Cascaded Inverters for electric vehicles: Towards a better management of traction chain from the battery to the motor?

Currently small electric vehicles (EV) are generally implemented with low voltage batteries around 48V with high current in order to reach a power of several kW for the traction chain. The objective of future converters is to increase the AC amplitude to higher levels (up to 300V) in order to decrease the level of currents, while keeping the same transferred power. Voltage source inverters are generally used in order to drive electric motors. Multilevel voltage source inverters, namely cascaded H-bridge, are under investigation in this paper, in their application to electrical vehicles. This paper presents a numerical and experimental analysis of cascaded H-bridge inverters, and focuses on an optimal modulation strategy. The expected benefits of cascaded inverters for electric vehicle are a better management of battery cells, improved output voltage waveforms, spread thermal losses sources and a better operation in fault modes.

[1]  Brendan Peter McGrath,et al.  Multicarrier PWM strategies for multilevel inverters , 2002, IEEE Trans. Ind. Electron..

[2]  S. Pélissier,et al.  Frequency and Temporal Identification of a Li-ion Polymer Battery Model Using Fractional Impedance , 2008 .

[3]  Bin Wu,et al.  Multilevel Voltage-Source-Converter Topologies for Industrial Medium-Voltage Drives , 2007, IEEE Transactions on Industrial Electronics.

[4]  Leon M. Tolbert,et al.  Multilevel inverters for electric vehicle applications , 1998, Power Electronics in Transportation (Cat. No.98TH8349).

[5]  A. Capel.  Mathematical model for the representation of the electrical behaviour of a lithium cell , 2001, 2001 IEEE 32nd Annual Power Electronics Specialists Conference (IEEE Cat. No.01CH37230).

[6]  A. H. Bonnett,et al.  A comparison between insulation systems available for PWM inverter fed motors , 1996, Proceedings of 1996 IAS Petroleum and Chemical Industry Technical Conference.

[7]  S. Bell,et al.  Will your motor insulation survive a new adjustable frequency drive? , 1996, Proceedings of 1996 IAS Petroleum and Chemical Industry Technical Conference.

[8]  J. Erdman,et al.  Effect of PWM inverters on AC motor bearing currents and shaft voltages , 1996 .

[9]  G. Sciutto,et al.  A new multilevel PWM method: a theoretical analysis , 1990, 21st Annual IEEE Conference on Power Electronics Specialists.

[10]  Hirofumi Akagi,et al.  A New Neutral-Point-Clamped PWM Inverter , 1981, IEEE Transactions on Industry Applications.

[11]  Dong-Seok Hyun,et al.  The carrier-based PWM method for voltage balance of flying capacitor multilevel inverter , 2001, 2001 IEEE 32nd Annual Power Electronics Specialists Conference (IEEE Cat. No.01CH37230).

[12]  B. Davat,et al.  Energetical modelling of lithium-ion battery discharge and relaxation , 2008, 2008 IEEE Power Electronics Specialists Conference.

[13]  Pablo Lezana,et al.  Extended Operation of Cascade Multicell Converters Under Fault Condition , 2009, IEEE Transactions on Industrial Electronics.

[14]  Vassilios G. Agelidis,et al.  Application specific harmonic performance evaluation of multicarrier PWM techniques , 1998, PESC 98 Record. 29th Annual IEEE Power Electronics Specialists Conference (Cat. No.98CH36196).

[15]  Dong-Seok Hyun,et al.  A study on the multi-carrier PWM methods for voltage balancing of flying capacitor in the flying capacitor multi-level inverter , 2005, 31st Annual Conference of IEEE Industrial Electronics Society, 2005. IECON 2005..

[16]  J. Erdman,et al.  Effect of PWM inverters on AC motor bearing currents and shaft voltages , 1995, Proceedings of 1995 IEEE Applied Power Electronics Conference and Exposition - APEC'95.

[17]  M. Marchesoni,et al.  A non conventional power converter for plasma stabilization , 1988, PESC '88 Record., 19th Annual IEEE Power Electronics Specialists Conference.