Synthesis of thickness-controlled cuboid WO3 nanosheets and their exposed facets-dependent acetone sensing properties

Abstract Thickness-controlled cuboid WO 3 nanosheets with exposed (020) and (200) facets have been successively synthesized by a low temperature acid-assisted (HCl) hydrothermal process and the subsequent heating treatment. The average thickness of the WO 3 nanosheet samples can be adjusted from about 10 to 110 nm by simply changing the oxalic acid and HCl content in the preparation solutions. A high exposure degree of (020) facets make WO 3 nanosheets a very promising sensitive material for developing gas sensors with high acetone sensing performance, which can even make them easy to distinguish between acetone and ethanol. The gas responses of the WO 3 nanosheet samples increased with the increase of the exposure degree of (020) facets, obvious facet-dependent gas sensing characteristic was found. A high response of 49.1, a lower detection limit of 0.5 ppm, and shorter response and recovery times (7 and 19 s, respectively) to 100 ppm acetone vapor were obtained for the WO 3 nanosheet sample with the highest exposure degree of (020) facets. The gas sensing mechanism was discussed in detail. The content of dangling bonds and the local electric polarization on the exposed special facets could be the key factors for the highly acetone sensitivity and selectivity.

[1]  Yuxiang Qin,et al.  DFT study on interaction of NO2 with the vacancy-defected WO3 nanowires for gas-sensing , 2016 .

[2]  Liang Li,et al.  Controlling the morphologies of WO3 particles and tuning the gas sensing properties , 2012 .

[3]  G. Yang,et al.  Porous tungsten oxide nanoflakes for highly alcohol sensitive performance. , 2012, Nanoscale.

[4]  Yu Lei,et al.  Solid-state gas sensors for high temperature applications – a review , 2014 .

[5]  Zheng Lou,et al.  Cross-linked p-type Co3O4 octahedral nanoparticles in 1D n-type TiO2 nanofibers for high-performance sensing devices , 2014 .

[6]  Fenggong Wang,et al.  DFT Study of Hydrogen Adsorption On the Monoclinic WO3 (001) Surface , 2012 .

[7]  Benjamin J. Carey,et al.  Proton intercalated two-dimensional WO3 nano-flakes with enhanced charge-carrier mobility at room temperature. , 2014, Nanoscale.

[8]  A. Fu,et al.  Mechanism of CO adsorption on hexagonal WO3 (001) surface for gas sensing: A DFT study , 2013 .

[9]  C. Liu,et al.  Low-temperature hydrothermal synthesis of WO3 nanorods and their sensing properties for NO2 , 2012 .

[10]  Dzung Viet Dao,et al.  Ultrahigh-sensitive WO3 nanosensor with interdigitated Au nano-electrode for NO2 detection , 2008 .

[11]  N. Martin,et al.  Improvement of ozone detection with GLAD WO3 films , 2015 .

[12]  K. Shimanoe,et al.  Pd size effect on the gas sensing properties of Pd-loaded SnO2 in humid atmosphere. , 2015, ACS applied materials & interfaces.

[13]  Zhaoxiong Xie,et al.  MOF-templated synthesis of porous Co(3)O(4) concave nanocubes with high specific surface area and their gas sensing properties. , 2014, ACS applied materials & interfaces.

[14]  K. Kojima,et al.  Morphological and crystal structural control of tungsten trioxide for highly sensitive NO2 gas sensors , 2015 .

[15]  Jinmin Wang,et al.  Synthesis, Assembly, and Electrochromic Properties of Uniform Crystalline WO3 Nanorods , 2008 .

[16]  R. Hayn,et al.  Mechanism of NOx sensing on WO3 surface: First principle calculations , 2014 .

[17]  Yongyao Xia,et al.  Large-scale synthesis of single-crystal hexagonal tungsten trioxide nanowires and electrochemical lithium intercalation into the nanocrystals , 2007 .

[18]  Yun Chan Kang,et al.  Highly selective and sensitive detection of trimethylamine using WO3 hollow spheres prepared by ultrasonic spray pyrolysis , 2013 .

[19]  Shihe Yang,et al.  Vertically aligned, double-sided, and self-supported 3D WO3 nanocolumn bundles for low-temperature gas sensing , 2015 .

[20]  C. Li,et al.  The preparation of Cr2O3@WO3 hierarchical nanostructures and their application in the detection of volatile organic compounds (VOCs) , 2015 .

[21]  N. Xu,et al.  Study of Physical and Chemical Processes of H2 Sensing of Pt-Coated WO3 Nanowire Films , 2010 .

[22]  Xianghong Liu,et al.  Nanostructured Materials for Room‐Temperature Gas Sensors , 2016, Advanced materials.

[23]  B. Ohtani,et al.  Fabrication and photoelectrochemical property of tungsten(vi) oxide films with a flake-wall structure. , 2010, Chemical communications.

[24]  Nak-Jin Choi,et al.  A ppb-level formaldehyde gas sensor based on CuO nanocubes prepared using a polyol process , 2014 .

[25]  Michael Dudley,et al.  Fabrication and characterization of polycrystalline WO3 nanofibers and their application for ammonia sensing. , 2006, The journal of physical chemistry. B.

[26]  Zhengguo Jin,et al.  Exposed facets induced enhanced acetone selective sensing property of nanostructured tungsten oxide , 2014 .

[27]  Chade Lv,et al.  Controllable synthesis of In2O3 octodecahedra exposing {110} facets with enhanced gas sensing performance , 2015 .

[28]  J. H. Lee,et al.  Highly sensitive and selective gas sensors using p-type oxide semiconductors: Overview , 2014 .

[29]  Eduard Llobet,et al.  Au nanoparticle-functionalised WO3 nanoneedles and their application in high sensitivity gas sensor devices. , 2011, Chemical communications.

[30]  H. Arakawa,et al.  The visible light induced photocatalytic activity of tungsten trioxide powders , 2001 .

[31]  Zhifu Liu,et al.  Facile synthesis and NO2 gas sensing of tungsten oxide nanorods assembled microspheres , 2009 .

[32]  J. Madarász,et al.  Gas sensing selectivity of hexagonal and monoclinic WO3 to H2S , 2010 .

[33]  Yeon-Tae Yu,et al.  Facile Approach to Synthesize Au@ZnO Core-Shell Nanoparticles and Their Application for Highly Sensitive and Selective Gas Sensors. , 2015, ACS applied materials & interfaces.

[34]  Shuang Yan,et al.  A novel structure for enhancing the sensitivity of gas sensors – α-Fe2O3 nanoropes containing a large amount of grain boundaries and their excellent ethanol sensing performance , 2015 .