Modeling Approach to Determine Static Rivulet Height in Regular Polygonal Capillary Tubes

The rise of partially wetting liquids along the corners of noncircular capillary tubes is observed in many practical science and engineering applications such as wastewater treatment using membranes, remediation, oil recovery from petroleum reservoirs, and blood flow. In this paper, rivulet rise at the corners of polygonal capillary tubes is studied for partially wetting liquids with contact angles below the critical value. The presence of corners changes the distribution of a liquid in an incomplete wetting condition. In this study, geometrical models are proposed to better understand the capillary rise and flow behavior at the corners. A geometrical solution for the capillary rivulet height and profile is derived under gravity in triangular, square, and pentagonal capillary tubes. The effects of several factors including contact angle, number of polygon sides, and liquid properties on the capillary rivulet height are examined. It was found that the ratio of liquid surface tension to density directly affects the corner rise, while it has an inverse relationship with other factors. The maximum rivulet height of 91.6 mm is obtained in the triangular capillary tube with a side length of 1 mm and a contact angle of 30° for polydimethylsiloxane (PDMS-20)-air fluid pair. The minimum capillary rivulet height of 6.2 mm, on the other hand, is achieved in the pentagonal capillary tube, with a side length of 3 mm and a contact angle of 30°. To validate the developed analytical approach, comparisons are made between the model results, literature predictions, and experimental data. In addition, the geometrical model for a square capillary tube is compared with previous published studies, revealing a good agreement. This study provides quantitative results for the influence of capillary tube shape on the flow behavior of fluids in noncircular tubes that can be useful for control and optimization of transport phenomena in corresponding systems.

[1]  H. Khan,et al.  Capillary rise in vuggy media , 2020, Advances in Water Resources.

[2]  C. Tropea,et al.  Capillary rivulet rise in real-world corners , 2020 .

[3]  D. Gründing.  An enhanced model for the capillary rise problem , 2020 .

[4]  Qinggong Wang,et al.  A dynamic model for the oscillatory regime of liquid rise in capillaries , 2019 .

[5]  G. Tang,et al.  Dynamics of droplet and liquid layer penetration in three-dimensional porous media: A lattice Boltzmann study , 2019, Physics of Fluids.

[6]  C. Tropea,et al.  Spontaneous rise in open rectangular channels under gravity. , 2018, Journal of colloid and interface science.

[7]  B. Nestler,et al.  Evaporation rate analysis of capillaries with polygonal cross-section , 2018, International Journal of Heat and Mass Transfer.

[8]  Cameron Tropea,et al.  Computations of spontaneous rise of a rivulet in a corner of a vertical square capillary , 2018 .

[9]  K. Sarah,et al.  Short timescale wetting and penetration on porous sheets measured with ultrasound, direct absorption and contact angle , 2018, RSC advances.

[10]  Mohammad O. Hamdan,et al.  Modeling meniscus rise in capillary tubes using fluid in rigid-body motion approach , 2018, Commun. Nonlinear Sci. Numer. Simul..

[11]  A. Perazzo,et al.  Emulsions in porous media: From single droplet behavior to applications for oil recovery. , 2018, Advances in colloid and interface science.

[12]  Bing Zhang,et al.  The distribution of fluids in irregular capillary tubes: a new capillary model based on the single-corner capillary , 2018, Journal of Petroleum Exploration and Production Technology.

[13]  N. Morrow,et al.  Two-phase displacements in microchannels of triangular cross-section. , 2017, Journal of colloid and interface science.

[14]  Junbiao Wang,et al.  Research on variation of static contact angle in incomplete wetting system and modeling method , 2016 .

[15]  Yajun Li,et al.  Liquid–Liquid Flow in Irregular Triangular Capillaries Under Different Wettabilities and Various Viscosity Ratios , 2016, Transport in Porous Media.

[16]  Li Chen,et al.  Contact Angle Effects on Pore and Corner Arc Menisci in Polygonal Capillary Tubes Studied with the Pseudopotential Multiphase Lattice Boltzmann Model , 2016, Comput..

[17]  A. Nikolov,et al.  Rise of the main meniscus in rectangular capillaries: Experiments and modeling. , 2016, Journal of colloid and interface science.

[18]  N. Yasufuku,et al.  An approach for quick estimation of maximum height of capillary rise , 2014 .

[19]  M. Piri,et al.  Experimental investigation of dynamic contact angle and capillary rise in tubes with circular and noncircular cross sections. , 2014, Langmuir : the ACS journal of surfaces and colloids.

