DC-link Voltage Control of a Full Power Converter for Wind Generator Operating in Weak-Grid Systems

When the wind power accounts for a large portion of the grid power, it may need to help the grid voltage and frequency regulation. This paper investigates a permanent-magnet wind generator with a full power voltage-source converter in weak-grid mode, where the DC-link voltage needs to be controlled from the generator side instead of the grid side. The energy relationship of the wind generator, DC-link energy storage, and load is established. An intrinsic right-half-plane zero, together with the wind power characteristics, the mechanical system inertia, and the DC-link energy storage, is identified as the physical limitations for the control. With the understanding of the system energy relationship and limitations, a hybrid adaptive control algorithm is proposed that searches for the optimal generator acceleration to achieve the maximum wind generator power change rate to match the load power variation. The proposed control scheme is verified through simulation of a 1.5-MW wind system as well as through the experiment of a scaled 1-kW, DSP-/field-programmable-gate-array-controlled, permanent-magnet-generator-based test bed. The results show that it is feasible to regulate DC link by the generator-side converter through the generator speed control. Some important applications issues are also investigated, including the DC-link energy storage requirement, wind speed change impact, and control transition between the weak-grid and strong-grid modes.

[1]  Erich Hau,et al.  Wind Turbines: Fundamentals, Technologies, Application, Economics , 1999 .

[2]  Zitao Wang,et al.  A DC Voltage Monitoring and Control Method for Three-Phase Grid-Connected Wind Turbine Inverters , 2008, IEEE Transactions on Power Electronics.

[3]  Frede Blaabjerg,et al.  Power Electronics for Modern Wind Turbines , 2006, Power Electronics for Modern Wind Turbines.

[4]  Dushan Boroyevich,et al.  Design and Evaluation of a PLL-Based Position Controller for Sensorless Vector Control of Permanent-Magnet Synchronous Machines , 2006, IECON 2006 - 32nd Annual Conference on IEEE Industrial Electronics.

[5]  F. Blaabjerg,et al.  Flexible control of small wind turbines with grid failure detection operating in stand-alone and grid-connected mode , 2004, IEEE Transactions on Power Electronics.

[6]  Vahan Gevorgian,et al.  Analysis of permanent magnet generator for wind power battery charging , 1996, IAS '96. Conference Record of the 1996 IEEE Industry Applications Conference Thirty-First IAS Annual Meeting.

[7]  I. Erlich,et al.  Interaction of Large Wind Power Generation Plants with the Power System , 2006, 2006 IEEE International Power and Energy Conference.

[8]  Kostas Kalaitzakis,et al.  Design of a maximum power tracking system for wind-energy-conversion applications , 2006, IEEE Transactions on Industrial Electronics.

[9]  A. Binder,et al.  Permanent magnet synchronous generators for regenerative energy conversion - a survey , 2005, 2005 European Conference on Power Electronics and Applications.

[10]  S. Grabic,et al.  Permanent Magnet Synchronous Generator Cascade for Wind Turbine Application , 2008, IEEE Transactions on Power Electronics.

[11]  K. Tan,et al.  Optimum control strategies in energy conversion of PMSG wind turbine system without mechanical sensors , 2004, IEEE Transactions on Energy Conversion.

[12]  Leopoldo García Franquelo,et al.  Modeling Strategy for Back-to-Back Three-Level Converters Applied to High-Power Wind Turbines , 2006, IEEE Transactions on Industrial Electronics.

[13]  M. Chinchilla,et al.  Control of permanent-magnet generators applied to variable-speed wind-energy systems connected to the grid , 2006, IEEE Transactions on Energy Conversion.

[14]  Frede Blaabjerg,et al.  Voltage recovery of grid-connected wind turbines after a short-circuit fault , 2003, IECON'03. 29th Annual Conference of the IEEE Industrial Electronics Society (IEEE Cat. No.03CH37468).

[15]  L. Ran,et al.  Use of turbine inertia for power smoothing of wind turbines with a DFIG , 2004, 2004 11th International Conference on Harmonics and Quality of Power (IEEE Cat. No.04EX951).

[16]  Mona N. Eskander,et al.  Fuzzy logic control based maximum power tracking of a wind energy system , 2001 .

[17]  Johan Enslin,et al.  Novel control strategies for variable-speed doubly fed wind power generation systems , 1995 .

[18]  Ned Mohan,et al.  Seamless transfer of grid-connected PWM inverters between utility-interactive and stand-alone modes , 2002, APEC. Seventeenth Annual IEEE Applied Power Electronics Conference and Exposition (Cat. No.02CH37335).

[19]  Zhe Chen,et al.  Design and comparison of full-size converters for large variable-speed wind turbines , 2007, 2007 European Conference on Power Electronics and Applications.

[20]  S. Bolognani,et al.  Start-up Strategy for a Sensorless Direct Drive PM Generator for Wind Turbines , 2005, Proceedings of the IEEE International Symposium on Industrial Electronics, 2005. ISIE 2005..

[21]  L. Xu,et al.  A new control method of permanent magnet generator for maximum power tracking in wind turbine application , 2005, IEEE Power Engineering Society General Meeting, 2005.

[22]  F. Blaabjerg,et al.  Power electronics as efficient interface in dispersed power generation systems , 2004, IEEE Transactions on Power Electronics.

[23]  E. Spooner,et al.  A Multilevel Modular Converter for a Large, Light Weight Wind Turbine Generator , 2008, IEEE Transactions on Power Electronics.

[24]  M. Nakaoka,et al.  Advanced control of PWM converter with variable-speed induction generator , 2006, IEEE Transactions on Industry Applications.

[25]  J. F. Conroy,et al.  Low-voltage ride-through of a full converter wind turbine with permanent magnet generator , 2007 .

[26]  Liuchen Chang,et al.  An intelligent maximum power extraction algorithm for inverter-based variable speed wind turbine systems , 2004 .

[27]  R. Portillo,et al.  Power Electronic Systems for the Grid Integration of Wind Turbines , 2006, IECON 2006 - 32nd Annual Conference on IEEE Industrial Electronics.

[28]  A.M. Knight,et al.  A review of power converter topologies for wind generators , 2005, IEEE International Conference on Electric Machines and Drives, 2005..