Development of a low cost yarn parameterisation unit by image processing

Abstract This paper deals with the development of a computerised system to measure different yarn parameters i.e. diameter, diameter variation, number of thick/thin places and neps, hairiness indices (hair length index and hair area index) and number of hairs in a single run with the help of image processing. A low cost Universal Serial Bus (USB) web camera, mechanical set up for yarn movement, computer and LabVIEW software are used for this purpose. Jute and cotton yarn with wide range of nominal diameter have been tested with cut length 1–4 mm and the results have been compared with a commercial capacitive tester i.e. Uster tester 3. The repeatability of results is insignificant in 1% level. Calibration has been done by taking image of a standard wire and adjusting the multiplying factor in the software if required. The developed system can give the average diameter of the yarn under test in real time unit (millimetre) unlike state of art instrument where it is set to zero. Hairiness is more rigorously defined in contrary to other tester where either qualitative analysis of hairs or hair count is measured. As the principle of measurement is image processing, the choice of correct background prior to the test is a prerequisite. The accuracy of the developed instrument is much higher as it can sense pixel change of measurable parameter. The developed system is equally useful for coloured yarns with proper background. The performance of the system is free from fluctuation of ambient temperature, humidity and illumination level.

[1]  Vítor H. Carvalho,et al.  Yarn Hairiness Characterization Using Two Orthogonal Directions , 2009, IEEE Transactions on Instrumentation and Measurement.

[2]  D Yuvaraj,et al.  A simple yarn hairiness measurement setup using image processing techniques , 2012 .

[3]  Filomena Soares,et al.  Yarn parameterization based on mass analysis , 2004 .

[4]  R.M. Vasconcelos,et al.  Yarn Diameter Measurements Using Coherent Optical Signal Processing , 2008, IEEE Sensors Journal.

[5]  Anirban Guha,et al.  Measurement of yarn hairiness by digital image processing , 2010 .

[6]  M. Kuzariski.  The algorithms of the yarn shape detection and calculation of the protruding fibres length , 2008, 2008 International Conference on Perspective Technologies and Methods in MEMS Design.

[7]  Filomena Soares,et al.  A comparison of mass parameters determination using capacitive and optical sensors , 2011 .

[8]  Anna Fabijanska,et al.  A survey of thresholding algorithms on yarn images , 2010, 2010 Proceedings of VIth International Conference on Perspective Technologies and Methods in MEMS Design.

[9]  Vítor Carvalho,et al.  A comparative study between yarn diameter and yarn mass variation measurement systems using capacitive and optical sensors , 2008 .

[10]  Vítor H. Carvalho,et al.  Artificial intelligence and image processing based techniques: A tool for yarns parameterization and fabrics prediction , 2009, 2009 IEEE Conference on Emerging Technologies & Factory Automation.

[11]  Vítor H. Carvalho,et al.  Yarn-Mass Measurement With 1-mm-Length Samples , 2007, IEEE Transactions on Industrial Electronics.

[12]  Filomena Soares,et al.  Yarn Evenness Parameters Evaluation: A New Approach , 2008 .

[13]  M. Kuzanski,et al.  Measurement Methods for Yarn Hairiness Analysis - the idea and construction of research standing , 2006, Proceedings of the 2nd International Conference on Perspective Technologies and Methods in MEMS Design.

[14]  Anna Fabijanska,et al.  Image processing and analysis algorithms for yarn hairiness determination , 2012, Machine Vision and Applications.

[15]  R.M. Vasconcelos,et al.  Automatic Yarn Characterization System: Design of a Prototype , 2009, IEEE Sensors Journal.

[16]  Michael Belsley,et al.  Yarn Diameter and Linear Mass Correlation , 2009 .