A non-precious metal bifunctional oxygen electrode for alkaline anion exchange membrane cells

Abstract An initial study of a non-precious metal based bifunctional oxygen electrode for use in regenerative fuel cells with alkaline anion exchange membranes is described. Four nanometer size CuxMn0.9−xCo2.1O4 samples (x = 0, 0.3, 0.6, and 0.9) were prepared and characterized with XRD, SEM, TEM, and cyclic voltammetry. The CuxMn0.9−xCo2.1O4 samples exhibited promising ORR and OER catalytic activities. The gap between ORR half wave potentials of Pt/C and CuxMn0.9−xCo2.1O4 in 1 M KOH achieved only 50 mV. The onset potentials for OER on CuxMn0.9−xCo2.1O4 catalysts were more than 100 mV more negative than Pt/C in 1 M KOH. MEA with CuxMn0.9−xCo2.1O4 bifunctional oxygen electrode was prepared with CCM method and applied in a laboratory scale regenerative fuel cell. In fuel cell mode the peak power density was over 80 mW cm−2 and in electrolyser mode the onset voltage was about 1.55 V. The fuel cell to electrolyser voltage ration at 100 mA cm−2 achieved c.a. 31.87%.

[1]  T. Jaramillo,et al.  A bifunctional nonprecious metal catalyst for oxygen reduction and water oxidation. , 2010, Journal of the American Chemical Society.

[2]  J. L. Gautier,et al.  Mixed valency spinel oxides of transition metals and electrocatalysis: case of the MnxCo3−xO4 system , 1998 .

[3]  T. Ohsaka,et al.  Bifunctional catalytic activity of manganese oxide toward O2 reduction: novel insight into the mechanism of alkaline air electrode , 2004 .

[4]  Guoying Chen,et al.  DEVELOPMENT OF SUPPORTED BIFUNCTIONAL ELECTROCATALYSTS FOR UNITIZED REGENERATIVE FUEL CELLS , 2002 .

[5]  B. Marsan,et al.  Cu x Co3 − x O4 Used as Bifunctional Electrocatalyst II. Electrochemical Characterization for the Oxygen Reduction Reaction , 2007 .

[6]  K. Matsuki,et al.  Oxygen reduction catalysis of Mn–Co spinel oxides on agraphite electrode in alkaline solution , 1997 .

[7]  K. Scott,et al.  Electrochemical and fuel cell evaluation of Co based catalyst for oxygen reduction in anion exchange , 2011 .

[8]  Rudolf Holze,et al.  Bifunctional electrodes for an integrated water-electrolysis and hydrogen-oxygen fuel cell with a solid polymer electrolyte , 1992 .

[9]  Keith Scott,et al.  Development of direct methanol alkaline fuel cells using anion exchange membranes , 2004 .

[10]  K. Scott,et al.  CuxCo3−xO4 (0 ≤ x < 1) nanoparticles for oxygen evolution in high performance alkaline exchange membrane water electrolysers , 2011 .

[11]  Tsutomu Ioroi,et al.  Iridium Oxide/Platinum Electrocatalysts for Unitized Regenerative Polymer Electrolyte Fuel Cells , 2000 .

[12]  M. Armand,et al.  Building better batteries , 2008, Nature.

[13]  K. Scott,et al.  The effects of ionomer content on PEM water electrolyser membrane electrode assembly performance , 2010 .

[14]  B. Marsan,et al.  MnxCu1−xCo2O4 used as bifunctional electrocatalyst in alkaline medium , 2008 .

[15]  Jun Chen,et al.  Rapid room-temperature synthesis of nanocrystalline spinels as oxygen reduction and evolution electrocatalysts. , 2011, Nature chemistry.