Mathematical modeling of a pressurizer in a pressurized water reactor for control design

Abstract A pressurizer is a key equipment to ensure the safe operation of a pressurized water reactor by maintaining the reactor coolant system pressure within allowed tolerances. In this paper, a nonequilibrium three-region pressurizer model for the pressurized water reactor was developed first base on the basic conservation laws of mass and energy for the steam and water in the pressurizer. Then the nonlinear model was linearized to introduce the transfer function models of the pressurizer during insurge and outsurge transients for the controller design of a small pressurized water reactor pressurizer. Based on the developed transfer function models, the closed-loop pressurizer pressure and water level control systems including conventional proportional-integral-derivative controllers were designed employing the control strategy that uses a spray valve and two electric heaters for pressure control and regulates the charging flow rate with the letdown flow rate keeping constant for water level control. Finally, a simulation platform for the small pressurized water reactor pressurizer was developed in MATLAB/Simulink with implementation of the proposed nonlinear and nonequilibrium three-region pressurizer model, a widely-used nonlinear and nonequilibrium three-region pressurizer model and the designed pressure and water level controllers. Two typical load change transients, including the 100% to 90% of full power step load decrease and load rejection from 100% to 25% of full power, were simulated based on the platform. Dynamic responses of the pressure and water level obtained using the two nonlinear pressurizer models were analyzed, and the controller performances were assessed. The analysis and assessment results have shown satisfactory control performance and good robustness of the designed controllers regardless of the pressurizer simulation model adopted, demonstrating the feasibility, effectiveness and accuracy of the developed nonlinear and transfer function models of the pressurizer for dynamic simulation and controller design.

[1]  G. Su,et al.  Numerical study on annular tube once-through steam generator using compressible flow model , 2012 .

[2]  Zhi Chen,et al.  Control simulation and study of load rejection transient for AP1000 , 2015 .

[3]  Mauro Vitor de Oliveira,et al.  Application of artificial intelligence techniques in modeling and control of a nuclear power plant pressurizer system , 2013 .

[4]  Qiu Suizheng Dynamic Simulation and Verification of Pressurizer Based on Nonequilibrium Multi-region Model , 2012 .

[5]  You Hong A Nonequilibrium Multi-region Model for Nuclear Power Pressurizer , 2001 .

[6]  Jiashuang Wan,et al.  Development of a simulation platform for dynamic simulation and control studies of AP1000 nuclear steam supply system , 2015 .

[7]  Wang Weiwei,et al.  Development of a thermal–hydraulic safety analysis code RETAC for AP1000 , 2012 .

[8]  Hee Cheon No,et al.  A Nonequilibrium Three-Region Model for Transient Analysis of Pressurized Water Reactor Pressurizer , 1986 .

[10]  Goon-Cherl Park,et al.  Development of nonequilibrium pressurizer model with noncondensable gas , 2006 .

[11]  Yang Liu,et al.  Research on the steam–gas pressurizer model with Relap5 code , 2017 .

[12]  Luigi Colombo,et al.  A non-equilibrium control oriented model for the pressurizer dynamics , 2018, Progress in Nuclear Energy.

[13]  Tahir Ahmad,et al.  Fuzzy state space model for a pressurizer in a nuclear power plant , 2015 .

[14]  Celso Marcelo Franklin Lapa,et al.  The IRIS pressurizer: Simulation of out-surge transients and optimization procedure to design scaled experiments , 2008 .

[15]  Mohammad Rahgoshay,et al.  Simulation of two-region and four-region models for typical PWR pressurizer and benchmark obtained results using available results , 2014 .