Waste heat recovery from exhausted gas of a proton exchange membrane fuel cell to produce hydrogen using thermoelectric generator

[1]  C. Long,et al.  A comprehensive review on energy management, demand response, and coordination schemes utilization in multi-microgrids network , 2022, Applied Energy.

[2]  Yu-Ching Lan,et al.  Effects of temperature-dependent thermal properties and the side leg heat dissipation on the performance of the thermoelectric generator , 2021, Energy.

[3]  W. Mohamed,et al.  Enhancement of low grade waste heat recovery from a fuel cell using a thermoelectric generator module with swirl flows , 2021 .

[4]  Haksoo Han,et al.  Efficiency improvement of a fuel cell cogeneration plant linked with district heating: Construction of a water condensation latent heat recovery system and analysis of real operational data , 2021, Applied Thermal Engineering.

[5]  Muhammad Hadrami Hamdan,et al.  Performance analysis on series and parallel circuit configurations of a four-cell thermoelectric generator module design , 2021, Journal of Applied Engineering Design and Simulation.

[6]  Taeho Choi,et al.  Three-zone numerical modeling method for predicting system-level waste heat recovery performance of thermoelectric generator with various electrical array configurations , 2021, Energy Conversion and Management.

[7]  A. Mraoui,et al.  Assessment of geothermal energy use with thermoelectric generator for hydrogen production , 2021, International Journal of Hydrogen Energy.

[8]  Alessandro Romagnoli,et al.  Geometry optimization of solar thermoelectric generator under different operating conditions via Taguchi method , 2021 .

[9]  M. Mohamed,et al.  Effects of fuel cell vehicle waste heat temperatures and cruising speeds on the outputs of a thermoelectric generator energy recovery module , 2021, International Journal of Hydrogen Energy.

[10]  Edward Rajan Samuel Nadar,et al.  Investigation of novel thermoelectric sensor array configurations operating under non‐uniform temperature distribution conditions for the measurement of maximum output power in an energy harvesting system , 2021, IET Science, Measurement & Technology.

[11]  T. Majozi,et al.  A mathematical model for optimum design and synthesis of a hybrid electrolyser-fuel cell system: Production of hydrogen and freshwater from seawater , 2020 .

[12]  T. Lam,et al.  Material property effect on conical semiconductor element temperatures in inhomogeneous thermoelectric coolers , 2020 .

[13]  Debao Zhang,et al.  Model development and performance evaluation of thermoelectric generator with radiative cooling heat sink , 2020 .

[14]  K. Jiao,et al.  Life cycle assessment of fuel cell, electric and internal combustion engine vehicles under different fuel scenarios and driving mileages in China , 2020 .

[15]  R. Banerjee,et al.  Net energy and carbon footprint analysis of solar hydrogen production from the high-temperature electrolysis process , 2020 .

[16]  A. Sohani,et al.  Solutions for thermal energy exploitation from the exhaust of an industrial gas turbine using optimized bottoming cycles , 2020 .

[17]  M. Zaher,et al.  Study of the effects of axial conduction on the performance of thermoelectric generators integrated in a heat exchanger for waste heat recovery applications , 2020 .

[18]  Zhen He,et al.  Powering microbial electrolysis cells by electricity generation from simulated waste heat of anaerobic digesters using thermoelectric generators , 2020 .

[19]  B. Shabani,et al.  Proton exchange membrane fuel cells heat recovery opportunities for combined heating/cooling and power applications , 2020 .

[20]  M. Sulaiman,et al.  Experimental and theoretical study of thermoelectric generator waste heat recovery model for an ultra-low temperature PEM fuel cell powered vehicle , 2019, Energy.

[21]  Pouria Ahmadi,et al.  Multi-objective design optimization of a solar based system for electricity, cooling, and hydrogen production , 2019, Energy.

[22]  Shixue Wang,et al.  Performance analysis of a thermoelectric generator applied to wet flue gas waste heat recovery , 2018, Applied Energy.

[23]  T. Kwan,et al.  Multi-objective genetic optimization of the thermoelectric system for thermal management of proton exchange membrane fuel cells , 2018 .

[24]  Fu Wang,et al.  Performance analyzes of an integrated phosphoric acid fuel cell and thermoelectric device system for power and cooling cogeneration , 2018 .

[25]  Qibin Li,et al.  Exergoenvironmental model of Organic Rankine Cycle system including the manufacture and leakage of working fluid , 2018 .

[26]  Fubao Zhou,et al.  Design for thermoelectric power generation using subsurface coal fires , 2017 .

[27]  Bin Chen,et al.  Application of cascading thermoelectric generator and cooler for waste heat recovery from solid oxide fuel cells , 2017 .

[28]  M. Sulaiman,et al.  Validation of a Waste Heat Recovery Model for a 1kW PEM Fuel Cell using Thermoelectric Generator , 2017 .

[29]  G. Dui,et al.  Revisiting the temperature dependence in material properties and performance of thermoelectric materials , 2017 .

[30]  Yiping Wang,et al.  The influence of inner topology of exhaust heat exchanger and thermoelectric module distribution on the performance of automotive thermoelectric generator , 2016 .

[31]  Yusuke Kishita,et al.  Evaluating the life cycle CO2 emissions and costs of thermoelectric generators for passenger automobiles: a scenario analysis , 2016 .

[32]  Chris Dames,et al.  Cost optimization of thermoelectric materials for power generation: The case for ZT at (almost) any cost , 2016 .

[33]  Mostafa Hasani,et al.  Application of thermoelectric cooler as a power generator in waste heat recovery from a PEM fuel cell – An experimental study , 2015 .

[34]  J. Ji,et al.  Analysis and discussion on the impact of non-uniform input heat flux on thermoelectric generator array , 2015 .

[35]  C. Su,et al.  A research on thermoelectric generator's electrical performance under temperature mismatch conditions for automotive waste heat recovery system , 2015 .

[36]  S. Kær,et al.  Optimization of a thermoelectric generator subsystem for high temperature PEM fuel cell exhaust heat recovery , 2014 .

[37]  K. Goodson,et al.  Material and manufacturing cost considerations for thermoelectrics , 2014 .

[38]  Ronnie Andersson,et al.  Analysis of Thermoelectric Generator Performance by Use of Simulations and Experiments , 2014, Journal of Electronic Materials.

[39]  Zhengkai Tu,et al.  Water recovery and air humidification by condensing the moisture in the outlet gas of a proton exchange membrane fuel cell stack , 2012 .

[40]  S. Kær,et al.  Numerical model of a thermoelectric generator with compact plate-fin heat exchanger for high temperature PEM fuel cell exhaust heat recovery , 2012 .

[41]  Gaowei Liang,et al.  Analytical model of parallel thermoelectric generator , 2011 .

[42]  Mohan Kolhe,et al.  Equivalent electrical model for a proton exchange membrane (PEM) electrolyser , 2011 .

[43]  Xiaohang Chen,et al.  An available method exploiting the waste heat in a proton exchange membrane fuel cell system , 2011 .

[44]  Wei-Keng Lin,et al.  Geometric optimization of thermoelectric coolers in a confined volume using genetic algorithms , 2005 .