The effect of a HfO2 insulator on the improvement of breakdown voltage in field-plated GaN-based HEMT

A GaN/Al0.3Ga0.7N/AlN/GaN high-electron mobility transistor utilizing a field plate (with a 0.3 μm overhang towards the drain and a 0.2 μm overhang towards the source) over a 165-nm sputtered HfO2 insulator (HfO2-FP-HEMT) is fabricated on a sapphire substrate. Compared with the conventional field-plated HEMT, which has the same geometric structure but uses a 60-nm SiN insulator beneath the field plate (SiN-FP-HEMT), the HfO2-FP-HEMT exhibits a significant improvement of the breakdown voltage (up to 181 V) as well as a record field-plate efficiency (up to 276 V/μm). This is because the HfO2 insulator can further improve the modulation of the field plate on the electric field distribution in the device channel, which is proved by the numerical simulation results. Based on the simulation results, a novel approach named the proportional design is proposed to predict the optimal dielectric thickness beneath the field plate. It can simplify the field-plated HEMT design significantly.

[1]  Shreepad Karmalkar,et al.  Enhancement of breakdown voltage in AlGaN/GaN high electron mobility transistors using a field plate , 2001 .

[2]  S. Denbaars,et al.  Deep-Submicrometer AlGaN/GaN HEMTs With Slant Field Plates , 2009, IEEE Electron Device Letters.

[3]  J. Chyi,et al.  Simulation and fabrication of high voltage AlGaN/GaN based Schottky diodes with field plate edge termination , 2007 .

[4]  M. Asif Khan,et al.  High electron mobility transistor based on a GaN‐AlxGa1−xN heterojunction , 1993 .

[5]  S. Keller,et al.  High breakdown GaN HEMT with overlapping gate structure , 2000, IEEE Electron Device Letters.

[6]  L. Tan,et al.  Investigations of HfO2∕AlGaN∕GaN metal-oxide-semiconductor high electron mobility transistors , 2006 .

[7]  S. Karmalkar,et al.  RESURF AlGaN/GaN HEMT for high voltage power switching , 2001, IEEE Electron Device Letters.

[8]  Ichiro Omura,et al.  High breakdown voltage AlGaN-GaN power-HEMT design and high current density switching behavior , 2003 .

[9]  M. Conti,et al.  Surface breakdown in silicon planar diodes equipped with field plate , 1972 .

[10]  L. Hongxia,et al.  Development and characteristic analysis of a field-plated Al2O3/AlInN/GaN MOS—HEMT , 2011 .

[11]  I. Omura,et al.  Design optimization of high breakdown voltage AlGaN-GaN power HEMT on an insulating substrate for R/sub ON/A-V/sub B/ tradeoff characteristics , 2005, IEEE Transactions on Electron Devices.

[12]  A. Chini,et al.  High breakdown voltage AlGaN-GaN HEMTs achieved by multiple field plates , 2004, IEEE Electron Device Letters.

[13]  Eng Fong Chor,et al.  Enhanced device performance of AlGaN/GaN HEMTs using HfO2 high-k dielectric for surface passivation and gate oxide , 2007 .

[14]  K. Kunihiro,et al.  Experimental evaluation of impact ionization coefficients in GaN , 1999, IEEE Electron Device Letters.

[15]  R. J. Shul,et al.  GAN : PROCESSING, DEFECTS, AND DEVICES , 1999 .

[16]  Wei Mao,et al.  AlGaN/GaN MOS-HEMT With $\hbox{HfO}_{2}$ Dielectric and $\hbox{Al}_{2}\hbox{O}_{3}$ Interfacial Passivation Layer Grown by Atomic Layer Deposition , 2008, IEEE Electron Device Letters.

[17]  U. Mishra,et al.  AlGaN/GaN HEMTs-an overview of device operation and applications , 2002, Proc. IEEE.

[18]  S. Keller,et al.  High Breakdown Voltage Achieved on AlGaN/GaN HEMTs With Integrated Slant Field Plates , 2006, IEEE Electron Device Letters.

[19]  W. Frensley,et al.  Power-limiting breakdown effects in GaAs MESFET's , 1981, IEEE Transactions on Electron Devices.