TDL absorption sensors for gas temperature and concentrations in a high-pressure entrained-flow coal gasifier

Abstract We report the first tunable diode laser (TDL) absorption measurements for gas temperature and species concentrations in a pilot-scale, high-pressure, entrained-flow, oxygen-blown, slagging coal gasifier with pressures up to 18 atm and temperatures to 1800 K. Three locations in the gasifier flow were investigated: (1) the reactor core, (2) the exit of the reactor where a water spray quenches the reaction products (pre-quench), and (3) in the gasifier product stream before particulate clean-up (post-quench). Gas temperature was measured by three pairs of H2O transitions with distinct temperature dependence at all three locations using five distributed feedback (DFB) lasers near 1.4 μm. CO, CO2 and H2O concentrations were measured at the post-quench location using DFB lasers near 2.3 μm, 2.0 μm and 1.4 μm, respectively. Fixed-wavelength, 1f-normalized, wavelength-modulation-spectroscopy with second-harmonic detection (WMS-2f) was used for all the measurements. Usable signal-to-noise ratio (SNR) > 10 was achieved with one second averaging even at gasifier conditions with large particulate loading where the non-absorption transmission loss was >99.99% from light scattering and the thermal emission was intense. The work demonstrates the capability of TDL sensors to monitor transient changes in gas temperature providing a potentially valuable control sensor for gasifier performance. In addition, measurements of CO, CO2 and H2O in the gasifier product stream showed good promise for monitoring the syngas heating value. The potential advantages of using higher WMS harmonics under high-pressure conditions were also investigated.

[1]  Terry Wall,et al.  Combustion processes for carbon capture , 2007 .

[2]  Volker Ebert,et al.  Sensitive in situ detection of CO and O2 in a rotary kiln-based hazardous waste incinerator using 760 nm and new 2.3 μm diode lasers , 2005 .

[3]  C. Taatjes,et al.  Time-resolved wavelength modulation spectroscopy measurements of HO 2 kinetics. , 1997, Applied optics.

[4]  O. Axner,et al.  Background Signals in Wavelength-Modulation Spectrometry by use of Frequency-Doubled Diode-Laser Light. II. Experiment. , 2001, Applied optics.

[5]  Volker Ebert,et al.  Absolute diode laser-based in situ detection of HCl in gasification processes , 2010 .

[6]  Hejie Li,et al.  Extension of wavelength-modulation spectroscopy to large modulation depth for diode laser absorption measurements in high-pressure gases. , 2006, Applied optics.

[7]  O. Axner,et al.  Characterization of 2f-, 4f-, and 6f-background signals in wavelength modulation diode laser absorption spectrometry in graphite furnaces , 2003 .

[8]  Ronald K. Hanson,et al.  Applications of quantitative laser sensors to kinetics, propulsion and practical energy systems , 2011 .

[9]  D. Labrie,et al.  Second-harmonic detection with tunable diode lasers — Comparison of experiment and theory , 1981 .

[10]  O. Axner,et al.  Theoretical description based on Fourier analysis of wavelength-modulation spectrometry in terms of analytical and background signals. , 1999, Applied optics.

[11]  R. Hanson,et al.  Calibration-free wavelength-modulation spectroscopy for measurements of gas temperature and concentration in harsh environments. , 2009, Applied optics.

[12]  Volker Ebert,et al.  Simultaneous in situ measurement of CO, H2O, and gas temperatures in a full-sized coal-fired power plant by near-infrared diode lasers. , 2003, Applied optics.

[13]  Rolf Arndt,et al.  Analytical Line Shapes for Lorentzian Signals Broadened by Modulation , 1965 .

[14]  Ronald K. Hanson,et al.  In situ absorption sensor for NO in combustion gases with a 5.2 μm quantum-cascade laser , 2011 .

[15]  P. Griffiths,et al.  Second Derivative Tunable Diode Laser Spectrometry for Line Profile Determination I. Theory , 1980 .

[16]  Jürgen Wolfrum,et al.  Lasers in combustion: From basic theory to practical devices , 1998 .