Signal processing of zero sequence voltage technique

This paper deals with the implementation of the zero sequence voltage (ZSV) technique [4,7], which was exploited to determine the rotor position of the surface permanent magnet synchronous motor (SMPMSM). The method is based on the zero sequence voltage measurement, performed between the neutral point of AC machines and the mid-point of the inverter DC bus. The air gap flux position and consequently the rotor position were obtained by adopting a position estimator with suitable filtering algorithm.

[1]  Alfio Consoli,et al.  Zero frequency rotor position detection for synchronous PM motors , 2000, 2000 IEEE 31st Annual Power Electronics Specialists Conference. Conference Proceedings (Cat. No.00CH37018).

[2]  Thomas A. Lipo,et al.  Direct field orientation controller using the stator phase voltage third harmonic , 1992, Conference Record of the 1992 IEEE Industry Applications Society Annual Meeting.

[3]  M. Sumner,et al.  Sensorless Control of Induction Machines, including Zero Frequency using only Fundamental PWM Excitation , 2006, IECON 2006 - 32nd Annual Conference on IEEE Industrial Electronics.

[4]  G. Scelba,et al.  Zero-sequence Flux and Voltage of Induction Motors Supplied with Low-and High-frequency Currents , 2007, 2007 IEEE International Electric Machines & Drives Conference.

[5]  R. D. Lorenz,et al.  Rotor position and velocity estimation for a salient-pole permanent magnet synchronous machine at standstill and high speeds , 1998 .

[6]  A. Consoli,et al.  Harmonic Analysis of Voltage Zero-Sequence-Based Encoderless Techniques , 2006, IEEE Transactions on Industry Applications.

[7]  A. Consoli,et al.  Low and zero speed sensorless control of synchronous reluctance motors , 1998, Conference Record of 1998 IEEE Industry Applications Conference. Thirty-Third IAS Annual Meeting (Cat. No.98CH36242).

[8]  G. Scelba,et al.  Saturation Modulation in Voltage Zero Sequence-Based Encoderless Techniques - Part II: Implementation Issues , 2005, IEEE International Conference on Electric Machines and Drives, 2005..

[9]  Peter Vas,et al.  Sensorless vector and direct torque control , 1998 .

[10]  Alfio Consoli,et al.  A new zero frequency flux position detection approach for direct field oriented control drives , 1999, Conference Record of the 1999 IEEE Industry Applications Conference. Thirty-Forth IAS Annual Meeting (Cat. No.99CH36370).