Design and Implementation of a New Multilevel Inverter Topology

Multilevel inverters have been widely accepted for high-power high-voltage applications. Their performance is highly superior to that of conventional two-level inverters due to reduced harmonic distortion, lower electromagnetic interference, and higher dc link voltages. However, it has some disadvantages such as increased number of components, complex pulsewidth modulation control method, and voltage-balancing problem. In this paper, a new topology with a reversing-voltage component is proposed to improve the multilevel performance by compensating the disadvantages mentioned. This topology requires fewer components compared to existing inverters (particularly in higher levels) and requires fewer carrier signals and gate drives. Therefore, the overall cost and complexity are greatly reduced particularly for higher output voltage levels. Finally, a prototype of the seven-level proposed topology is built and tested to show the performance of the inverter by experimental results.

[1]  P.N. Enjeti,et al.  A Carrier-Based PWM Method With Optimal Switching Sequence for a Multilevel Four-Leg Voltage-Source Inverter , 2008, IEEE Transactions on Industry Applications.

[2]  G.S. Perantzakis,et al.  A Novel Four-Level Voltage Source Inverter—Influence of Switching Strategies on the Distribution of Power Losses , 2007, IEEE Transactions on Power Electronics.

[3]  Frede Blaabjerg,et al.  Multilevel inverter by cascading industrial VSI , 2002, IEEE Trans. Ind. Electron..

[4]  Jeyraj Selvaraj,et al.  Multilevel Inverter For Grid-Connected PV System Employing Digital PI Controller , 2009, IEEE Transactions on Industrial Electronics.

[5]  Yunping Zou,et al.  A Novel Composite Cascade Multilevel Converter , 2007, IECON 2007 - 33rd Annual Conference of the IEEE Industrial Electronics Society.

[6]  D.A.B. Zambra,et al.  A comparative analysis between the symmetric and the hybrid asymmetric nine-level series connected H-bridge cells inverter , 2007, 2007 European Conference on Power Electronics and Applications.

[7]  Simone Buso,et al.  Three-Phase Low-Frequency Commutation Inverter for Renewable Energy Systems , 2006, IEEE Transactions on Industrial Electronics.

[8]  Jeyraj Selvaraj,et al.  Single-Phase Seven-Level Grid-Connected Inverter for Photovoltaic System , 2011, IEEE Transactions on Industrial Electronics.

[9]  K. Baskaran,et al.  Analysis and Implementation of Multiphase Multilevel Hybrid Single Carrier Sinusoidal Modulation , 2010 .

[10]  Ehsan Najafi,et al.  A novel current mode controller for a static compensator utilizing Goertzel algorithm to mitigate voltage sags , 2011 .

[11]  Fernando L. M. Antunes,et al.  Multilevel Inverter Topologies for Stand-Alone PV Systems , 2013, IEEE Transactions on Industrial Electronics.

[12]  J. Walter,et al.  A New Simplified Multilevel Inverter Topology for DC–AC Conversion , 2006, IEEE Transactions on Power Electronics.

[13]  Leon M. Tolbert,et al.  Multilevel converters for large electric drives , 1998, APEC '98 Thirteenth Annual Applied Power Electronics Conference and Exposition.

[14]  Mahesh Kumar Mishra,et al.  DC Capacitor Voltage Equalization in Neutral Clamped Inverters for DSTATCOM Application , 2010, IEEE Transactions on Industrial Electronics.

[15]  Mariusz Malinowski,et al.  A Survey on Cascaded Multilevel Inverters , 2010, IEEE Transactions on Industrial Electronics.

[16]  M.I. Valla,et al.  Analysis of a Cascade Asymmetric Topology for Multilevel Converters , 2007, 2007 IEEE International Symposium on Industrial Electronics.

[17]  T. Sutikno,et al.  An Optimized Switching Strategy for Quick Dynamic Torque Control in DTC-Hysteresis-Based Induction Machines , 2011, IEEE Transactions on Industrial Electronics.

[18]  E. Babaei.  OPTIMAL TOPOLOGIES FOR CASCADED SUB-MULTILEVEL CONVERTERS , 2010 .

[19]  Sung-Jun Park,et al.  Cascaded Multilevel Inverter Employing Three-Phase Transformers and Single DC Input , 2009, IEEE Transactions on Industrial Electronics.

[20]  P. N. Tekwani,et al.  A Reduced-Switch-Count Five-Level Inverter With Common-Mode Voltage Elimination for an Open-End Winding Induction Motor Drive , 2007, IEEE Transactions on Industrial Electronics.

[21]  Gui-Jia Su.  Multilevel DC-link inverter , 2005, IEEE Transactions on Industry Applications.

[22]  Makbul Anwari,et al.  Performance analysis of hybrid photovoltaic/diesel energy system under Malaysian conditions , 2010 .

[23]  K. Nakata,et al.  A three-level traction inverter with IGBTs for EMU , 1994, Proceedings of 1994 IEEE Industry Applications Society Annual Meeting.

[24]  A. Radan,et al.  Evaluation of Carrier-Based PWM Methods for Multi-level Inverters , 2007, 2007 IEEE International Symposium on Industrial Electronics.

[25]  N. Seki,et al.  Converter configurations and switching frequency for a GTO reactive power compensator , 1997 .

[26]  Pierluigi Siano,et al.  A Multilevel Inverter for Photovoltaic Systems With Fuzzy Logic Control , 2010, IEEE Transactions on Industrial Electronics.

[27]  P. Steimer,et al.  Active Neutral-Point-Clamped Multilevel Converters , 2005, 2005 IEEE 36th Power Electronics Specialists Conference.

[28]  S. Halasz,et al.  Analysis of the unipolar PWM techniques , 1996, Proceedings of 8th Mediterranean Electrotechnical Conference on Industrial Applications in Power Systems, Computer Science and Telecommunications (MELECON 96).

[29]  Richard H. Osman,et al.  A medium-voltage drive utilizing series-cell multilevel topology for outstanding power quality , 1999, Conference Record of the 1999 IEEE Industry Applications Conference. Thirty-Forth IAS Annual Meeting (Cat. No.99CH36370).

[30]  J. Rodriguez,et al.  Mixed Multicell Cascaded Multilevel Inverter , 2007, 2007 IEEE International Symposium on Industrial Electronics.

[31]  Esra Kandemir Beser,et al.  Design and Application of a Single Phase Multilevel Inverter Suitable for using as a Voltage Harmonic Source , 2010 .

[32]  Ghazanfar Shahgholiyan,et al.  IMPROVING THE MITIGATION OF VOLTAGE FLICKER BY USAGE OF FUZZY CONTROL IN A DISTRIBUTION STATIC SYNCHRONOUS COMPENSATOR (DSTATCOM) , 2010 .

[33]  Robert Stala,et al.  Application of Balancing Circuit for DC-Link Voltages Balance in a Single-Phase Diode-Clamped Inverter With Two Three-Level Legs , 2011, IEEE Transactions on Industrial Electronics.

[34]  Mauricio Aredes,et al.  Multi-pulse STATCOM operation under unbalanced voltages , 2002, 2002 IEEE Power Engineering Society Winter Meeting. Conference Proceedings (Cat. No.02CH37309).

[35]  Young Min Park,et al.  Design of a Cascaded H-Bridge Multilevel Inverter Based on Power Electronics Building Blocks and Control for High Performance , 2010 .

[36]  Fang Zheng Peng,et al.  Multilevel converters-a new breed of power converters , 1995, IAS '95. Conference Record of the 1995 IEEE Industry Applications Conference Thirtieth IAS Annual Meeting.