The effect of south wall's outdoor absorption coefficient on time lag, decrement factor and temperature variations

In this study, the effect of outdoor absorption coefficient of an opaque wall on time lag, decrement factor and temperature variations is investigated by employing a dynamic thermal-network model. The model simulates heat transfer by conduction through the wall and considers convection boundary conditions under detailed forcing functions on the wall outer and inner surfaces. The transient analysis is based on the fundamental principles of thermal circuits and the well-known analogies between the thermal and electrical laws are employed. The effect of the solar absorptivity, is examined for representative wall formations including masonry, insulation and coatings on both surfaces. The insulation is placed as one or two layers on the outer, the inner or in the mid-center of the masonry. The investigation is carried out for a wall with south orientation during the cooling season in the Mediterranean region. The analyses presume a non-sinusoidal periodical excitation that simulates precisely the effect of the outdoor environmental conditions. Computer results show how these varied aspects affect thermal inertia parameters and outdoor/indoor temperature peaks.

[1]  B. Givoni.  Passive and Low Energy Cooling of Buildings , 1994 .

[2]  Edward Henry Mathews,et al.  A novel thermal simulation model and its application on naturally ventilated desert buildings , 1997 .

[3]  D. Asimakopoulos.  Energy and Climate in the Urban Built Environment , 2001 .

[4]  Dimitrios Bikas,et al.  The influence of the zone's indoor temperature settings on the cooling/heating loads for fixed and controlled ventilation , 2006 .

[5]  H. Asan,et al.  Investigation of wall's optimum insulation position from maximum time lag and minimum decrement factor point of view , 2000 .

[6]  Edward Henry Mathews,et al.  Energy efficiency of formal low-cost housing in South Africa's Gauteng region , 1996 .

[7]  H. Asan.  Numerical computation of time lags and decrement factors for different building materials , 2006 .

[8]  Edward Henry Mathews,et al.  The development and testing of low-cost insulation for shacks , 1999 .

[9]  Edward Henry Mathews,et al.  A two-port envelope model for building heat transfer , 1998 .

[10]  H. Asan,et al.  Effects of Wall's thermophysical properties on time lag and decrement factor , 1998 .

[11]  H. Asan,et al.  Effects of wall's insulation thickness and position on time lag and decrement factor , 1998 .

[12]  Greg Knowles,et al.  Use of layered walls to reduce building temperature swings , 1984 .

[13]  Rufus Oldenburger,et al.  Mathematical engineering analysis , 1953 .

[14]  Baruch Givoni,et al.  Characteristics, design implications, and applicability of passive solar heating systems for buildings , 1991 .

[15]  Dimitrios Bikas,et al.  Modeling the influence of glazed openings percentage and type of glazing on the thermal zone behavior , 2002 .

[16]  Y. Çengel.  Heat Transfer: A Practical Approach , 1997 .

[17]  D. Asimakopoulos.  Passive Cooling of Buildings , 1996 .

[18]  Greg Knowles,et al.  A passive wall design to minimize building temperature swings , 1984 .

[19]  Koray Ulgen,et al.  Experimental and theoretical investigation of effects of wall’s thermophysical properties on time lag and decrement factor , 2002 .