Stability Issues for Fuel Cell Models in the Activation and Concentration Regimes

Code stability is a matter of concern for three-dimensional (3D) fuel cell models operating both at high current density and at high cell voltage. An idealized mathematical model of a fuel cell should converge for all potentiostatic or galvanostatic boundary conditions ranging from open circuit to closed circuit. Many fail to do so, due to (i) fuel or oxygen starvation causing divergence as local partial pressures and mass fractions of fuel or oxidant fall to near zero and (ii) nonlinearities in the Nernst and Butler-Volmer equations near open-circuit conditions. This paper describes in detail, specific numerical methods used to improve the stability of a previously existing fuel cell performance calculation procedure, at both low and high current densities. Four specific techniques are identified. A straight channel operating as a (i) solid oxide and (ii) polymer electrolyte membrane fuel cell is used to illustrate the efficacy of the modifications. (Less)

[1]  J. Pharoah,et al.  Three-dimensional computational fluid dynamics modelling and experimental validation of the Jülich Mark-F solid oxide fuel cell stack , 2018 .

[2]  W. Lehnert,et al.  Accelerated Degradation of High-Temperature Polymer Electrolyte Fuel Cells: Discussion and Empirical Modeling , 2015 .

[3]  Hrvoje Jasak,et al.  A tensorial approach to computational continuum mechanics using object-oriented techniques , 1998 .

[4]  Jon G. Pharoah,et al.  Validation of a Solid Oxide Fuel Cell Model on the International Energy Agency Benchmark Case with Hydrogen Fuel , 2015 .

[5]  S. Beale,et al.  Numerical Predictions of Transport Phenomena in a Proton Exchange Membrane Fuel Cell , 2005 .

[6]  Bengt Sundén,et al.  Review on modeling development for multiscale chemical reactions coupled transport phenomena in solid oxide fuel cells , 2010 .

[7]  R. Probstein.  Physicochemical Hydrodynamics: An Introduction , 1989 .

[8]  Werner Lehnert,et al.  3D modeling of a 200 cm2 HT-PEFC short stack , 2012 .

[9]  Ahmet Kusoglu,et al.  A Critical Review of Modeling Transport Phenomena in Polymer-Electrolyte Fuel Cells , 2014 .

[10]  S. D. Fraser,et al.  An empirical fuel cell polarization curve fitting equation for small current densities and no-load operation , 2008 .

[11]  C. Siegel.  Review of computational heat and mass transfer modeling in polymer-electrolyte-membrane (PEM) fuel cells , 2008 .

[12]  Dieter Froning,et al.  Experiences with a CFD Based Two Stage SOFC Stack Modeling Concept and Its Application , 2007 .

[13]  Jon G. Pharoah,et al.  Numerical and Experimental Analysis of a Solid Oxide Fuel Cell Stack , 2011, ECS Transactions.

[14]  Dudley Brian Spalding,et al.  Convective mass transfer : an introduction , 1963 .

[15]  D. Wilkinson,et al.  Aging mechanisms and lifetime of PEFC and DMFC , 2004 .

[16]  M. Andersson,et al.  A review of cell-scale multiphase flow modeling, including water management, in polymer electrolyte fuel cells , 2016 .

[17]  Atilla Biyikoglu,et al.  Review of proton exchange membrane fuel cell models , 2005 .

[18]  S. Patankar.  Numerical Heat Transfer and Fluid Flow , 2018, Lecture Notes in Mechanical Engineering.

[19]  Steven Beale,et al.  Computer methods for performance prediction in fuel cells , 2003 .

[20]  Steven Beale,et al.  Calculation procedure for mass transfer in fuel cells , 2004 .

[21]  D. Spalding.  A standard formulation of the steady convective mass transfer problem , 1960 .

[22]  S. Beale.  Mass transfer formulation for polymer electrolyte membrane fuel cell cathode , 2015 .

[23]  S. Kakaç,et al.  A review of numerical modeling of solid oxide fuel cells , 2007 .

[24]  Jon G. Pharoah,et al.  Open-source computational model of a solid oxide fuel cell , 2016, Comput. Phys. Commun..

[25]  S. Beale.  Mass transfer in plane and square ducts , 2005 .

[26]  P. Roache.  Fundamentals of computational fluid dynamics , 1998 .

[27]  D. H. Schwarz,et al.  Calculations of transport phenomena and reaction distribution in a polymer electrolyte membrane fuel cell , 2009 .

[28]  Ellen Ivers-Tiffée,et al.  SOFC Modeling and Parameter Identification by Means of Impedance Spectroscopy , 2010 .