Design and Computation of Energy Factor Parameters for an Interleaved Boost Converter

Energy factor and the sub-sequential parameters best describe the characteristics of the DC-DC converter and they are mainly used in stability studies as well as controller design. In this paper, the computation of these parameters for a 3-phase interleaved boost converter (IBC) has been described in detail. Also, the design of IBC has been given importance. The values of the parameters computed have been tabulated. The simulation of the 3-phase IBC has been carried out using MATLAB/SIMULINK.

[1]  Rong-Jong Wai,et al.  High step-up converter with coupled-inductor , 2005 .

[2]  Milan M. Jovanovic,et al.  Analysis and evaluation of interleaving techniques in forward converters , 1998 .

[3]  Fang Lin Luo,et al.  Digital Power Electronics and Applications , 2005 .

[4]  T. C. Green,et al.  AC/DC power factor correction using interleaved boost and Cuk converters , 2000 .

[5]  Milan M. Jovanovic,et al.  New two-inductor boost converter with auxiliary transformer , 2002, APEC. Seventeenth Annual IEEE Applied Power Electronics Conference and Exposition (Cat. No.02CH37335).

[6]  Phatiphat Thounthong,et al.  Design and implementation of 2-phase interleaved boost converter for fuel cell power source , 2008 .

[7]  Tomonobu Senjyu,et al.  Modeling and analysis of interleaved dual boost converter , 2001, ISIE 2001. 2001 IEEE International Symposium on Industrial Electronics Proceedings (Cat. No.01TH8570).

[8]  Laszlo Balogh,et al.  Understanding Interleaved Boundary Conduction Mode PFC Converters , 2008 .

[9]  Xuhui Wen,et al.  Analysis and Design of High Power Interleaved Boost Converters for Fuel Cell Distributed Generation System , 2005, 2005 IEEE 36th Power Electronics Specialists Conference.

[10]  Peter J. Wolfs.  A current-sourced DC-DC converter derived via the duality principle from the half-bridge converter , 1993, IEEE Trans. Ind. Electron..

[11]  Tomonobu Senjyu,et al.  Maximum power point tracking of coupled inductor interleaved boost converter supplied PV system , 2003 .

[12]  Roger Gules,et al.  An interleaved boost DC-DC converter with large conversion ratio , 2003, 2003 IEEE International Symposium on Industrial Electronics ( Cat. No.03TH8692).

[13]  Krischonme Bhumkittipich,et al.  Design and Analysis of Interleaved Boost Converter For Renewable Energy Applications , 2011 .

[14]  Tsorng-Juu Liang,et al.  Novel high-efficiency step-up converter , 2004 .

[15]  David M. Otten,et al.  High efficiency power factor correction using interleaving techniques , 1992, [Proceedings] APEC '92 Seventh Annual Applied Power Electronics Conference and Exposition.

[16]  Byoung-Kuk Lee,et al.  Design consideration of interleaved converters for fuel cell applications , 2007, 2007 International Conference on Electrical Machines and Systems (ICEMS).