle (ORC) for waste heat recovery , 2007 .

[9]  Xi Chen,et al.  Efficiency Improving Strategies of Low-temperature Heat Conversion Systems Using Organic Rankine Cycles: An Overview , 2011 .

[10]  K. Srinivasan,et al.  Analysis of exhaust waste heat recovery from a dual fuel low temperature combustion engine using an Organic Rankine Cycle , 2010 .

[11]  Andreas Schuster,et al.  Efficiency optimization potential in supercritical Organic Rankine Cycles , 2010 .

[12]  Tzu-Chen Hung,et al.  A study of organic working fluids on system efficiency of an ORC using low-grade energy sources , 2010 .

[13]  Chi-Chuan Wang,et al.  Analysis of a 50 kW organic Rankine cycle system , 2011 .

[14]  K. Goni Boulama,et al.  Power generation from residual industrial heat , 2010 .

[15]  A. Miyara,et al.  Heat Transfer and Flow Resistance of a Shell and Plate-Type Evaporator , 1997 .

[16]  D. Brüggemann,et al.  Exergy based fluid selection for a geothermal Organic Rankine Cycle for combined heat and power generation , 2010 .

[17]  Vincent Lemort,et al.  Thermo-economic optimization of waste heat recovery Organic Rankine Cycles , 2011 .

[18]  Per Lundqvist,et al.  A comparative study of the carbon dioxide transcritical power cycle compared with an organic rankine cycle with R123 as working fluid in waste heat recovery , 2006 .

[19]  Fahad A. Al-Sulaiman,et al.  Greenhouse gas emission and exergy assessments of an integrated organic Rankine cycle with a biomass combustor for combined cooling, heating and power production , 2011 .

[20]  Pedro J. Mago,et al.  Second Law Analysis and Optimization of Organic Rankine Cycle , 2006 .

[21]  Chi-Chuan Wang,et al.  Effect of working fluids on organic Rankine cycle for waste heat recovery , 2004 .

[22]  Wenhua Li,et al.  Operation optimization of an organic rankine cycle (ORC) heat recovery power plant , 2011 .

[23]  Li Zhao,et al.  A review of working fluid and expander selections for organic Rankine cycle , 2013 .

[24]  Hui Xie,et al.  The environmental impact of organic Rankine cycle for waste heat recovery through life-cycle assessment , 2013 .

[25]  N. Lai,et al.  Working fluids for high-temperature organic Rankine cycles , 2007 .

[26]  E. Stefanakos,et al.  A REVIEW OF THERMODYNAMIC CYCLES AND WORKING FLUIDS FOR THE CONVERSION OF LOW-GRADE HEAT , 2010 .

[27]  Minggao Ouyang,et al.  Study of working fluid selection of organic Rankine cycle (ORC) for engine waste heat recovery , 2011 .

[28]  Pedro J. Mago,et al.  An examination of regenerative organic Rankine cycles using dry fluids , 2008 .

[29]  Haruo Uehara,et al.  Performance test of a shell-and-plate type evaporator for OTEC , 1988 .

[30]  W. Worek,et al.  Optimum design criteria for an Organic Rankine cycle using low-temperature geothermal heat sources , 2007 .

[31]  Wang Hui-tao Experimental Study on Evaporating Heat Transfer Characteristics of HFC-245fa , 2011 .

[32]  Lijun Yu,et al.  Effects of evaporating temperature and internal heat exchanger on organic Rankine cycle , 2011 .

[33]  T. Hung Waste heat recovery of organic Rankine cycle using dry fluids , 2001 .