Investigation and Scrutiny of Drilling Process Parameters for Tool wear and Material Removal Rate of SMC Composite in the Itinerary of Fuzzy Inference Give up

The drilling action is the majority widespread process used in construction of holes and the primary input machining parameters are highly influencing over the output parameters of material removal rate, surface finish, dimensional exactness, shape precision, tool wear. In this at hand exploration the MRR and tool wear are predicted with respect to the input parameters with the Fuzzy Logic inference with MATLAB in order to lay the path of drilling effects on the polymer composite. The outcome of the Fuzzy inference compared in the midst of the experimental values and instituted to be in close conformity.

[1]  C. K. H. Dharan,et al.  Machining parameters for an intelligent machining system for composite laminates , 2000 .

[2]  A. Abrão,et al.  Influence of Drill Point Angle in High Speed Drilling of Glass Fiber Reinforced Plastics , 2008 .

[3]  P. C. Upadhyay,et al.  On the Evaluation of Critical Thrust for Delamination-Free Drilling of Composite Laminates , 1999 .

[4]  H. Hocheng,et al.  On drilling characteristics of fiber-reinforced thermoset and thermoplastics , 1992 .

[5]  W. König,et al.  Machining of Fibre Reinforced Plastics , 1985 .

[6]  A. Abrão,et al.  The effect of cutting tool geometry on thrust force and delamination when drilling glass fibre reinforced plastic composite , 2008 .

[7]  S. Lin,et al.  Drilling Unidirectional Glass Fiber-Reinforced Composite Materials at High Speed , 1999 .

[8]  Dai Gil Lee,et al.  Delamination-Free and High Efficiency Drilling of Carbon Fiber Reinforced Plastics , 1995 .

[9]  Wen-Chou Chen,et al.  Some experimental investigations in the drilling of carbon fiber-reinforced plastic (CFRP) composite laminates , 1997 .

[10]  R. Komanduri,et al.  Machining fiber-reinforced composites , 1997 .

[11]  K. Krishnamurthy,et al.  A neural network thrust force controller to minimize delamination during drilling of graphite-epoxy laminates , 1996 .

[12]  B. Latha,et al.  Fuzzy Rule Based Modeling of Drilling Parameters for Delamination in Drilling GFRP Composites , 2009 .

[13]  Klaus Weinert,et al.  Cutting Temperatures and Their Effects on the Machining Behaviour in Drilling Reinforced Plastic Composites , 2004 .

[14]  Frédéric Lachaud,et al.  Experimental analysis of drilling damage in thin carbon/epoxy plate using special drills , 2000 .