[20]  Xiangyun Hu,et al.  Generalized modeling of spontaneous imbibition based on Hagen-Poiseuille flow in tortuous capillaries with variably shaped apertures. , 2014, Langmuir : the ACS journal of surfaces and colloids.

[21]  Giovanni Sebastiano Barozzi,et al.  A note on capillary rise in tubes , 2014 .

[22]  S. Moon,et al.  Experimental measurement of forces and energies associated with capillary rise in a vertical tube. , 2013, Journal of colloid and interface science.

[23]  Xiaoqian Chen,et al.  Study on asymmetric interior corner flow in microgravity condition , 2012 .

[24]  Jiansheng Feng,et al.  Simulations of novel nanostructures formed by capillary effects in lithography. , 2011, Journal of colloid and interface science.

[25]  Christophe Clanet,et al.  A universal law for capillary rise in corners , 2011, Journal of Fluid Mechanics.

[26]  J. Sherwood,et al.  Streaming potential generated by two-phase flow in a polygonal capillary. , 2010, Journal of colloid and interface science.

[27]  K. Suh,et al.  Multi-curvature liquid meniscus in a nanochannel: evidence of interplay between intermolecular and surface forces. , 2009, Lab on a chip.

[28]  P. Concus,et al.  Correction for Concus and Finn, On the behavior of a capillary surface in a wedge , 1969, Proceedings of the National Academy of Sciences.

[29]  F. Higuera,et al.  Capillary rise of a liquid between two vertical plates making a small angle , 2008 .

[30]  N. Fries,et al.  An analytic solution of capillary rise restrained by gravity. , 2008, Journal of colloid and interface science.

[31]  G. Homsy,et al.  Steady three-dimensional thermocapillary flows and dryout inside a V-shaped wedge , 2006 .

[32]  George M. Homsy,et al.  MODELING SHAPES AND DYNAMICS OF CONFINED BUBBLES , 2006 .

[33]  D. Rothman,et al.  Static contact angle in lattice Boltzmann models of immiscible fluids. , 2005, Physical review. E, Statistical, nonlinear, and soft matter physics.

[34]  C. Tsakiroglou,et al.  Pore‐structure analysis by using nitrogen sorption and mercury intrusion data , 2004 .

[35]  Mark M. Weislogel,et al.  Computing Existence and Stability of Capillary Surfaces Using Surface Evolver , 2004 .

[36]  K. Trumble,et al.  Numerical analysis of capillarity in packed spheres: planar hexagonal-packed spheres. , 2003, Journal of colloid and interface science.

[37]  Zhmud,et al.  Dynamics of Capillary Rise. , 2000, Journal of colloid and interface science.

[38]  J. Schultz,et al.  Effect of dynamic contact angle on capillary rise phenomena , 2000 .

[39]  S. Lichter,et al.  Capillary flow in an interior corner , 1998, Journal of Fluid Mechanics.

[40]  Walliser,et al.  Capillary Rise for Thermodynamic Characterization of Solid Particle Surface , 1997, Journal of colloid and interface science.

[41]  Shouxiang Ma,et al.  Effect of contact angle on drainage and imbibition in regular polygonal tubes , 1996 .

[42]  Ioannis Chatzis,et al.  The Imbibition and Flow of a Wetting Liquid along the Corners of a Square Capillary Tube , 1995 .

[43]  Lei-Han Tang,et al.  Capillary rise in tubes with sharp grooves , 1994, cond-mat/9401031.

[44]  C. Radke,et al.  Three-Dimensional Menisci in Polygonal Capillaries , 1992 .

[45]  Norman R. Morrow,et al.  Capillary behavior of a perfectly wetting liquid in irregular triangular tubes , 1991 .

[46]  D. Langbein.  The shape and stability of liquid menisci at solid edges , 1990, Journal of Fluid Mechanics.

[47]  N. Morrow,et al.  Meniscus curvatures in capillaries of uniform cross-section , 1984 .

[48]  Paul Concus,et al.  On capillary free surfaces in the absence of gravity , 1974 .

[49]  E. W. Washburn.  The Dynamics of Capillary Flow , 1921 .

[50]  Richard Lucas,et al.  Ueber das Zeitgesetz des kapillaren Aufstiegs von Flüssigkeiten , 1918 .

[51]  L. Rayleigh.  On the Theory of the Capillary Tube , 1916 .