Manufacturing process optimization for wear property of fiber-reinforced polybutylene terephthalate composites with grey relational analysis

[1]  A. Misra,et al.  Influence of injection‐molding parameters on the morphology and mechanical properties of glass fiber‐reinforced polypropylene composites , 1982 .

[2]  K. Tempelmeyer,et al.  The abrasive wear of short fibre composites , 1985 .

[3]  M. S. Phadke,et al.  Optimization of product and process design for quality and cost , 1988 .

[4]  N. Logothetis,et al.  Characterizing and optimizing multi‐response processes by the taguchi method , 1988 .

[5]  J. Karger‐Kocsis,et al.  Fatigue crack propagation in glass-fibre and glass-sphere filled PBT composites , 1988 .

[6]  Raghu N. Kacker,et al.  A methodology for planning experiments in robust product and process design , 1988 .

[7]  T. Vu-khanh,et al.  Tensile properties of injection molded long fiber thermoplastic composites , 1989 .

[8]  J. Deng,et al.  Introduction to Grey system theory , 1989 .

[9]  T. Vu-khanh,et al.  Fracture behaviour of long fibre reinforced thermoplastics , 1994, Journal of Materials Science.

[10]  The Wear of a Composite of High-Modulus HDPE Fibers in a Matrix of LDPE in Unidirectional Motion against 316L Steel , 1997 .

[11]  Tribological characteristics of short glass fibre reinforced polycarbonate composites , 1997 .

[12]  K. Friedrich,et al.  Wear performance of tribologically modified thermoplastic composites at elevated temperatures , 1999 .

[13]  Shyam Bahadur,et al.  Mechanical and tribological properties of polyamide 6 and high density polyethylene polyblends with and without compatibilizer , 2000 .